Kerr-Enhanced Optical Spring.

We propose and experimentally demonstrate the generation of enhanced optical springs using the optical Kerr effect. A nonlinear optical crystal is inserted into a Fabry-Perot cavity with a movable mirror, and a chain of second-order nonlinear optical effects in the phase-mismatched condition induces the Kerr effect. The optical spring constant is enhanced by a factor of 1.6±0.1 over linear theory. To our knowledge, this is the first realization of optomechanical coupling enhancement using a nonlinear optical effect, which has been theoretically investigated to overcome the performance limitations of linear optomechanical systems. The tunable nonlinearity of demonstrated system has a wide range of potential applications, from observing gravitational waves emitted by binary neutron star postmerger remnants to cooling macroscopic oscillators to their quantum ground state.

Photothermal effect in macroscopic optomechanical systems with an intracavity nonlinear optical crystal.

Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of optomechanical coupling due to the presence of a nonlinear optical crystal in an optical cavity. We propose a novel method to predict the influence of the photothermal effect by measuring the susceptibility of the optomechanical oscillator and identifying the net optical spring constant and photothermal absorption rate. Using this method, we succeeded in precisely estimating parameters related to even minor photothermal effects, which could not be measured using a previously developed method.

Compact integrated optical sensors and electromagnetic actuators for vibration isolation systems in the gravitational-wave detector KAGRA.

This paper reports on the design and characteristics of a compact module integrating an optical displacement sensor and an electromagnetic actuator for use with vibration-isolation systems installed in KAGRA, the 3-km baseline gravitational-wave detector in Japan. In the technical concept, the module belongs to a family tree of similar modules used in other interferometric gravitational-wave detector projects. After the initial test run of KAGRA in 2016, the sensor part, which is a type of slot sensor, was modified by increasing the spacing of the slot from 5 mm to 15 mm to avoid the risk of mechanical interference with the sensor flag. We confirm that the sensor performance is comparable to that of the previous design despite the modification. We also confirm that the sensor noise is consistent with the theoretical noise budget. The noise level is 0.5 nm/Hz1/2 at 1 Hz and 0.1 nm/Hz1/2 at 10 Hz, and the linear range of the sensor is 0.7 mm or more. We measured the response of the actuator to be 1 N/A and also measured the resistances and inductances of coils of the actuators to confirm consistency with theory. Coupling coefficients among the different degrees of freedom were also measured and shown to be negligible, varying little between designs. A potential concern about thermal noise contribution due to eddy current loss is discussed. As of 2020, 42 of the modules are in operation at the site.

Demonstration of Displacement Sensing of a mg-Scale Pendulum for mm- and mg-Scale Gravity Measurements.

Gravity generated by large masses has been observed using a variety of probes from atomic interferometers to torsional balances. However, gravitational coupling between small masses has never been observed so far. Here, we demonstrate sensitive displacement sensing of the Brownian motion of an optically trapped 7 mg pendulum motion whose natural quality factor is increased to 10^{8} through dissipation dilution. The sensitivity for an integration time of one second corresponds to the displacement generated in a millimeter-scale gravitational experiment between the probe and a 100 mg source mass, whose position is modulated at the pendulum mechanical resonant frequency. Development of such a sensitive displacement sensor using a milligram-scale device will pave the way for a new class of experiments where gravitational coupling between small masses in quantum regimes can be achieved.

Selenite reduction by the thioredoxin system: kinetics and identification of protein-bound selenide.

Selenite (SeO(3)(2-)) assimilation into a bacterial selenoprotein depends on thioredoxin (trx) reductase in Esherichia coli, but the molecular mechanism has not been elucidated. The mineral-oil overlay method made it possible to carry out anaerobic enzyme assay, which demonstrated an initial lag-phase followed by time-dependent steady NADPH consumption with a positive cooperativity toward selenite and trx. SDS-PAGE/autoradiography using (75)Se-labeled selenite as substrate revealed the formation of trx-bound selenium in the reaction mixture. The protein-bound selenium has metabolic significance in being stabilized in the divalent state, and it also produced the selenopersulfide (-S-SeH) form by the catalysis of E. coli trx reductase (TrxB).