RESUMO
In the current study, the concept of multiparticulate drug delivery systems (MDDS) was applied to tablets intended for the amorphisation of supersaturated granular ASDs in situ, i.e. amorphisation within the final dosage form by microwave irradiation. The MDDS concept was hypothesised to ensure geometric and structural stability of the dosage form and to improve the in vitro disintegration and dissolution characteristics. Granules were prepared in two sizes (small and large) containing the crystalline drug celecoxib (CCX) and polyvinylpyrrolidone/vinyl acetate copolymer (PVP/VA) at a 50 % w/w drug load as well as sodium dihydrogen phosphate monohydrate as the microwave absorbing excipient. The granules were subsequently embedded in an extra-granular tablet phase composed of either the filler microcrystalline cellulose (MCC) or mannitol (MAN), as well as the disintegrant crospovidone and the lubricant magnesium stearate. The tensile strength and disintegration time were investigated prior to and after 10 min of microwave irradiation (800 and 1000 W) and the formed ASDs were characterised by X-ray powder diffraction and modulated differential scanning calorimetry. Additionally, the internal structure was elucidated by X-ray micro-Computed Tomography (XµCT) and, finally, the dissolution performance of selected tablets was investigated. The MDDS tablets displayed no geometrical changes after microwave irradiation, however, the tensile strength and disintegration time generally increased. Complete amorphisation of CCX was achieved only for the MCC-based tablets at a power input of 1000 W, while MAN-based tablets displayed partial amorphisation independent of power input. The complete amorphisation of CCX was associated with the fusion of individual ASD granules within the tablets, which negatively impacted the subsequent disintegration and dissolution performance. For these tablets, supersaturation was only observed after 60 min. On the other hand, the partially amorphised MDDS tablets displayed complete disintegration during the dissolution experiments, resulting in a fast onset of supersaturation within 5 min and an approx. 3.5-fold degree of supersaturation within the experimental timeframe (3 h). Overall, the MDDS concept was shown to potentially be a feasible dosage form for in situ amorphisation, however, there is still room for improvement to obtain a both fully amorphous and disintegrating system.
Assuntos
Química Farmacêutica , Povidona , Humanos , Química Farmacêutica/métodos , Microtomografia por Raio-X , Comprimidos/química , Povidona/química , Excipientes/química , Celecoxib/química , Manitol/química , Sistemas de Liberação de Medicamentos , SolubilidadeRESUMO
This study investigated the ability of in situ amorphisation using microwave irradiation in order to prepare highly supersaturated ASDs, i.e. ASDs with drug loads higher than the saturation solubility in the polymer at ambient temperature. For this purpose, compacts containing the crystalline drug celecoxib (CCX) and polyvinylpyrrolidone (PVP), polyvinylpyrrolidone-vinyl acetate copolymer (PVP/VA), or polyvinyl acetate (PVAc), were prepared at drug loads between 30 and 90 % w/w. Sodium dihydrogen phosphate (NaH2PO4) monohydrate was included in all compacts, as a source of water, to facilitate the dielectric heating of the compacts upon dehydration during microwave irradiation. After processing, the samples were analysed towards their solid state using X-ray powder diffraction (XRPD) and modulated differential scanning calorimetry (mDSC). Complete amorphisation of CCX was achieved across all the investigated polymers and with a maximal drug load of 90, 80, and 50 % w/w in PVP, PVP/VA, and PVAc, respectively. These drug loads corresponded to a 2.3-, 2.4-, and 10.0-fold supersaturation in the investigated polymers at ambient temperature. However, dissolution experiments with the in situ prepared ASDs in fasted state simulated intestinal fluid (FaSSIF), showed a lower initial drug release (0-2 h) compared to equivalent physical mixtures of crystalline CCX and polymers or crystalline CCX alone. The lower drug release rate was explained by the fusion of individual drug and polymer particles during microwave irradiation and, subsequently, a lack of disintegration of the monolithic ASDs. Nevertheless, supersaturation of CCX in FaSSIF was achieved with the in situ amorphised ASDs with PVP and PVP/VA, albeit only after 3-24 h. Overall, the present study confirmed that it is feasible to prepare supersaturated ASDs in situ. However, in the current experimental setup, the monolithic nature of the resulting ASDs is considered a limiting factor in the practical applicability of this preparation method, due to limited disintegration and the associated negative effect on the drug release.
Assuntos
Micro-Ondas , Povidona , Celecoxib/química , Polímeros/química , Polivinil , Povidona/química , Solubilidade , ÁguaRESUMO
Amorphisation within the final dosage form, i.e. in situ amorphisation, seeks to circumvent the potential stability issues associated with poorly soluble drugs in amorphous solid dispersions (ASDs). Microwave irradiation has previously been shown to enable in situ preparation of ASDs, when a high amount of microwave absorbing water was introduced into the final dosage form by conditioning at high relative humidity. In this study, an alternative to this conditioning step was investigated by introducing crystal water in form of sodium dihydrogen phosphate (NaH2PO4) di-, and monohydrate, in compacts prepared with 30 % w/w celecoxib (CCX) in polyvinylpyrrolidone K12 (PVP). As controls, compacts prepared with NaH2PO4 anhydrate and without NaH2PO4 were included in the study. The quantification of amorphous CCX after microwave irradiation showed an increase in CCX amorphicity for compacts containing NaH2PO4 di-, and monohydrate with increasing irradiation time. Complete amorphisation of CCX in compacts containing NaH2PO4 di-, and monohydrate was observed after 6 min, while no appreciable amorphisation was observed for the control compacts containing NaH2PO4 anhydrate and without NaH2PO4. Modulated differential scanning calorimetric analysis revealed that a homogenous ASD was formed after 12 min and 6 min for compacts containing NaH2PO4 di-, and monohydrate, respectively. Thermal gravimetric analysis indicated that NaH2PO4 monohydrate showed higher dehydration rates compared to the dihydrate, which in turn resulted in higher compact temperatures, and overall increased the rate of amorphisation and reduced the microwave irradiation time necessary to achieve a homogenous ASD. The present results confirmed the suitability of NaH2PO4 di- and monohydrate as alternative sources of water, the primary microwave absorbing material, for in situ microwave amorphisation. The use of crystalline hydrates as water reservoirs for in situ amorphisation circumvents the time-consuming and highly impractical conditioning step previously reported in order to achieve complete amorphisation. Additionally, it allows for easier and more accurate adjustment of the compacts water content, which directly affects the temperature reached during microwave irradiation, and thus, the rate of amorphisation.
Assuntos
Micro-Ondas , Preparações Farmacêuticas , Varredura Diferencial de Calorimetria , Cristalização , Povidona , SolubilidadeRESUMO
The typical excipients used as bulking agents and lyoprotectants for freeze-drying are usually limited to only a few selected substances, such as sucrose and mannitol. Considering the sheer diversity amongst proteins, it is doubtful that this limited choice should, in every case, provide the best possible option in order to achieve the most stable product. In this work, a screening of 12 proteins with 64 excipients was conducted in order to increase the knowledge space of potential excipients. Three critical quality attributes (CQAs) of the freeze-dried products, namely the solid state, the cake appearance and the protein integrity based on changes in tryptophan fluorescence were investigated by high throughput X-ray powder diffraction, image analysis and intrinsic fluorescence spectroscopy, respectively. It was found, that in some cases the excipient had a dominating influence on the CQAs, whilst in other cases the CQAs were primarily protein dependent, or that the CQAs were dependent on the combination of both. In the course of this investigation, a general view of potentially relevant excipients, and their interplay with various proteins, was obtained, thereby furthermore paving the way for the use of novel freeze-drying excipients.
Assuntos
Produtos Biológicos/química , Composição de Medicamentos/métodos , Excipientes/química , Proteínas/química , Química Farmacêutica , Liofilização , Difração de Raios XRESUMO
Commonly, a limited number of generally accepted bulking agents and lyoprotectants are used for freeze-drying; predominantly mannitol, glycine, sucrose and trehalose. The purpose of this study was to combine a theoretical approach using molecular descriptors with a large scale experimental screening to evaluate the suitability of a broad range of excipients for freeze-drying. A large selection of sugars, polyols and amino acids was characterized by modulated differential scanning calorimetry (mDSC) and X-ray powder diffraction (XRPD) after well-plate based freeze-drying. The calculated molecular descriptors were investigated with both hierarchical cluster analysis and principal component analysis. A clear clustering of the excipients according to the size-related and weight-related descriptors was observed; however other relevant descriptors could also be identified. From a practical perspective, a trend was observed with regard to a higher likelihood for amorphisation and a higher glass transition temperature of the maximally freeze-concentrated solution with increasing molecular size. A translation of the molecular descriptors on pharmaceutical performance was more successful for lyoprotectants than for bulking agents. Additionally, in the course of the experimental screening, several new potential bulking agents and lyoprotectants were identified.