Tip-apex distance as a risk factor for cut-out in cephalic double-screw nailing of intertrochanteric femur fractures.

Aims: Proximal femur fractures treatment can involve anterograde nailing with a single or double cephalic screw. An undesirable failure for this fixation is screw cut-out. In a single-screw nail, a tip-apex distance (TAD) greater than 25 mm has been associated with an increased risk of cut-out. The aim of the study was to examine the role of TAD as a risk factor in a cephalic double-screw nail. Methods: A retrospective study was conducted on 112 patients treated for intertrochanteric femur fracture with a double proximal screw nail (Endovis BA2; EBA2) from January to September 2021. The analyzed variables were age, sex, BMI, comorbidities, fracture type, side, time of surgery, quality of reduction, pre-existing therapy with bisphosphonate for osteoporosis, screw placement in two different views, and TAD. The last follow-up was at 12 months. Logistic regression was used to study the potential factors of screw cut-out, and receiver operating characteristic curve to identify the threshold value. Results: A total of 98 of the 112 patients met the inclusion criteria. Overall, 65 patients were female (66.3%), the mean age was 83.23 years (SD 7.07), and the mean follow-up was 378 days (SD 36). Cut-out was observed in five patients (5.10%). The variables identified by univariate analysis with p < 0.05 were included in the multivariate logistic regression model were screw placement and TAD. The TAD was significant with an odds ratio (OR) 5.03 (p = 0.012) as the screw placement with an OR 4.35 (p = 0.043) in the anteroposterior view, and OR 10.61 (p = 0.037) in the lateral view. The TAD threshold value identified was 29.50 mm. Conclusion: Our study confirmed the risk factors for cut-out in the double-screw nail are comparable to those in the single screw. We found a TAD value of 29.50 mm to be associated with a risk of cut-out in double-screw nails, when good fracture reduction is granted. This value is higher than the one reported with single-screw nails. Therefore, we suggest the role of TAD should be reconsidered in well-reduced fractures treated with double-screw intramedullary nail.

Comparison of cutout risk factors between single- and doublescrew proximal nails in intertrochanteric femur fractures - a multicentric study.

Aim Significant risk factors for femoral nail cutout are well-documented, primarily in the context of single-screw proximal nails. However, it remains uncertain whether those same risk factors are applicable when considering different implant devices. The aim of this retrospective cohort study was to compare cutout risk factors between single- versus double-screw proximal femoral nails. Methods Patients over the age of 75 with intertrochanteric femur fractures (AO Classification 31-A1 or 31-A2) were included in the multicentre study. A study group was treated with a double-screw nail, while a control group received single-screw device. Demographic data, surgical time (min), fracture pattern, distal locking, reduction quality, comorbidities, tip-apex distance (TAD) and 12-month functional scores was collected. Results Two hundred patients were enrolled, 100 for each group. Nine patients experienced a cutout complication, five in the study and four in the control group. The main differences were in distal locking configurations (p<0.05) and in TAD values (p<0.05). The TAD value was higher in the study than in the control group (30.40±0.89 versus 26.79±1.79). No differences at 12-month follow up were reported according to functional scores. Conclusion This study provides insights into the choice of nail systems for intertrochanteric femur fractures, highlighting the importance of distal locking configurations and TAD values. The double screw nail exhibits quite a tolerance by having a higher average TAD value. These findings may guide clinical decisionmaking in the treatment of this challenging fracture type.

Computer-assisted navigation for intramedullary nailing of intertrochanteric femur fractures: a preliminary result.

Aim To demonstrate a reduction of risk factors ray-depending in proximal femur nailing of intertrochanteric femur fractures, comparing standard technique with computer-assisted navigation system. Methods One hundred patients hospitalised between October 2021 and June 2022 with intertrochanteric femur fractures type 31-A1 and 31-A2 were prospectively enrolled and divided randomly into two groups. A study group was treated with computer-assisted navigation system ATLAS (Masmec Biomed, Modugno, Bari, Italy) (20 patients), while a control group received the standard nailing technique. The same intertrochanteric nail was implanted by a single senior surgeon, Endovis BA 2 (EBA2, Citieffe, Calderara di Reno, Bologna, Italy). The following data were recorded: the setup time of operating room (STOR; minutes); surgical time (ST; minutes); radiation exposure time (ETIR; seconds) and dose area product (DAP; cGy·cm2). Results Patients underwent femur nailing with computer-assisted navigation system reported more set-up time of operating room (24.87±4.58; p<0.01), less surgical time (26.15±5.80; p<0.01), less time of radiant exposure (4.84±2.07; p<0.01) and lower dose area product (16.26±2.91; p<0.01). Conclusion The preliminary study demonstrated that computerassisted navigation allowed a better surgical technique standardization, significantly reduced exposure to ionizing radiation, including a reduction in surgical time. The ATLAS system could also play a key role in residents improving learning curve.

Continuous Cold Flow Device Following Total Knee Arthroplasty: Myths and Reality.

Background and Objectives: To assess the effect of continuous cold flow (CCF) therapy on pain reduction, opioid consumption, fast recovery, less perioperative bleeding and patient satisfaction in patients undergoing a total knee arthroplasty. Materials and Methods: Patients affected by knee osteoarthritis between September 2020 and February 2022 were enrolled in this case-control study. Patients were randomly divided into two groups (n = 50, each): the study group received postoperative CCF therapy while the control group was treated by cold pack (gel ice). The CCF device is a computer-assisted therapy with continuous cold fluid, allowing a selective distribution, constant and uniform, of cold or hot on the areas to be treated. In both groups, pre- and postoperative evaluations at 6, 24, 72 h and at the fifth day were conducted using Visual Analogic Scale (VAS), opioid consumption, passive range of motion, preoperative hematocrit, total blood loss by Gross formula, transfusion requirement and patient satisfaction questionnaire. Results: One hundred patients, 52 women (52%), were included in the study. Reduction of pain, opioid consumption and increase in passive range of movement were statistically significantly demonstrated in the study group on the first and third days. Patients were satisfied with adequate postoperative pain management due to CCF therapy (p = 0.01) and they would recommend this treatment to others (p = 0.01). Conclusions: A continuous cold flow device in the acute postoperative setting after total knee arthroplasty is associated with pain reduction and improving early movement. Patients were almost satisfied with the procedure. The management of perioperative pain control could improve participation in the early rehabilitation program as demonstrated by the increase in ROM, psychological satisfaction and reduction in opioid use.

Allogenic platelet concentrates from umbilical cord blood for knee osteoarthritis: preliminary results.

Aim To investigate the role of cordonal blood platelet-rich plasma (PRP) intra-articular injections for treating the patients with knee osteoarthritis in terms of procedure safety and clinical outcomes. Methods Twenty-five patients affected by knee osteoarthritis were enrolled and received one single intra-articular knee injection of umbilical cord PRP in a volume of 10 mL. A follow-up was investigated at time 0, 4, 8, 12 weeks and 6 months, evaluating clinical parameters and functional performances. Results No serious adverse events were identified. The paired ttest analysis showed a significant difference between baseline and each follow-up times for all clinical scales (p<0.05), with a significant improvement of clinical outcomes. Conclusion Allogeneic PRP can generate reliable therapeutic effect. The high content of tissue regenerative factors in cord blood platelets makes cordonal blood one of the ideal sources of PRP.

Insights on the role of physical activity in patients with rheumatoid arthritis.

Patients with rheumatoid arthritis (RA) are physically inactive, and trials have been undertaken to examine the effect of physical activity on pain, disease activity, functional ability and quality of life (QoL) in RA. The aim of this study was to explore the relationship between physical activity and disease-activity in RA and in healthy controls. Our findings showed that fewer RA patients had a professional occupation compared with controls, but patients and controls were similar with respect to the sedentary extent of their job. Physical exercise was inversely associated with disease activity (DAS-28), stiffness visual analog scale (VAS), patient global VAS and SF-36, but not associated with Health Assessment Questionnaire (HAQ), pain VAS, fatigue VAS, global health and the Arthritis Ipact Measurement Scale (AIMS), suggesting that pain and fatigue are important barriers to physical activity. Our findings suggest that this is more pronounced in RA patients who do not participate in regular physical activity, and so physical exercise should be recommended as part of comprehensive RA care.