Unveiling the origins and transport processes of radioactive pollutants downstream from a former U-mine site using isotopic tracers and U-238 series disequilibrium.

High U concentrations (reaching up to 14,850 mg â‹… kg-1), were determined in soils and sediments of a wetland downstream of a former U mine in France. This study aims to identify the origin of radioactive contaminants in the wetland by employing Pb isotope fingerprinting, (234U/238U) disequilibrium, SEM, and SIMS observations. Additionally, information about U and 226Ra transport processes was studied using U-238 series disequilibrium. The results of Pb fingerprinting highlighted inherited material inputs of different U-mines with mainly two types of U-ores: i) pitchblende (UO2), and ii) parsonsite (Pb2(UO2)(PO4)2). Moreover, significant disequilibrium of (230Th/238U) and (226Ra/230Th) activity ratios highlighted the mobility of 238U and 226Ra in the wetland, primarily driven by the water table fluctuations. Finally, this work uncovered a limitation of Pb isotope fingerprinting in the case of parsonsite materials, as the high natural Pb content of this mineral may hide the uranogenic Pb signature in the samples.

Elevated uranium concentration and low activity ratio (234U/238U) in the Œuf river as the result of groundwater-surface water interaction (Essonne river valley, South of Paris Basin, France).

Uranium (U) is a naturally occurring radioactive heavy metal widely distributed on Earth. Noticeable elevated U concentration and low activity ratio (AR) were occasionally detected in headwater stream of the Essonne river (Seine Basin, France), the namely Œuf river. This paper aims at providing new insight on geogenic U features in headwater streams and examines the role of river-groundwater interaction. The Œuf river was sampled four times in 2020 to investigate the influence of heterogeneous geology and hydrological seasonality. The dissolved fraction of water samples was analyzed for a variety of chemical parameters (anion, major, minor and trace element concentrations, isotopes 234U and 238U). The Œuf river was shown to exhibit elevated U concentration up to 19.3 µg L-1 (exceeding by 100-fold the value of 0.19 µg L-1 known for riverine average) and low AR down to 0.41 (almost the third of the value expected in surface water, i.e., 1.17). The Œuf river got enriched in U when receiving groundwater from Beauce Limestone Aquifer System. High U concentration (above 15 µg L-1) was found in association with low AR (below 0.5) in the stream water when flowing in the outcrop zone of one BLAS unit. Taking advantage of changes in the stream flow conditions and the geochemical contrast between surface and ground waters, mixing volumes were calculated. This study first examined the potential of using U isotopes in combination with selenium as hydrogeochemical tracers of the river-groundwater continuum. In HWS, the aquifer discharge was shown to supply 12 to 59 % of the river water. This study demonstrates the key role played by the river-groundwater interaction on river water chemistry in small streams draining catchment with various geology setting. It also supports the use of combining redox sensitive trace elements to track the river-groundwater continuum.

Dissolved iodide in marine waters determined with Diffusive Gradients in Thin-films technique.

For the first time, Diffusive Gradient in Thin-films (DGT) focuses on the inorganic iodine species iodate (IO3-) and iodide (I-). A silver-doped Cl resin (AgdCl), which is known to selectively accumulate I-, was used to make a binding gel. Laboratory investigations were designed to verify the suitability of the AgdCl-DGT method to measure the total I- concentration in environmental waters. Total recovery of I- was obtained using an elution solution containing 100 mmol L-1 KCN. DGT validation experiments in 10 mmol L-1 NaCl showed linear accumulation of I- over time, contrary to IO3-, thus confirming the selectivity of AgdCl-binding gel. The AgdCl-DGT measurement of total I- concentration was independent of pH (4.5-8.8) and was not impacted by the presence of bicarbonate (1-5 mmol L-1). Finally, the performance of AgdCl-DGT samplers were tested in two continental waters and a synthetic seawater. The AgdCl-DGT samplers measured 27-33% of the total I- concentration in the two continental waters up to 24 h of deployment time, whereas the AgdCl-DGT response retrieved the total I- concentration in seawater up to 72 h (106 ± 7%). The difference in DGT response was attributed to the low ionic strength of the two continental waters, limiting the application of AgdCl-DGT method to media with higher ionic strength.

Passive sampler measurements of inorganic arsenic species in environmental waters: A comparison between 3-mercapto-silica, ferrihydrite, Metsorb®, zinc ferrite, and zirconium dioxide binding gels.

The performances of five Diffusive Gradients in Thin Films (DGT) binding gels, namely 3-mercapto-functionalized silica (3MP), ferrihydrite (Fh), Metsorb®, zinc ferrite (ZnFe2O4), and Zirconium oxide (ZrO2), were evaluated for in situ determination of As speciation in water and sediments. A combination of batch experiments at various pH (without addition of buffers) and in the presence of reduced species (Mn2+, Fe2+ and HS-),time-series experiments in oxic waters, and in situ deployment in anoxic river sediments has permitted to evaluate the potential interferences among the binding gels. Firstly, the efficiency of each DGT binding gel dedicated to total As (i.e., Fh, Metsorb®, ZnFe2O4 and ZrO2) or As(III) (i.e., 3MP) determination confirms that the determination of As species is possible in oxic freshwater and seawater over 96 h for a wide range of pH (5-9). Secondly, concerning the deployment in river sediment, high HCO3- concentrations have a little negative effect only on the DGT performances of the iron(III)-binding gels (i.e, Fh and ZnFe2O4). Thirdly, the presence of sulfides does not show any effect on the DGT uptake of As, but strongly affects the elution factor parameter. Discrepancies in elution between the different binding gels potentially result in precipitation of orpiment, especially in 1 mol L-1 HNO3. A correction of the classical elution factor derived from batch experiments was applied to provide more representative results. Finally, this study shows the difficulties to determine As speciation in anoxic sediments, and suggests that corrections of the elution factor may be required as a function of the species present in the deployment matrices.

Better understanding and applications of ammonium 12-molybdophosphate-based diffusive gradient in thin film techniques for measuring Cs in waters.

This study deals with further and systematic laboratory evaluation of the already known ammonium 12-molybdophosphate (AMP)-diffusive gradient in thin film (DGT) method, which is used for measuring total Cs concentration in environmental waters. This study confirms that the AMP-binding gel is not stable for pH > 6. In order to reveal a potential impact of AMP degradation on DGT application, time-series experiments were performed by deploying AMP-DGT samplers in Cs-doped moderately basic soft and hard water up to total AMP-binding gel degradation (60 and 175 h of deployment time, respectively). Linear accumulation of Cs by AMP-DGT samplers was observed up to 48 and 58 h in hard and soft waters, respectively. For this deployment time range, AMP-DGT measured over 77 ± 10 and 94 ± 16% of total Cs concentration in hard and soft water, respectively. The difference in DGT response was attributed to Ca2+ and Mg2+ competition reducing the uptake of AMP-DGT samplers in hard water. Shrinkage of agarose-polyacrylamide diffusive gel was experimentally observed only in hard water due to more intensive AMP-binding gel degradation in hard water. Even if the AMP-DGT response was not impacted in this study, it is recommended to use agarose hydrogel as standard diffusive gel. Based on the experience obtained from this detailed validation process, the authors propose a number of key requirements that need to be considered when developing DGT devices, with testing the performance over longer deployment times being critical. Graphical abstract ᅟ.

Determination of total arsenic using a novel Zn-ferrite binding gel for DGT techniques: Application to the redox speciation of arsenic in river sediments.

A new laboratory-made Zn-ferrite (ZnFe2O4) binding gel is fully tested using Diffusive Gradient in Thin films (DGT) probes to measure total As [including inorganic As(III) and As(V), as well as MonoMethyl Arsenic Acid (MMAA(V)) and DiMethyl Arsenic Acid (DMAA(V))] in river waters and sediment pore waters. The synthesis of the binding gel is easy, cheap and its insertion into the acrylamide gel is not problematic. An important series of triplicate tests have been carried out to validate the use of the Zn-ferrite binding gel in routine for several environmental matrixes studies, in order to test: (i) the effect of pH on the accumulation efficiency of inorganic As species; (ii) the reproducibility of the results; (iii) the accumulation efficiency of As species; (iv) the effects of the ionic strength and possible competitive anions; and (v) the uptake and the elution efficiency of As species after accumulation in the binding gel. All experimental conditions have been reproduced using two other existing binding gels for comparison: ferrihydrite and Metsorb® HMRP 50. We clearly demonstrate that the Zn-ferrite binding gel is at least as good as the two other binding gels, especially for pH values higher than 8. In addition, by taking into consideration the diffusion rates of As(III) and As(V) in the gel, combining the 3-mercaptopropyl [accumulating only As(III)] with the Zn-ferrite binding gels allows for performing speciation studies. An environmental study along the Marque River finally illustrates the ability of the new binding gel to be used for field studies.

Arsenic behavior in river sediments under redox gradient: a review.

The fate of arsenic - a redox sensitive metalloid - in surface sediments is closely linked to early diagenetic processes. The review presents the main redox mechanisms and final products of As that have been evidenced over the last years. Oxidation of organic matter and concomitant reduction of oxidants by bacterial activity result in redox transformations of As species. The evolution of the sediment reactivity will also induce secondary abiotic reactions like complexation/de-complexation, sorption, precipitation/dissolution and biotic reactions that could, for instance, lead to the detoxification of some As species. Overall, abiotic redox reactions that govern the speciation of As mostly involve manganese (hydr)-oxides and reduced sulfur species produced by the sulfate-reducing bacteria. Bacterial activity is also responsible for the inter-conversion between As(V) and As(III), as well as for the production of methylated arsenic species. In surficial sediments, sorption processes also control the fate of inorganic As(V), through the formation of inner sphere complexes with iron (hydr)-oxides, that are biologically reduced in buried sediment. Arsenic species can also be bound to organic matter, either directly to functional groups or indirectly through metal complexes. Finally, even if the role of reduced sulfur species in the cycling of arsenic in sediments has been evidenced, some of the transformations remain hypothetical and deserve further investigation.