Measurement uncertainty of ethyl alcohol concentration in the exhaled breath of drivers and determination of sobriety at the time of incident. / Niepewnosc pomiaru stezenia alkoholu etylowego w powietrzu wydychanym kierowców oraz ustalenia stanu trzezwosci w chwili zdarzenia.

The aim of the study was to determine the components of measurement uncertainty in the concentration of alcohol in exhaled breath and to determine the state of sobriety at the time of incident. Based on the literature review and the authors' experience in providing opinions for law enforcement and the judiciary, the influence of various factors on the final interpretation of sobriety state is described on the basis of measurement uncertainty of breath analyzers, uncertainty of retrospective and prospective calculations, and uncertainty related to the conversion of alcohol concentrations detected during breath and blood tests. The paper pays particular attention to interpreting the concentrations of ethanol in exhaled breath close to the legal limits of the state of sobriety and the state after alcohol use, or the state after alcohol use and the state of insobriety. Analyzing the results of an exhaled breath test concerning concentrations close to the values of 0.1 mg/dm3 and 0.25 mg/dm3, it is necessary to take into account the factors affecting the measurements obtained, including the measurement uncertainty of the determination of alcohol in exhaled breath, the processes of absorption, distribution and metabolism of ethyl alcohol, and the possibility of the presence of alcohol lingering in the oral cavity. The incorrect execution of measurements of the tested person's alcohol concentration is also a problematic issue. When determining sobriety state by means of retrospective and prospective calculations, it is important to remember that the uncertainty of the result is affected by a number of factors and depends, among other things, on the information provided by the suspect. Hence, the expert should draw conclusions particularly cautiously and any overestimation or underestimation of the components of uncertainty can lead to erroneous conclusions. Awareness of the uncertainties inherent in the results of a sobriety test or alcohol calculation allows for meaningful interpretation of test results and determination of the sobriety state of the person tested.

Bioconversion of waste glycerol into viscosinamide by Pseudomonas fluorescens DR54 and its activity evaluation.

Lipopeptides, derived from microorganisms, are promising surface-active compounds known as biosurfactants. However, the high production costs of biosurfactants, associated with expensive culture media and purification processes, limit widespread industrial application. To enhance the sustainability of biosurfactant production, researchers have explored cost-effective substrates. In this study, crude glycerol was evaluated as a promising and economical carbon source in viscosinamide production by Pseudomonas fluorescens DR54. Optimization studies using the Box - Behnken design and response surface methodology were performed. Optimal conditions for viscosinamide production including glycerol 70.8 g/L, leucine 2.7 g/L, phosphate 3.7 g/L, and urea 9.3 g/L were identified. Yield of viscosinamide production, performed under optimal conditions, reached 7.18 ± 0.17 g/L. Preliminary characterization of viscosinamide involved the measurement of surface tension. The critical micelle concentration of lipopeptide was determined to be 5 mg/L. Furthermore, the interactions between the viscosinamide and lipase from Candida rugosa (CRL) were investigated by evaluating the impact of viscosinamide on lipase activity and measuring circular dichroism. It was observed that the α-helicity of CRL increases with increasing viscosinamide concentration, while the random coil structure decreases.

Evaluation of the Antitumor Activity of Quaternary Ammonium Surfactants.

Quaternary ammonium surfactants, due to their diverse chemical structure and their biological properties, can be used in medicine as DNA carriers, disinfectants, and antimicrobial and antitumor agents. In this study, using melanoma A375, colon adenocarcinoma HT-29 and normal human dermal fibroblast (NHDF) cells, we tested the hypothesis that the quaternary ammonium surfactants 2-dodecanoyloxyethyl)trimethylammonium bromide (DMM-11), 2-dodecanoyloxypropyl)trimethylammonium bromide (DMPM-11) and 2-pentadecanoyloxymethyl)trimethylammonium bromide (DMGM-14) act selectively against cancer cells. The results showed that these compounds led to the initiation of the apoptotic process of programmed cell death, as evidenced by the ratio of the relative expression of Bax protein to Bcl-2. The encapsulation of surfactants in liposomes allowed lower concentrations to be used. Moreover, encapsulation reduced their toxicity towards non-cancerous cells. The anticancer efficiency and apoptotic effect of the liposomal formulations with surfactants (DMM-11, DMPM-11 and DMGM-14) were higher than those of surfactant-free liposomes. Therefore, quaternary ammonium surfactant-loaded liposomes show significant potential as delivery vehicles for the treatment of melanoma and colon cancers. The use of nano-formulations offers the advantage of optimizing quaternary ammonium surfactant delivery for improved anticancer therapy.

High value-added products derived from crude glycerol via microbial fermentation using Yarrowia clade yeast.

BACKGROUND: Contemporary biotechnology focuses on many problems related to the functioning of developed societies. Many of these problems are related to health, especially with the rapidly rising numbers of people suffering from civilization diseases, such as obesity or diabetes. One factor contributing to the development of these diseases is the high consumption of sucrose. A very promising substitute for this sugar has emerged: the polyhydroxy alcohols, characterized by low caloric value and sufficient sweetness to replace table sugar in food production. RESULTS: In the current study, yeast belonging to the Yarrowia clade were tested for erythritol, mannitol and arabitol production using crude glycerol from the biodiesel and soap industries as carbon sources. Out of the 13 tested species, Yarrowia divulgata and Candida oslonensis turned out to be particularly efficient polyol producers. Both species produced large amounts of these compounds from both soap-derived glycerol (59.8-62.7 g dm-3) and biodiesel-derived glycerol (76.8-79.5 g dm-3). However, it is equally important that the protein and lipid content of the biomass (around 30% protein and 12% lipid) obtained after the processes is high enough to use this yeast in the production of animal feed. CONCLUSIONS: The use of waste glycerol for the production of polyols as well as utilization of the biomass obtained after the process for the production of feed are part of the development of modern waste-free technologies.

Sustainable Surfactin Production by Bacillus subtilis Using Crude Glycerol from Different Wastes.

Most biosurfactants are obtained using costly culture media and purification processes, which limits their wider industrial use. Sustainability of their production processes can be achieved, in part, by using cheap substrates found among agricultural and food wastes or byproducts. In the present study, crude glycerol, a raw material obtained from several industrial processes, was evaluated as a potential low-cost carbon source to reduce the costs of surfactin production by Bacillus subtilis #309. The culture medium containing soap-derived waste glycerol led to the best surfactin production, reaching about 2.8 g/L. To the best of our knowledge, this is the first report describing surfactin production by B. subtilis using stearin and soap wastes as carbon sources. A complete chemical characterization of surfactin analogs produced from the different waste glycerol samples was performed by liquid chromatography-mass spectrometry (LC-MS) and Fourier transform infrared spectroscopy (FTIR). Furthermore, the surfactin produced in the study exhibited good stability in a wide range of pH, salinity and temperatures, suggesting its potential for several applications in biotechnology.