Rise and fall of sea ice production in the Arctic Ocean's ice factories.

The volume, extent and age of Arctic sea ice is in decline, yet winter sea ice production appears to have been increasing, despite Arctic warming being most intense during winter. Previous work suggests that further warming will at some point lead to a decline in ice production, however a consistent explanation of both rise and fall is hitherto missing. Here, we investigate these driving factors through a simple linear model for ice production. We focus on the Kara and Laptev seas-sometimes referred to as Arctic "ice factories" for their outsized role in ice production, and train the model on internal variability across the Community Earth System Model's Large Ensemble (CESM-LE). The linear model is highly skilful at explaining internal variability and can also explain the forced rise-then-fall of ice production, providing insight into the competing drivers of change. We apply our linear model to the same climate variables from observation-based data; the resulting estimate of ice production over recent decades suggests that, just as in CESM-LE, we are currently passing the peak of ice production in the Kara and Laptev seas.

A rate-based transcutaneous CO2 sensor for noninvasive respiration monitoring.

The pain and risk of infection associated with invasive blood sampling for blood gas measurements necessitate the search for reliable noninvasive techniques. In this work we developed a novel rate-based noninvasive method for a safe and fast assessment of respiratory status. A small sampler was built to collect the gases diffusing out of the skin. It was connected to a CO2 sensor through gas-impermeable tubing. During a measurement, the CO2 initially present in the sampler was first removed by purging it with nitrogen. The gases in the system were then recirculated between the sampler and the CO2 sensor, and the CO2 diffusion rate into the sampler was measured. Because the measurement is based on the initial transcutaneous diffusion rate, reaching mass transfer equilibrium and heating the skin is no longer required, thus, making it much faster and safer than traditional method. A series of designed experiments were performed to analyze the effect of the measurement parameters such as sampler size, measurement location, subject positions, and movement. After the factor analysis tests, the prototype was sent to a level IV NICU for clinical trial. The results show that the measured initial rate of increase in CO2 partial pressure is linearly correlated with the corresponding arterial blood gas measurements. The new approach can be used as a trending tool, making frequent blood sampling unnecessary for respiratory status monitoring.

High Resolution Non-contact Fluorescence Based Temperature Sensor for Neonatal Care.

To date, thermistors are used to continuously monitor the body temperature of newborn babies in the neonatal intensive care unit. The thermistor probe is attached to the body with a strong adhesive tape to ensure that the probe stays in place. However, these strong adhesives are shown to increase microbial growth and cause serious skin injuries via epidermal stripping. The latter compromises the skin's ability to serve as a protective barrier leading to increase in water loss and further microbial infections. In this article a new approach is introduced that eliminates the need for an adhesive. Instead, two kinds of fluorophores are entrapped in a skin friendly chitosan gel that can be easily wiped on and off of the skin, and has antimicrobial properties as well. A CCD camera is used to detect the temperature dependent fluorescence of the fluorophore, tris(1,10-phenthroline)ruthenium(II) while 8-aminopyrene-1,3,6-trisulfonic acid serves as the reference. This temperature sensor was found to have a resolution of at least 0.13°C.

In vitro cell culture pO2 is significantly different from incubator pO2.

Continuous noninvasive monitoring of peri-cellular liquid phase pO2 in adherent cultures is described. For neurons and astrocytes, this approach demonstrates that there is a significant difference between predicted and observed liquid phase pO2. Particularly at low gas phase pO2s, cell metabolism shifts liquid phase pO2 significantly lower than would be predicted from the O2 gas/air equilibrium coefficient, indicating that the cellular oxygen uptake rate exceeds the oxygen diffusion rate. The results demonstrate the need for direct pO2 measurements at the peri-cellular level, and question the widely adopted current practice of relying on setting the incubator gas phase level as means of controlling pericellular oxygen tension, particularly in static culture systems that are oxygen mass transfer limited.

Low-cost microbioreactor for high-throughput bioprocessing.

The design of a microbioreactor is described. An optical sensing system was used for continuous measurements of pH, dissolved oxygen, and optical density in a 2 mL working volume. The K(L)a of the microbioreactor was evaluated under different conditions. An Escherichia coli fermentation in both the microbioreactor and a standard 1 L bioreactor showed similar pH, dissolved oxygen, and optical density profiles.%The low cost of the microbioreactor, detection system, and the small volume of the fermentation broth provide a basis for development of a multiple-bioreactor system for high-throughput bioprocess optimization.

All solid-state GFP sensor.

An all-solid-state green fluorescent protein (GFP) sensor for GFP measurement was developed. It is immune to interference from ambient light and works with standard flow-through cuvettes. The sensor is practically insensitive to the scattered excitation light encountered in microbial suspensions. It has a range of 0.0002-1 g/L (7.4 x 10(-9) - 3.7 x 10(-5) M) with limit of detection 0.00019 g/L (7.0 x 10(-9) M). The sensor could be used with a UV or blue light emitting diode (LED) as a light source, depending on required sensitivity, selectivity, and background levels. Its very low cost makes it useful in a variety of applications. This article describes the construction and validation of the sensor both off- and on-line in fermentation processes.

Ratiometric oxygen sensing: detection of dual-emission ratio through a single emission filter.

A new method and device for the ratiometric measurement of oxygen concentration are presented. They are based on the use of a dual-emission oxygen-sensitive dye. The method allows the exclusion of the influence of emission overlap. The detection of the dual-emission ratio is performed using a single long-pass emission filter. The device described is simpler than the widely used lifetime instruments and could easily be a stand-alone low-cost instrument.