Quantitative titanium imaging in fish tissues exposed to titanium dioxide nanoparticles by laser ablation-inductively coupled plasma-mass spectrometry.

Imaging studies by laser ablation-inductively coupled plasma mass spectrometry have been successfully developed to obtain qualitative and quantitative information on the presence/distribution of titanium (ionic titanium and/or titanium dioxide nanoparticles) in sea bream tissues (kidney, liver, and muscle) after exposure assays with 45-nm citrate-coated titanium dioxide nanoparticles. Laboratory-produced gelatine standards containing ionic titanium were used as a calibration strategy for obtaining laser ablation-based images using quantitative (titanium concentrations) data. The best calibration strategy consisted of using gelatine-based titanium standards (from 0.1 to 2.0 µg g-1) by placing 5.0-µL drops of the liquid gelatine standards onto microscope glass sample holders. After air drying at room temperature good homogeneity of the placed drops was obtained, which led to good repeatability of measurements (calibration slope of 4.21 × 104 ± 0.39 × 104, n = 3) and good linearity (coefficient of determination higher than 0.990). Under the optimised conditions, a limit of detection of 0.087 µg g-1 titanium was assessed. This strategy allowed to locate prominent areas of titanium in the tissues as well as to quantify the bioaccumulated titanium and a better understanding of titanium dioxide nanoparticle spatial distribution in sea bream tissues.

Inter-comparison of carbon content in PM10 and PM2.5 measured with two thermo-optical protocols on samples collected in a Mediterranean site.

Scientific interest is focusing on different approaches for characterising organic carbon (OC), elemental carbon (EC) and equivalent black carbon (eBC), although EUSAAR2 protocol has been established and frequently used in EU for regulatory purposes. Discrepancies are observed due to thermal protocols used for OC/EC determinations and the effect of the chemical-physical properties of aerosol using optical measurements for eBC. In this work, a long-term inter-comparison of carbon measurements with two widely used protocols (EUSAAR2 and NIOSH870) was performed on PM2.5 and PM10 samples. The influence of the protocol on the evaluation of secondary organic aerosol (SOC) and on the correlation between EC and eBC was investigated. An extensive check of repeatability gave typical uncertainties of ~ 5% for TC and OC, and ~ 10% for EC for both thermal protocols. Results show that OC is statistically comparable between the two protocols but EC is significantly higher with EUSAAR2, especially during the warm season. The ratio OC/EC is lower with EUSAAR2, also showing a seasonality (lower values in the warm season) not observed with NIOSH870. Despite the differences in OC/EC ratios, the contribution of SOC to OC (~ 50%), evaluated using the EC-tracer method, did not differ significantly between the two protocols and for both size fractions. Further, SOC/OC ratios were comparable in cold and warm periods. eBC/EC ratios larger than one for both protocols were obtained, 1.62 (EUSAAR2) and 1.92 (NIOSH870), and also correlated with the ratio OC/EC for both protocols, especially in the cold season.

Silver-loaded chitosan coating as an integrated approach to face titanium implant-associated infections: analytical characterization and biological activity.

The present work focuses on the idea to prevent and/or inhibit the colonization of implant surfaces by microbial pathogens responsible for post-operative infections, adjusting antimicrobial properties of the implant surface prior to its insertion. An antibacterial coating based on chitosan and silver was developed by electrodeposition techniques on poly(acrylic acid)-coated titanium substrates. When a silver salt was added during the chitosan deposition step, a stable and scalable silver incorporation was achieved. The physico-chemical composition of the coating was studied by X-ray photoelectron spectroscopy (XPS), while atomic force microscopy in intermittent contact mode (ICAFM) was used to explore the coating morphology. The amount of silver released from the coating up to 21 days was evaluated by inductively coupled plasma mass spectrometry (ICP-MS). The capability of the proposed coating to interact in vitro with the biological environment in terms of compatibility and antibacterial properties was assessed using MG-63 osteoblast-like cell line and S. aureus and P. aeruginosa strains, respectively. These studies revealed that a coating showing a silver surface atomic percentage equal to 0.3% can be effectively used as antibacterial system, while providing good viability of osteoblast-like cells after 7 days. The antibacterial effectiveness of the prepared coating is mainly driven by a contact killing mechanism, although the low concentration of silver released (below 0.1 ppm up to 21 days) is enough to inhibit bacterial growth, advantaging MG-63 cells in the race for the surface.