Quality control of [177Lu]Lu-PSMA preparations using HPLC: effect of sample composition and ligand on recovery.

BACKGROUND: [177Lu]Lu-PSMA is used for the treatment of metastatic castration-resistant prostate cancer. For in-house productions, quality control methods are essential for ensuring product quality, and thus patient safety. During HPLC method development for quality control of [177Lu]Lu-PSMA-I&T, we noticed an unpredictable variability in peak area and height with replicate measurements. After a run, irremovable radioactivity was measured over the whole the length of the HPLC column, with slightly higher activity at the beginning and end of the column. The uniform distribution suggests that [177Lu]Lu-PSMA-I&T interacts with the column. As a result of the interaction, incomplete and variable recovery of injected activity was observed leading to the variability in peak area and height. Therefore the aim of this study was to (1) investigate the effect of sample composition on the interaction of [177Lu]Lu-PSMA-I&T to the HPLC column (measured as recovery, peak area, and peak height), and (2) to compare this with same concentrations of the well-known [177Lu]Lu-PSMA-617. RESULTS: Sample composition significantly affects recovery of [177Lu]Lu-PSMA-I&T, leading to a change in peak area and height. Recovery was 24% when diluted with 0.1 mM octreotide, 38% with water, and increased to 95% when diluted with 0.7 mM unlabeled PSMA-I&T. Peak area and height decreased to 26% and 17% when diluted in octreotide and to 41% and 29% when diluted in water, compared to a dilution in PSMA-I&T. Further experiments showed that recovery (and consequently peak area and peak height) reached a plateau of > 99% at concentrations of 0.27 mM and higher. [177Lu]Lu-PSMA-617 also interacts with the HPLC column, leading to lower, but less variable, recovery (9%). The low recovery of [177Lu]Lu-PSMA-617 could not be prevented with addition of unlabeled PSMA-617. CONCLUSION: [177Lu]Lu-PSMA-I&T can undergo an irreversible binding with an HPLC column resulting in a decreased recovery. The recovery is can be highly dependent on sample composition. The addition of a surplus of unlabeled PSMA-I&T leads to an accurate analysis of [177Lu]Lu-PSMA-I&T.

Haematotoxicity during peptide receptor radionuclide therapy: Baseline parameters differences and effect on patient's therapy course.

BACKGROUND: Mainly severe (CTCAE grade 3-4) haematotoxicity during peptide receptor radionuclide therapy (PRRT) is reported in literature due to major clinical impact, however moderate (CTCAE grade 2) haematotoxicity is common and could affect therapy management. The aim of this study was to evaluate the haematotoxicity course during PRRT and to compare baseline parameters between haematotoxicity grades. METHODS: In this retrospective study, 100 patients with a neuroendocrine tumour treated with PRRT were included. Patients were treated with an aimed number of four cycles with 7.4 GBq [177Lu]Lu-DOTA-TATE administered every 10 weeks. Haematological assessment was performed at baseline and frequently up to 10 weeks after the fourth cycle. The lowest haematological value was graded according to CTCAE v5.0, and patients were classified using the highest observed grade. Differences in baseline parameters, including [68Ga]Ga-DOTA-TATE positive tumour volume, were evaluated between CTCAE grades. RESULTS: Four cycles were completed by 86/100 of patients, 4/100 patients discontinued due to haematotoxicity, and 10/100 patients due to progressive disease. The treatment course was adjusted due to haematotoxicity in 24/100 patients, including postponed next cycle (n = 17), reduced administered activity (n = 13), and both adjustments (n = 10). The most observed haematotoxicity grade was grade 0-1 in 54/100 patients, grade 2 in 38/100 and grade 3-4 in 8/100. Significant differences in baseline leucocyte, neutrophil and platelet counts were observed between grade 0-1 and grade 2. However, the correlation between baseline and lowest observed values was poor to moderate. No differences between haematotoxicity grades and baseline parameters or somatostatin receptor positive tumour volume was observed. CONCLUSIONS: The incidence of severe haematotoxicity was low with extensive screening and monitoring. The vast majority of patients (96/100) was not restricted in treatment continuation by haematotoxicity; therefore, our selection criteria appeared appropriate for safe PRRT treatment. Baseline parameters showed limited correlation with the degree of decline in haematological values.

Automated synthesis and quality control of [99mTc]Tc-PSMA for radioguided surgery (in a [68Ga]Ga-PSMA workflow).

BACKGROUND: Lymph node dissection is a therapeutic option for prostate cancer patients with a high risk of- or proven lymph node metastases. Radioguided surgery after intravenous injection of [99mTc]Tc-PSMA could improve the selectivity of lymph node dissection. The aim of this project was to develop an automated synthesis method for [99mTc]Tc-PSMA, using the disposables and chemicals used at our institute for [68Ga]Ga-PSMA labeling. Furthermore, quality control procedures and validation results of the automated production of [99mTc]Tc-PSMA conform cGMP and cGRPP are presented. METHODS: [99mTc]Tc-PSMA is produced fully automatic with a Scintomics synthesis module. Quality control procedures are described and performed for: activity, labeling yield, visual inspection, pH measurement, sterility and endotoxin determination, radionuclide purity, radiochemical purity (99mTc-colloids, unbound [99mTc]pertechnetate, and other impurities), and HEPES content. Three batches of [99mTc]Tc-PSMA were prepared on three separate days for validation and stability testing at 0, 4, 6, and 24 h. RESULTS: [99mTc]Tc-PSMA can be successfully manufactured automatically within a [68Ga]Ga-PSMA workflow with the addition of only [99mTc]pertechnetate and stannous chloride. The radiochemical purity after production was highly reproducible (96.3%, 97.6%, and 98.2%) and remained > 90% (required for patient administration) up to 6 h later. CONCLUSION: A fully automated labeling procedure with corresponding quality control methods for production of [99mTc]Tc-PSMA is presented, which is validated according to cGMP and cGRPP guidelines and can be implemented in a GMP environment. The produced [99mTc]Tc-PSMA is stable for up to 6 h. The presented procedure is almost identical to the automated production of [68Ga]Ga-PSMA and can therefore be implemented expediently if a workflow for [68Ga]Ga-PSMA is already in place.

A Practical Guide for the Production and PET/CT Imaging of 68Ga-DOTATATE for Neuroendocrine Tumors in Daily Clinical Practice.

Neuroendocrine tumors are a rare form of cancer that arise from neuroendocrine cells and can be present at almost any location throughout the body. Although heterogeneous in presentation, a common denominator among these tumors is the overexpression of somatostatin receptors. 68Ga-DOTATATE is a somatostatin analog labeled with the positron emitter gallium-68 (68Ga). For well-differentiated neuroendocrine tumors, 68Ga-DOTATATE positron emission tomography (PET)/computed tomography (CT) imaging is used for diagnosis, determination of disease burden, and therapy selection. This protocol details the radiolabeling of 68Ga-DOTATATE, quality control, patient preparation, and subsequent PET/CT imaging. Radiolabeling of 68Ga-DOTATATE is performed with a fully automated labeling module coupled to a germanium-68 (68Ge)/68Ga generator. Quality control of the final product evaluates radiochemical purity with instant thin-layer chromatography and solid-phase chromatography, and pH prior to patient injection. Periodic quality control is performed to determine 68Ge breakthrough, sterility, and (4-(2-hydroxyethyl)-1-piperazineethanesulfonic acid (HEPES) content. Patient preparation includes patient instructions, a protocol for 68Ga-DOTATATE during treatment with somatostatin analogs, and intravenous administration of the radiopharmaceutical. For PET/CT imaging, the acquisition and reconstruction settings are described. For each step, radiation safety will be highlighted, as well as time constrictions due to the short half-life of 68Ga. Fully automated in-house production and quality control of 68Ga-DOTATATE leads to very high success rates (95%) and produces two to four patient dosages per batch, depending on the yield of the generator. In conclusion, 68Ga-DOTATATE PET/CT imaging is a noninvasive and fast method of providing information on the tumor burden of neuroendocrine tumors (NETs) while also assisting in diagnosis and therapy selection.