Inhalation powder development without carrier: How to engineer ultra-flying microparticles?

Particle engineering technologies have led to the commercialization of new inhaled powders like PulmoSolTM or PulmoSphereTM. Such platforms are produced by spray drying, a well-known process popular for its versatility, thanks to wide-ranging working parameters. Whereas these powders contain a high drug-loading, we have studied a low-dose case, in optimizing the production of powders with two anti-asthmatic drugs, budesonide and formoterol. Using a Design of Experiments approach, 27 powders were produced, with varying excipient mixes (cyclodextrins, raffinose and maltodextrins), solution concentrations, and spray drying parameters in order to maximize deep lung deposition, measured through fine particle fraction (next generation impactor). Based on statistical analysis, two powders made of hydropropyl-ß-cyclodextrin alone or mixed with raffinose and L-leucine were selected. Indeed, the two powders demonstrated very high fine particle fraction (>55%), considerably better than commercially available products. Deep lung deposition has been correlated to very fine particle size and lower microparticles interactions shown by laser diffraction assays at different working pressures, and particle morphometry. Moreover, the two drugs would be predicted to deposit homogeneously into the lung according to impaction studies. Uniform delivery is fundamental to control symptoms of asthma. In this study, we develop carrier-free inhalation powders promoting very efficient lung deposition and demonstrate the high impact of inter-particular interactions intensity on their aerosolization behaviour.

Fused deposition modeling 3D printing of solid oral dosage forms containing amorphous solid dispersions: How to elucidate drug dissolution mechanisms through surface spectral analysis techniques?

Many active principles belong to the second class of the Biopharmaceutics Classification System due to their low aqueous solubility. Elaboration of new solid oral forms by hot-melt extrusion and fused deposition modeling appears as a promising tool to increase the dissolution rate of these drugs. Indeed, hot-melt extrusion allows the amorphisation of drugs and forms with complex geometries are built by 3D printing. Therefore, the goal of this work is to enhance the dissolution rate of poorly soluble drugs using hot-melt extrusion coupled with fused deposition modeling. Four formulations containing Affinisol® 15LV, Kollidon® VA64 and a challenging amount of itraconazole (25 % (wt.)) were successfully printed into forms of 20, 50 and 80 % infill densities. Differential scanning calorimetry analysis has shown that itraconazole remained amorphous during 52 weeks. The drug release rate was highly improved compared to itraconazole in a crystalline form. The dissolution rate was influenced by the infill density and the polymer composition of printed forms which could modify respectively the surface to volume ratio and the distribution of the components in the printed forms. One formulation printed with 20 % infill density even had a solubility profile similar to that of Sporanox®, the commercialized drug product in Belgium.