RESUMO
BACKGROUND: Due to high stiffness, metal fixation plates are prone to stress shielding of the peri-prosthetic bones, leading to bone loss. Therefore, it has become important to design implants with reduced rigidity but increased load-carrying capacity. Considering the uncertainties in the parameters affecting the implant-bone structure is critical in making more reliable implant designs. In this study, a Response Surface Method based Reliability-based Topology Optimization approach was proposed to design a fixation plate for humerus fracture having less stiffness than the conventional plate. METHODS: The design of the fixation plate was described as an Reliability-based Topology Optimization problem in which the probabilistic constraint was replaced with a meta-model generated using the Kriging method. The artificial humerus bone model was scanned, and the 3D simulation model was used in the finite element analysis required in the solution. The optimum plate was manufactured using Selective Laser Melting. Both designs were experimentally compared in terms of rigidity. FINDINGS: The volume of the conventional plate was reduced from 2512.5 mm3 to 1667.3 mm3; nevertheless, the optimum plate had almost one-third less rigidity than the conventional plate. The probability of failure of the conventional plate was computed as 0.994. However, this value was almost half for the optimum fixation plate. Interpretation The studies showed that the new fixation plate design was less rigid but more reliable than the conventional one. The computation time required to have the optimum plate was reduced by one-tenth by applying the Response Surface Method for the Reliability-based Topology Optimization problem.
Assuntos
Placas Ósseas , Fixação Interna de Fraturas , Fenômenos Biomecânicos , Análise de Elementos Finitos , Fixação Interna de Fraturas/métodos , Humanos , Úmero/cirurgia , Reprodutibilidade dos Testes , Estresse MecânicoRESUMO
In order to prevent failure as well as ensure comfort, patient-specific modelling for prostheses has been gaining interest. However, deterministic analyses have been widely used in the design process without considering any variation/uncertainties related to the design parameters of such prostheses. Therefore, this study aims to compare the performance of patient-specific anatomic Total Knee Arthroplasty (TKA) with off-the-shelf TKA. In the patient-specific model, the femoral condyle curves were considered in the femoral component's inner and outer surface design. The tibial component was designed to completely cover the tibia cutting surface. In vitro experiments were conducted to compare these two models in terms of loosening of the components. A probabilistic approach based on the finite element method was also used to compute the probability of failure of both models. According to the deterministic analysis results, 103.10 and 21.67 MPa von Mises stress values were obtained for the femoral component and cement in the anatomical model, while these values were 175.86 and 25.76 MPa, respectively, for the conventional model. In order to predict loosening damage due to local osteolysis or stress shield, it was determined that the deformation values in the examined cement structures were 15% lower in the anatomical model. According to probabilistic analysis results, it was observed that the probability of encountering an extreme value for the anatomical model is far less than that of the conventional model. This indicates that the anatomical model is safer than the conventional model, considering the failure scenarios in this study.