Radioactivity and radionuclides in deciduous teeth formed before the Fukushima-Daiichi Nuclear Power Plant accident.

The Fukushima-Daiichi Nuclear Power Plant (FNPP) accident in March of 2011 released substantial amounts of radionuclides into the environment. We collected 4,957 deciduous teeth formed in children before the Fukushima accident to obtain precise control data for teeth formed after the accident. Radioactivity was measured using imaging plates (IP) and epidemiologically assessed using multivariate regression analysis. Additionally, we measured 90Sr, 137Cs, and natural radionuclides which might be present in teeth. Epidemiological studies of IP showed that the amount of radioactivity in teeth from Fukushima prefecture was similar to that from reference prefectures. We found that artificial radionuclides of 90Sr and 137Cs, which were believed to have originated from past nuclear disasters, and natural radionuclides including 40 K and daughter nuclides in the 238U and 232Th series contributed to the generation of radioactivity in teeth. We also found no evidence to suggest that radionuclides originating from the FNPP accident significantly contaminated pre-existing teeth. This is the first large-scale investigation of radioactivity and radionuclides in teeth. The present findings will be indispensable for future studies of teeth formed after the FNPP accident, which will fall out over the next several years and might be more contaminated with radionuclides.

Influence of irradiation conditions on the deformation of pure titanium frames in laser welding.

Due to its ease of use in connecting metal frames, laser welding is now applied in dentistry. However, to achieve precise laser welding, several problems remain to be resolved. One such problem is the influence of irradiation conditions on the deformation of titanium frameworks during laser welding, which this study sought to investigate. Board-shaped pure titanium specimens were prepared with two different joint types. Two specimens were abutted against each other to form a welding block with gypsum. For welding, three different laser waveforms were used. Deformation of the specimen caused by laser welding was measured as a rise from the gypsum surface at the opposite, free end of the specimen. It was observed that specimens with a beveled edge registered a smaller deformation than specimens with a square edge. In addition, a double laser pulse waveform--whereby a supplementary laser pulse was delivered immediately after the main pulse--resulted in a smaller deformation than with a single laser pulse waveform.