DNA sequence and taxonomic gap analyses to quantify the coverage of aquatic cyanobacteria and eukaryotic microalgae in reference databases: Results of a survey in the Alpine region.

The taxonomic identification of organisms based on the amplification of specific genetic markers (metabarcoding) implicitly requires adequate discriminatory information and taxonomic coverage of environmental DNA sequences in taxonomic databases. These requirements were quantitatively examined by comparing the determination of cyanobacteria and microalgae obtained by metabarcoding and light microscopy. We used planktic and biofilm samples collected in 37 lakes and 22 rivers across the Alpine region. We focused on two of the most used and best represented genetic markers in the reference databases, namely the 16S rRNA and 18S rRNA genes. A sequence gap analysis using blastn showed that, in the identity range of 99-100%, approximately 30% (plankton) and 60% (biofilm) of the sequences did not find any close counterpart in the reference databases (NCBI GenBank). Similarly, a taxonomic gap analysis showed that approximately 50% of the cyanobacterial and eukaryotic microalgal species identified by light microscopy were not represented in the reference databases. In both cases, the magnitude of the gaps differed between the major taxonomic groups. Even considering the species determined under the microscope and represented in the reference databases, 22% and 26% were still not included in the results obtained by the blastn at percentage levels of identity ≥95% and ≥97%, respectively. The main causes were the absence of matching sequences due to amplification and/or sequencing failure and potential misidentification in the microscopy step. Our results quantitatively demonstrated that in metabarcoding the main obstacles in the classification of 16S rRNA and 18S rRNA sequences and interpretation of high-throughput sequencing biomonitoring data were due to the existence of important gaps in the taxonomic completeness of the reference databases and the short length of reads. The study focused on the Alpine region, but the extent of the gaps could be much greater in other less investigated geographic areas.

Application of hydrodynamic cavitation in ballast water treatment.

Ballast water is, together with hull fouling and aquaculture, considered the most important factor of the worldwide transfer of invasive non-indigenous organisms in aquatic ecosystems and the most important factor in European Union. With the aim of preventing and halting the spread of the transfer of invasive organisms in aquatic ecosystems and also in accordance with IMO's International Convention for the Control and Management of Ships Ballast Water and Sediments, the systems for ballast water treatment, whose work includes, e.g. chemical treatment, ozonation and filtration, are used. Although hydrodynamic cavitation (HC) is used in many different areas, such as science and engineering, implied acoustics, biomedicine, botany, chemistry and hydraulics, the application of HC in ballast water treatment area remains insufficiently researched. This paper presents the first literature review that studies lab- and large-scale setups for ballast water treatment together with the type-approved systems currently available on the market that use HC as a step in their operation. This paper deals with the possible advantages and disadvantages of such systems, as well as their influence on the crew and marine environment. It also analyses perspectives on the further development and application of HC in ballast water treatment.

Removal of particles in organic filters in experimental treatment systems for domestic wastewater and black water.

This study assesses the total suspended solids (TSS) retention capacity of different organic filter media for two potential applications: (i) a polishing unit for package treatment plants and (ii) a pretreatment for blackwater from low-flushing toilets. The results showed that the peat filter media used can be significantly improved in terms of structural stability and TSS removal capacity by mixing it with sawdust. Most of the TSS accumulated in the upper part of the filter material, and filter thickness exceeding 15 cm had no statistically significant effect (P < 0.1) on the TSS treatment performance. The experimental system reached a TSS reduction of 60-70% for blackwater and 80-90% for simulated effluent peaks from a package treatment plant. The main challenge of a full-scale application of an organic filter is the issue of clogging, especially when treating concentrated blackwater. However, this work indicates that a clogged filter media can be regenerated by mixing the uppermost filter layer without significant loss of filter performance regarding TSS. More research is needed to develop an appropriate mechanical unit for automatic filter media regeneration.

Comparison of different wastewater treatments for removal of selected endocrine-disruptors from paper mill wastewaters.

There is increasing concern about chemical pollutants that have the ability to mimic hormones, the so-called endocrine-disrupting compounds (EDCs). One of the main reasons for concern is the possible effect of EDCs on human health. EDCs may be released into the environment in different ways, and one of the most significant sources is industrial wastewater. The main objective of this research was to evaluate the treatment performance of different wastewater treatment procedures (biological treatment, filtration, advanced oxidation processes) for the reduction of chemical oxygen demand and seven selected EDCs (dimethyl phthalate, diethyl phthalate, dibutyl phthalate, benzyl butyl phthalate, bis(2-ethylhexyl) phthalate, bisphenol A and nonylphenol) from wastewaters from a mill producing 100 % recycled paper. Two pilot plants were running in parallel and the following treatments were compared: (i) anaerobic biological treatment followed by aerobic biological treatment, ultrafiltration and reverse osmosis (RO), and (ii) anaerobic biological treatment followed by membrane bioreactor and RO. Moreover, at lab-scale, four different advanced oxidation processes (Fenton reaction, photo-Fenton reaction, photocatalysis with TiO(2), and ozonation) were applied. The results indicated that the concentrations of selected EDCs from paper mill wastewaters were effectively reduced (100 %) by both combinations of pilot plants and photo-Fenton oxidation (98 %), while Fenton process, photocatalysis with TiO(2) and ozonation were less effective (70 % to 90 %, respectively).

Negative impact of endocrine-disrupting compounds on human reproductive health.

There is increasing concern about chemical pollutants that are able to mimic hormones, the so-called endocrine-disrupting compounds (EDCs), because of their structural similarity to endogenous hormones, their ability to interact with hormone transport proteins or because of their potential to disrupt hormone metabolic pathways. Thus, the effects of endogenous hormones can be mimicked or, in some cases, completely blocked. A substantial number of environmental pollutants, such as polychlorinated biphenyls, dioxins, polycyclic aromatic hydrocarbons, phthalates, bisphenol A, pesticides, alkylphenols and heavy metals (arsenic, cadmium, lead, mercury), have been shown to disrupt endocrine function. These compounds can cause reproductive problems by decreasing sperm count and quality, increasing the number of testicular germ cells and causing male breast cancer, cryptorchidism, hypospadias, miscarriages, endometriosis, impaired fertility, irregularities of the menstrual cycle, and infertility. Although EDCs may be released into the environment in different ways, the main sources is industrial waste water. The present paper critically reviews the current knowledge of the impact of EDCs on reproductive disorders in humans.