Method and equipment for estimation activity nuclides in samples of finite dimensions.

This study presents a method of measuring the activity of a specific radionuclide 234mPa in samples placed in bulk transport containers under changing background conditions. The method makes it possible to measure specific activity of 234 mPa in objects without the need for sampling. The change in the effective sample volume limited by the surfaces of the containers is considered depending on the density of the measured material and the energy of gamma radiation of the radionuclide. The high sensitivity of scintillation detector, supplemented by adequate Monte Carlo simulation, allows spectrum measurements to be taken in a short time (less than an hour) with subsequent determination of specific activity. A comparison of measurement results and calculation of 234mPa activity in samples with different densities and compositions using the proposed algorithm, and those obtained by an HPGe spectrometer, demonstrated the high efficiency of the proposed solution.

In situ measurement of radioactive contamination of bottom sediments.

A gamma spectrometric method is presented for in situ radiation monitoring of bottom sediments with contaminated layer of unknown thickness to be determined. The method, based on the processing of experimental spectra using the results of their simulation by the Monte Carlo method, is proposed and tested in practice. A model for the transport of gamma radiation from deposited radionuclides 137Cs and 134Cs to a scintillation detection unit located on the upper surface of the contaminated layer of sediments is considered. The relationship between the effective radius of the contaminated site and the thickness of the layer has been studied. The thickness of the contaminated layer is determined by special analysis of experimental and thickness-dependent simulated spectra. The technique and algorithm developed are verified as a result of full-scale studies performed with the submersible gamma-spectrometer.

Monte Carlo modeling of beta-radiometer device used to measure milk contaminated as a result of the Chernobyl accident.

This paper presents results of Monte Carlo modeling of the beta-radiometer device with Geiger-Mueller detector used in Belarus and Russia to measure the radioactive contamination of milk after the Chernobyl accident. This type of detector, which is not energy selective, measured the total beta-activity of the radionuclide mix. A mathematical model of the beta-radiometer device, namely DP-100, was developed, and the calibration factors for the different radionuclides that might contribute to the milk contamination were calculated. The estimated calibration factors for (131)I, (137)Cs, (134)Cs, (90)Sr, (144)Ce, and (106)Ru reasonably agree with calibration factors determined experimentally. The calculated calibration factors for (132)Te, (132)I, (133)I, (136)Cs, (89)Sr, (103)Ru, (140)Ba, (140)La, and (141)Ce had not been previously determined experimentally. The obtained results allow to derive the activity of specific radionuclides, in particular (131)I, from the results of the total beta-activity measurements in milk. Results of this study are important for the purposes of retrospective dosimetry that uses measurements of radioactivity in environmental samples performed with beta-radiometer devices.