Apical aortic blood pump preclinical assessment for long­term use: durability test and stator topology to reduce wear in the bearing system

This study presents an assessment for long­term use of the apical aortic blood pump (AABP), focusing on wear reduction in the bearing system. AABP is a centrifugal left ventricle assist device initially developed for bridge to transplant application. To analyze AABP performance in long­term applications, a durability test was performed. This test indicated that wear in the lower bearing pivot causes device failure in long­term. A wear test in the bearing system was conducted to demonstrate the correlation of the load in the bearing system with wear. Results from the wear test showed a direct correlation between load and wear at the lower bearing pivot. In order to reduce load, thus reducing wear, a new stator topology has been proposed. In this topology, a radial stator would replace the axial stator previously used. Another durability test with the new stator has accounted twice the time without failure when compared with the original model.

Development of a prototype anti-pollution filter for volatile anesthetics

Introduction: The use of volatile agents during cardiopulmonary bypass allows a "single drug anesthesia" and is associated with reduced peak postoperative troponin levels. Connecting the exhaust systems to the oxygenator's gas outlet port is mandatory and allows to prevent operating room (but not atmospheric) pollution by volatile agents. The aim of this study was to create a prototype filter for volatile agents and to test its adsorption efficacy during an ex-vivo simulated conventional cardiopulmonary bypass test. Methods: We carried out bench tests to conceive a prototype filter that could prevent room and environment pollution without damaging membrane oxygenators. We performed the tests at the Engineering Center for Circulatory Assistance Laboratory, Dante Pazzanese Institute of Cardiology, São Paulo, Brazil. Bench tests included simulation of integral adsorption tests, filter dimensions and design, flow versus pressure curve, sizing, and tightness. Results: Calgon AT 410 was the best kind of activated charcoal granules for adsorption of sevoflurane, isoflurane, and desflurane. Filter dimension tests showed that a chamber of 30-cm width over 10-cm diameter filled with 200g of the Calgon AT410 granules was the minimum required to fully adsorb sevoflurane for 90min. Adsorption tests showed that the prototype filter fully adsorbed isoflurane in 100±2.3min, sevoflurane in 95±3.4min, and desflurane in 95±4.3min. Conclusion: The new version of our prototype filter adsorbed most of the volatile anesthetics agents during an ex-vivo simulated conventional cardiopulmonary bypass test.

Development of a prototype anti-pollution filter for volatile anesthetics.

INTRODUCTION: The use of volatile agents during cardiopulmonary bypass allows a "single drug anesthesia" and is associated with reduced peak postoperative troponin levels. Connecting the exhaust systems to the oxygenator's gas outlet port is mandatory and allows to prevent operating room (but not atmospheric) pollution by volatile agents. The aim of this study was to create a prototype filter for volatile agents and to test its adsorption efficacy during an ex-vivo simulated conventional cardiopulmonary bypass test. METHODS: We carried out bench tests to conceive a prototype filter that could prevent room and environment pollution without damaging membrane oxygenators. We performed the tests at the Engineering Center for Circulatory Assistance Laboratory, Dante Pazzanese Institute of Cardiology, São Paulo, Brazil. Bench tests included simulation of integral adsorption tests, filter dimensions and design, flow versus pressure curve, sizing, and tightness. RESULTS: Calgon AT 410 was the best kind of activated charcoal granules for adsorption of sevoflurane, isoflurane, and desflurane. Filter dimension tests showed that a chamber of 30-cm width over 10-cm diameter filled with 200 g of the Calgon AT410 granules was the minimum required to fully adsorb sevoflurane for 90 min. Adsorption tests showed that the prototype filter fully adsorbed isoflurane in 100 ± 2.3 min, sevoflurane in 95 ± 3.4 min, and desflurane in 95 ± 4.3 min. CONCLUSION: The new version of our prototype filter adsorbed most of the volatile anesthetics agents during an ex-vivo simulated conventional cardiopulmonary bypass test.

Apical aortic blood pump preclinical assessment for long-term use: Durability test and stator topology to reduce wear in the bearing system.

This study presents an assessment for long-term use of the apical aortic blood pump (AABP), focusing on wear reduction in the bearing system. AABP is a centrifugal left ventricle assist device initially developed for bridge to transplant application. To analyze AABP performance in long-term applications, a durability test was performed. This test indicated that wear in the lower bearing pivot causes device failure in long-term. A wear test in the bearing system was conducted to demonstrate the correlation of the load in the bearing system with wear. Results from the wear test showed a direct correlation between load and wear at the lower bearing pivot. In order to reduce load, thus reducing wear, a new stator topology has been proposed. In this topology, a radial stator would replace the axial stator previously used. Another durability test with the new stator has accounted twice the time without failure when compared with the original model.

Efeitos imediatos do eletrocautério endovascular em varizes de membros inferiores / Immediate effects of endovascular electrocauterization in lower limb varicose veins

OBJETIVOS: Determinar a importância das variáveis: Intensidade de Energia (I), Potência (P) e Tempo de Aplicação (T) nas alterações histológicas ocorridas em varizes de membros inferiores submetidas à eletrocauterização endovascular. MÉTODO: Estudo prospectivo experimental realizado em pacientes submetidos à eletrocauterização endovenosa de fragmento proximal da veia safena magna, de acordo com uma tabela de aleatorização - GI: I=0J, P=0W, T=15s; GII: I=300J, P=60W, T=5s; GIII: I=600J, P=60W, T=10s; GIV: I=900J, P=60W, T=15s; GV: I=450J, P=90W, T=5s; GVI: I=900J, P=90W, T=10s; GVII: I=1350J, P=90W, T=15s; GVIII: I=600J, P=120W, T=5s; GIX: I=1200J, P=120W, T=10s; GX: I=1800J, P=120W, T=15s. Os fragmentos foram submetidos a estudo anatomopatológico com o objetivo de analisar a profundidade das alterações tissulares, assim classificadas: Grupo A - endotélio e média, Grupo B - endotélio, média e adventícia. RESULTADOS: A intensidade das alterações histológicas - Grupo A e B - ocorridas nos fragmentos foram proporcionais à Intensidade de Energia de eletrocauterização (p=0,0001). Essa associação linear também pode ser verificada para as variáveis Potência (p=0,017) e Tempo de Aplicação (p=0,0001). O índice de correlação de Spearman foi maior para variável Tempo de Aplicação: 0,42269 (p=0,002) quando comparada com a variável Potência de Energia: 0,3542 (p=0,005). CONCLUSÃO: O Tempo de Aplicação de Energia é mais importante do que a Potência de Energia utilizada para uma mesma energia de eletrocauterização, na determinação da profundidade dos efeitos histológicos observados na parede das varizes de membros inferiores.

OBJECTIVE: To determine the importance of the variables: Energy Intensity (I), Power (P) and Time of Application (T) in the histological changes occurring in lower limb varicose vein submitted to endovascular electrocauterization. METHOD: Prospective experimental study conducted in patients undergoing great saphenous vein electrocauterization according to a randomization table - GI: I=0J, P=0W, T=15s; GII: I=300J, P=60W, T=5s; GIII: I=600, P=60W, T=10s; GIV: I=900J, P=60W, T=15s; GV: I=450J, P=90W, T=5s; GVI: I=900J, P=90W, T=10s; GVII: I=1350W, P=90W, T=15s; GVIII: I=600, P=120W, T=5s; GIX: I=1200J, P=120W, T=10s; GX: I=1800J, P=120W, T=15s. The fragments were submitted to histopathological examination in order to analyze the depth of tissue changes, classified as follows: Group A - endothelium and media; Group B - endothelium, media and adventitia. RESULTS: The intensity of histological changes - Groups A and B - that occur in the fragments were proportional to Energy Intensity of electrocauterization (p=0.0001), Power (p=0.017) and Time of Application (p=0.0001). The Spearman correlation coefficient was more powerful for the variable Time of Application: 0.42269 (p=0.002) when compared with the variable Power of Energy (P): 0.3542 (p=0.005). CONCLUSION: Time of Application of Energy is a stronger predictor than the Power of Energy in determining the depth of the histological effects observed in the wall of the varicose vein submitted to electrocauterization.