Multilayer immobilizing of denitrifying Bacillus sp. and TiO2-AgNPs on floating expanded clay carrier for co-treatment of nitrite and pathogens in aquaculture.

Nitrite contamination and the spread of pathogens can seriously degrade water quality. To simultaneously control these factors, an innovative approach of fabricating a remediation agent that contained denitrifying bacteria and TiO2-AgNPs co-immobilized on floating expanded clay (EC) was proposed in this study. The EC was fabricated from a mixture of clay and rice husk through pyrolysis at a high temperature of 1200 °C, followed by a rapid cooling step to create a porous structure for the material. TiO2NPs were modified with Ag to shift the absorbance threshold of TiO2-AgNPs into the visible region of 700-800 nm. The experimental results showed that the stirring speed of 250 rpm was suitable for immobilizing TiO2-AgNPs on EC and achieved the highest Ti and Ag content of 639.38 ± 3.04 and 200.51 ± 3.71 ppm, respectively. Coating TiO2-Ag/EC with chitosan (0.5%) significantly reduced the detachment level of immobilized TiO2-AgNPs compared to that of the material with no coating. In particular, this functionalized material inhibited 99.93 ± 0.1% of Vibrio parahaemolyticus pathogen but did not adversely affect the denitrifying bacteria after 2 h of visible light irradiation. Based on the electrostatic bond between oppositely charged polymers, the denitrifying bacteria, Bacillus sp., in alginate solution was successfully immobilized on the chitosan-coated TiO2-Ag/EC with a bacteria density of (76.67 ± 9.43) × 107 CFU g-1, retaining its nitrite removal efficiency at 99.0 ± 0.27% through six treatment cycles. These findings provide solid evidence for further investigating the combination of biodegradation and photodegradation in wastewater treatment.

Injectable thermogel incorporating reactive oxygen species scavenger and nitric oxide donor to accelerate the healing process of diabetic wounds.

The healing of diabetic wounds is challenging due to redox imbalances. Herein, the thermogelling system AR-ACP hydrogel, with encapsulated biosafe nitric oxide (NO) donor L-arginine and resveratrol as an ROS scavenger, is established for sustainable wound therapy in the diabetic state. The innovated AR-ACP hydrogel dressings shows the sol-gel transition at 34 °C, allowing the hydrogel to fully cover wounds. The combination of L-arginine and resveratrol showed a prominent effect on anti-oxidative activity. The elimination of superoxide anions from the activated immune cells/oxidative cells by resveratrol maintained the NO-proangiogenic factors generated from L-arginine. Furthermore, the AR-ACP hydrogel endowed outstanding features such as haemocompatibility, non-skin irradiation as well as antibacterial activity. In the in vivo diabetic mice model, complete epidermal regeneration comparable to undamaged skin was observed with AR-ACP hydrogel. The synergy between L-arginine and resveratrol in the ACP hydrogel facilitated neovascularisation in the early stage, resulting in the higher balance in cellularity growth and collagen deposition in the dermal layer compared to control groups. Taken together, our findings demonstrate that the use of a customised ACP-based hydrogel, with the additional L-arginine and resveratrol, resulted in significant skin regeneration in the diabetic state.

High Biocompatibility, MRI Enhancement, and Dual Chemo- and Thermal-Therapy of Curcumin-Encapsulated Alginate/Fe3O4 Nanoparticles.

(1) Background: Magnetite (Fe3O4) nanoparticles have great potential for biomedical applications, including hyperthermia and magnetic resonance imaging. In this study, we aimed to identify the biological activity of nanoconjugates composed of superparamagnetic Fe3O4 nanoparticles coated with alginate and curcumin (Fe3O4/Cur@ALG) in cancer cells. (2) Methods: The nanoparticles were evaluated for the biocompatibility and toxicity on mice. The MRI enhancement and hyperthermia capacities of Fe3O4/Cur@ALG were determined in both in vitro and in vivo sarcoma models. (3) Results: The results show that the magnetite nanoparticles exhibit high biocompatibility and low toxicity in mice at Fe3O4 concentrations up to 120 mg/kg when administered via intravenous injection. The Fe3O4/Cur@ALG nanoparticles enhance the magnetic resonance imaging contrast in cell cultures and tumor-bearing Swiss mice. The autofluorescence of curcumin also allowed us to observe the penetration of the nanoparticles into sarcoma 180 cells. In particular, the nanoconjugates synergistically inhibit the growth of sarcoma 180 tumors via magnetic heating and the anticancer effects of curcumin, both in vitro and in vivo. (4) Conclusions: Our study reveals that Fe3O4/Cur@ALG has a high potential for medicinal applications and should be further developed for cancer diagnosis and treatment.

Allium sativum@AgNPs and Phyllanthus urinaria@AgNPs: a comparative analysis for antibacterial application.

Although medicinal herbs contain many biologically active ingredients that can act as antibiotic agents, most of them are difficult to dissolve in lipids and absorb through biofilms in the gastrointestinal tract. Besides, silver nanoparticles (AgNPs) have been widely used as a potential antibacterial agent, however, to achieve a bactericidal effect, high concentrations are required. In this work, AgNPs were combined into plant-based antibiotic nanoemulsions using biocompatible alginate/carboxyl methylcellulose scaffolds. The silver nanoparticles were prepared by a green method with an aqueous extract of Allium sativum or Phyllanthus urinaria extract. The botanical antibiotic components in the alcoholic extract of these plants were encapsulated with emulsifier poloxamer 407 to reduce the particle size, and make the active ingredients both water-soluble and lipid-soluble. Field emission scanning electron microscopy (FESEM) and energy-dispersive X-ray (EDX) analysis showed that the prepared nanosystems were spherical with a size of about 20 nm. Fourier transform infrared spectroscopy (FTIR) confirmed the interaction of the extracts and the alginate/carboxyl methylcellulose carrier. In vitro drug release kinetics of allicin and phyllanthin from the nanosystems exhibited a retarded release under different biological pH conditions. The antimicrobial activity of the synthesized nanoformulations were tested against Escherichia coli. The results showed that the nanosystem based on Allium sativum possesses a significantly higher antimicrobial activity against the tested organisms. Therefore, the combination of AgNPs with active compounds from Allium sativum extract is a good candidate for in vivo infection treatment application.

Characterization of Isolated Aerobic Denitrifying Bacteria and Their Potential Use in the Treatment of Nitrogen-Polluted Aquaculture Water.

Ammonia and nitrite treatments are the critical steps that must be done to ensure the healthy growth of aquatic animals. The nitrification process is often used for nitrogen removal purposes due to its efficiency and environmentally friendly properties. However, the varied growth rate between ammonia and nitrite-oxidizing bacteria can cause nitrite accumulation, leading to the massive mortality of aquatic animals at high concentrations. Therefore, this study aimed to integrate the fast-growing heterotrophic nitrite-reducing bacteria with nitrifying bacteria to achieve a quicker nitrite removal activity. The two denitrifying Bacillus sp. ST20 and Bacillus sp. ST26 were screened from shrimp ponds in Bac Lieu province, Vietnam. Obtained results showed that under anoxic conditions, the nitrite removal efficiency of these two strains reached 68.5-82% at nitrite initial concentration of 20 mgN-NO2/L after 72 h. Higher efficiency of over 95% was gained under oxic conditions. Hence, it enabled the use of denitrifying and nitrifying bacteria-co-immobilized carriers for ammonia oxidation and nitrite reduction simultaneously in a single-aerated bioreactor. A total of over 96% nitrogen content was removed during the bioreactor operation, despite the increase of inputting nitrogen concentration from 40 to 200 mgN/L. Moreover, the suitable conditions for bacterial growth and nitrite conversion activity of the ST20 and ST26 were detected as 15‰ salinity and 35 °C. The isolates also utilized various C-sources for growth, hence widening their applicability. The present study suggested that the isolated aerobic denitrifying bacteria are potentially used for the complete removal of nitrogen compounds from aquaculture wastewater.

Modification of expanded clay carrier for enhancing the immobilization and nitrogen removal capacity of nitrifying and denitrifying bacteria in the aquaculture system.

In aquaculture systems, the treatment of nitrogen pollution has always been a center of attention due to its impact on productiveness. The bioremediation method based on simultaneous nitrification and denitrification was often used to effectively remove ammonium, nitrite, and nitrate compounds. In addition, the attachment and biofilm formation of the nitrogen-converting bacteria on carriers had superior removal efficiency over the suspended bacteria. Thus, this study focused on the fabrication of a porosity floatable expanded clay (EC) carrier that provided the basic structure for the immobilization of the nitrifiers Nitrosomonas sp., Nitrobacter sp., and the denitrifier Bacillus sp. The EC was also coated with alginate and essential nutrient to support the cohesion and growth of bacteria. Especially, the selected Bacillus sp. previously proved was able to reduce nitrite/nitrate in aerobic conditions. The co-immobilization of these three aerobic bacteria on the prepared carrier would simply the treatment process in practical use. Initial results showed that the integration of essential nutrients (N, P, K) on alginate coated EC (EC_Alg_N) increased bacterial density to (57 ± 3) × 107 - (430 ± 30) × 108 CFU/g, which then led to the enhancement of removal efficiency up to 91.62 ± 0.67% in the medium containing initial nitrogen content of 60 mg-N/L. The nitrogen removal efficacy of bacterial immobilized EC_Alg_N remained at 83.95 ± 0.15% after being reused for 6 cycles. In conclusion, the bacterial immobilized EC_Alg_N could be a potential material for nitrogen polluted wastewater treatment in aquaculture systems.

Dual Loading of Doxorubicin and Magnetic Iron Oxide into PLA-TPGS Nanoparticles: Design, in vitro Drug Release Kinetics, and Biological Effects on Cancer Cells.

The multifunctional nano drug delivery system (MNDDS) has much revolutionized in cancer treatment, aiming to eliminate many disadvantages of conventional formulations. This paper herein proposes and demonstrates MNDDS inspired by poly(lactide)-tocopheryl polyethylene glycol succinate (PLA-TPGS) copolymer co-loaded Doxorubicin and magnetic iron oxide nanoparticles (MIONs) with a 1 : 1 (w/w) optimal ratio. In vitro drug release kinetics of Doxorubicin from this nanosystem fitted best to the Weibull kinetic model and can be described by the classical Fickian diffusion mechanism under acidic pH conditions. The combination of MIONs and Doxorubicin in the PLA-TPGS copolymer has maintained the fluorescence properties of Doxorubicin and good cell penetration, especially inside the nucleus and its vicinity. Moreover, different cell cycle profiles were observed in HeLa cell lines treated with MNDDSs.

Characterizations and Antibacterial Efficacy of Chitosan Oligomers Synthesized by Microwave-Assisted Hydrogen Peroxide Oxidative Depolymerization Method for Infectious Wound Applications.

The use of naturally occurring materials with antibacterial properties has gained a great interest in infected wound management. Despite being an abundant resource in Vietnam, chitosan and its derivatives have not yet been intensively explored for their potential in such application. Here, we utilized a local chitosan source to synthesize chitosan oligomers (OCS) using hydrogen peroxide (H2O2) oxidation under the microwave irradiation method. The effects of H2O2 concentration on the physicochemical properties of OCS were investigated through molecular weight, degree of deacetylation, and heavy metal contamination for optimization of OCS formulation. Then, the antibacterial inhibition was examined; the minimum inhibitory concentration and minimum bactericidal concentration (MIC and MBC) of OCS-based materials were determined against common skin-inhabitant pathogens. The results show that the local Vietnamese chitosan and its derivative OCS possessed high-yield purification while the molecular weight of OCS was inversely proportional and proportional to the concentration of H2O2, respectively. Further, the MIC and MBC of OCS ranged from 3.75 to less than 15 mg/mL and 7.5-15 mg/mL, respectively. Thus, OCS-based materials induce excellent antimicrobial properties and can be attractive for wound dressings and require further investigation.

Characteristics and cytotoxicity of folate-modified curcumin-loaded PLA-PEG micellar nano systems with various PLA:PEG ratios.

Targeting delivery system use natural drugs for tumor cells is an appealing platform help to reduce the side effects and enhance the therapeutic effects of the drug. In this study, we synthesized curcumin (Cur) loaded (D, L Poly lactic - Poly ethylenglycol) micelle (Cur/PLA-PEG) with the ratio of PLA/PEG of 3:1 2:1 1:1 1:2 and 1:3 (w/w) and another micelle modified by folate (Cur/PLA-PEG-Fol) for targeting cancer therapy. The PLA-PEG copolymer was synthesized by ring opening polymerization method. After loading onto the micelle, solubility of Cur increased from 0.38 to 0.73mgml(-1). The average size of prepared Cur/PLA-PEG micelles was from 60 to 69nm (corresponding to the ratio difference of PLA/PEG) and the drug encapsulating efficiency was from 48.8 to 91.3%. Compared with the Cur/PLA-PEG micelles, the size of Cur/PLA-PEG-Fol micelles were from 80 to 86nm and showed better in vitro cellular uptake and cytotoxicity towards HepG2 cells. The cytotoxicity of the NPs however depends much on the PEG component. The results demonstrated that Folate-modified micelles could serve as a potential nano carrier to improve solubility, anti-cancer activity of Cur and targeting ability of the system.

Study of the hydrophobic cavity of beta-cryptogein through laser-polarized xenon NMR spectroscopy.

The interaction of xenon with beta-cryptogein, a basic 10 kDa protein belonging to the elicitin family, has been studied by using dissolved thermal and laser-polarized gas in liquid-state NMR. 13C and 1H chemical-shift-mapping experiments were unfruitful, the proton lines only experienced a slight narrowing but no significant frequency variation when the xenon concentration was increased. Nevertheless magnetization transfer from hyperpolarized xenon to protons of the protein demonstrates an undoubted interaction and enables localization of the noble-gas-binding site. Due to the proton-proton cross-relaxation efficiency, however, this experiment is subjected to important spin-diffusion. An automatic procedure that takes spin-diffusion into account when assigning the protons that interact with xenon is then used. The binding site, as defined by 30 Xe--H interactions, is situated in the inner core of the protein. The protons that interact with xenon border the channel by which sterols are known to enter into the cavity. These results support the idea that xenon is a good probe for hydrophobic protein regions.