WITHDRAWN: Selective spectrophotometric determination of cobalt(II) in various environmental samples with 2-(chromen-2'-onyl)-5(4''-chlorophenyl)1,3,4-oxadiazole.

The present work describes a selective, rapid and economical spectrophotometric method for the determination of cobalt(II) in various environmental samples. The method is based on the formation of pink colored complex of a stoichiometric ratio 1:2 between cobalt(II) and 2-(chromen-2'-onyl)-5-(4''-chlorophenyl)1,3,4-oxadiazole at pH 6.0+/-0.2. The absorbance of the complex was measured spectrophotometrically at 542nm. Under the optical conditions, Beer's law was obeyed over the range of 0.5-14mugml(-1). The molar absorptivity and Sandell's sensitivity were 1.348x10(4)lmol(-1)cm(-1) and 0.004115mugcm(-2), respectively. The detailed study of various interferences made the method more selective. The method was successfully applied to the determination of cobalt(II) in various environmental samples. The performance of proposed method was evaluated in terms of Student's t-test and variance ratio f-test which indicates the significance of proposed method over reported method. Recoveries obtained revealed that the proposed procedure shows good accuracy at 98% confidence level.

Solid phase extraction method for the determination of lead, nickel, copper and manganese by flame atomic absorption spectrometry using sodium bispiperdine-1,1'-carbotetrathioate (Na-BPCTT) in water samples.

A novel column solid phase extraction procedure was developed for the determination of lead, nickel, copper and manganese in various water samples by flame atomic absorption spectrometry (FAAS) after preconcentration on sodium bispiperdine-1,1'-carbotetrathioate (Na-BPCTT) supported by Amberlite XAD-7. The sorbed element was subsequently eluted with 1M nitric acid and the acid eluates are analysed by Flame atomic absorption spectrometry (FAAS). Various parameters such as pH, amount of adsorbent, eluent type and volume, flow-rate of the sample solution, volume of the sample solution and matrix interference effect on the retention of the metal ions have been studied. The optimum pH for the sorption of above mentioned metal ions was about 6.0+/-0.2. The loading capacity of adsorbent for Pb, Cu, Ni and Mn were found to 28, 26, 22 and 20x10(-6) g/mL, respectively. The recoveries of lead, copper, nickel and manganese under optimum conditions were found to be 96.7-99.2 at the 95% confident level. The limit of detection was 3.0, 3.2, 2.8 and 3.6x10(-6) g/mL for lead, copper, nickel and manganese, respectively by applying a preconcentration factor 50. The proposed enrichment method was applied for metal ions in various water samples. The results were obtained are good agreement with reported method.

Novel analytical reagent for the application of cloud-point preconcentration and flame atomic absorption spectrometric determination of nickel in natural water samples.

Cloud-point extraction was applied as a preconcentration of nickel after formation of complex with newly synthesized N-quino[8,7-b]azin-5-yl-2,3,5,6,8,9,11,12octahydrobenzo[b][1,4,7,10,13]pentaoxacyclopentadecin-15-yl-methanimine, and later determined by flame atomic absorption spectrometry (FAAS) using octyl phenoxy polyethoxy ethanol (Triton X-114) as surfactant. Nickel was complexed with N-quino[8,7-b]azin-5-yl-2,3,5,6,8,9,11,12octahydrobenzo[b][1,4,7,10,13]pentaoxacyclopentadecin-15-yl-methanimine in an aqueous phase and was kept for 15 min in a thermo-stated bath at 40 degrees C. Separation of the two phases was accomplished by centrifugation for 15 min at 4000 rpm. The chemical variables affecting the cloud-point extraction were evaluated, optimized and successfully applied to the nickel determination in various water samples. Under the optimized conditions, the preconcentration system of 100 ml sample permitted an enhancement factor of 50-fold. The detailed study of various interferences made the method more selective. The detection limits obtained under optimal condition was 0.042 ngml(-1). The extraction efficiency was investigated at different nickel concentrations (20-80 ngml(-1)) and good recoveries (99.05-99.93%) were obtained using present method. The proposed method has been applied successfully for the determination of nickel in various water samples and compared with reported method in terms of Student's t-test and variance ratio f-test which indicate the significance of present method over reported and spectrophotometric methods at 95% confidence level.