RESUMO
Spontaneous bone regeneration is a rapid and uncommon formation of new bone in a previous bone defect. Preservation of periosteum as the main source of osteogenesis, young age, and genetics are possible important factors related to this phenomenon.
RESUMO
PURPOSE: The mandible is an essential esthetic and functional component of the lower third of the face and its reconstruction has always been a challenge, especially after severe post-traumatic injuries. The purpose of the present report was to introduce a new approach of mandibular reconstruction in a patient who had lost the entire mandible except for the rami after being severely injured in a blast. MATERIALS AND METHODS: A new approach using a titanium mandibular rami implant technique was applied using computer-aided 3-dimensional virtual planning and rapid prototyping technology. A prosthetic component was supported by the mandibular implant, which achieved occlusion and dedicated function for the patient. RESULTS: This method offered precise adaptation of the implant and prosthesis and an easier surgical procedure, providing a shortened operation time, no donor site morbidity, and more predictable outcomes. CONCLUSION: This new technique allows reconstruction of large-scale mandibular defects that is not possible by conventional surgical methods.
Assuntos
Desenho Assistido por Computador , Imageamento Tridimensional , Traumatismos Mandibulares/cirurgia , Implante de Prótese Mandibular/métodos , Prótese Mandibular , Reconstrução Mandibular/métodos , Cirurgia Assistida por Computador/métodos , Humanos , Masculino , Implante de Prótese Mandibular/instrumentação , Reconstrução Mandibular/instrumentação , Impressão Tridimensional , Cirurgia Assistida por Computador/instrumentação , Adulto JovemRESUMO
BACKGROUND: This study was conducted to assess the effect of thickness and hydration condition on the surface microhardness of Endosequence Root Repair Material putty (ERRM; Brasseler USA, Savannah, GA), a premixed bioceramic material. MATERIALS AND METHODS: Polymethyl methacrylate cylindrical molds with an internal diameter of 4 mm and three heights of 2, 4, and 6 mm were fabricated. In Group 1 (dry condition), the molds with heights of 2, 4, and 6 mm (10 molds of each) were filled with ERRM. In Groups 2 and 3 (wet condition), a distilled water- or phosphate-buffered saline (PBS)-moistened cotton pellet was placed directly on the upper surface of ERRM, respectively. The lower surface of ERRM was in contact with floral foams soaked with human blood. After 4 days, Vickers microhardness of the upper surface of ERRM was tested. The data were analyzed using two-way analysis of variance. Significance level was set at P < 0.05. RESULTS: No significant difference was found between the microhardness of three thicknesses of ERRM (2, 4, and 6 mm) with or without placing a distilled water- or PBS-moistened cotton pellet over the material (P > 0.05). CONCLUSION: Based on the results of this study, it could be concluded that placing a moistened cotton pellet on ERRM putty up to 6 mm thick might be unnecessary to improve its surface microhardness and hydration characteristics.