Antropological measurement of the calcaneus.

Transfer of the forces from the trunk to the lower extremities end on calcaneus which transports these forces to the pad, and that is why it is very important to research this bone. This study was done on 57 calcaneal bones of the osteological collection of the Department of Anatomy "Drago Perovic" Zagreb School of Medicine and Department of Anatomy Osijek School of Medicine. The intention was to notice the regularity of the relations between specific dimensions and bone mass and structure, which is of great importance for understanding interrelation between biomechanical parameters of calcaneus and development of involutive changes. In this study geometrical parameters of the calcaneus have been defined, so length of the whole bone and especially frontal and back part, width, height, weight of dry bone, volume, geometrical surface of lateral and longitudinal cross section have been measured on every anatomical specimen. --Mean value, standard deviation and standard error have been calculated for every measured parameter. Positive correlation between most of the parameters of the calcaneus and negative correlation between specific weight and surface of cross section have been found. Coefficient of variation is the highest for weight, and the smallest for width.

Morphometric characteristics of thyroid cartilage in people of Eastern Croatia.

The aim of this research was to describe thyroid cartilage morphometry in the population of Eastern Slavonia in detail. The research was carried out on 68 samples of adult thyroid cartilages. There was statistically significant difference between all analysed parameters in male and female samples, except for the distance between the superior horns tips. All parameters had greater values in men, except for the thyroid angle, which was greater in women. There was significant correlation between most of the measured parameters. The strongest correlation was noticed in the distance between the horns at all measured levels and between the pairs of parameters measured for the left and right side respectively. The difference of our results in comparison to the results obtained by other researchers is probably caused by the fact that the measurements were taken on the samples obtained from different populations.

Antropological measurement of the sacroiliac joint.

This study was done on 65 isolated pelvic bones, These cadavers belonged to adult people of mature and old age, and they had no pathological changes. These measurements were performed on osteological collection of Department of Anatomy Drago Perovic. Many geometrical parameters of facies auricularis were measured, which we considered important for further studies, simulations of joint's action, transfer calculations of the forces from spine to hip joint. We used paper, which partially adapted to the surface of facies auricularis, so the values are closer to real ones than projection values. The results have shown that the average surface of facies auricularis is 13.46 cm(2). There was no statistical significance found between left and right cadavers. For easier orientation we divided surface of facies auricularis into two parts: vertical and horizontal. Height of the vertical part was 3.99 cm, while the width was 2.05 cm. Height of horizontal part was 2.07 cm and the width 3.62 cm.

Morphological characteristics of the acetabulum.

The aim of this research was to accurately measure the surface of the semi lunar articular surface of the pelvis (facies lunata acetabuli) and the variability of the acetabular geometry, as well as to determine the correlation between measured parameters. 30 macerated anatomical specimens of pelvic bones were measured. The radius and depth were measured in the classical way, while cartilaginous surface area was measured using small fragments of measuring paper to avoid errors in measurement due to the curvature of the surface. Computerized calculations provided accurate surface values. In our research, facies lunata acetabuli measured 2294+/-329 mm2. Diameter of the opening of the acetabulum measured 25.8+/-1.9 mm. Acetabular depth was 30+/-3.2 mm. Correlations between the surface area of the facies lunata acetabuli and the radius of the acetabular opening curvature (r=0.71), surface area of the facies lunata acetabuli and the depth of the acetabulum (r=0.80) and the radius of the acetabular opening curvature and the depth of the acetabulum (r=0.80) were confirmed. For precise assessment of the facies lunata acetabuli surface area, the simplest and the cheapest method is the method of measurement using small fragments of measuring paper and software analysis. There is a significant correlation between the depth, opening of the acetabulum and surface area of the facies lunata.

Holistic approach to functional anatomy of the injured ankle joint.

Talocrural joint injuries are among the most common injuries of the joints and therefore there is a need for a holistic approach to analysis of morphology, biomechanics and visualization of the talocrural joint ligamentary apparatus in different positions. The research was carried out on 20 fresh and conserved anatomical specimens of the lower leg on which X-ray, computed tomography, ultrasonography and stress analysis were performed before and after the lesion of ligaments. Also the gait of 130 adults without (100) and with ligament and joint capsule lesion (30) was analyzed by infrared telemetry. After complete discission of the lateral ligaments, arthrography and CT could register the lesion, while X-ray and ultrasonography could not detect it. Gait analysis of healthy and injured leg showed that the injured leg was significantly less loaded.