Femtosecond laser upgrading the quality of bismuth films to enhance ultra-broadband photodetection.

Topological insulator bismuth has attracted considerable attention for the fabrication of room-temperature, wide bandwidth, and high-performance photodetectors due to the gapless edge state and insulating bulk state properties. However, both the photoelectric conversion and carrier transportation of the bismuth films are extremely affected by the surface morphology and grain boundaries to limit optoelectronic properties further. Here, we demonstrate a strategy of femtosecond laser treatment for upgrading the quality of bismuth films. After the treatment with proper laser parameters, the measurement of average surface roughness can be reduced from Ra = 44 nm to 6.9 nm, especially with accompany of the evident grain boundary elimination. Consequently, the photoresponsivity of the bismuth films increases approximately 2 times within an ultra-broad spectrum range from the visible to mid-infrared. This investigation suggests that the femtosecond laser treatment can help to benefit the performance of topological insulator ultra-broadband photodetectors.

Bio-based phytic acid@polyurushiol­titanium complex coated cotton fabrics with durable flame retardancy for oil-water separation.

Bio-based hydrophobic coating modified cotton fabrics with durable flame retardancy are of high interest in the application of oil-water separation for not only avoiding the use of hazardous substances but also improving the fire safety during use. Herein, phytic acid@Polyurushiol­titanium complex coated cotton fabric was developed using the facile dip-coating method involving the sequential immersion in the solution of poly(ethyleneimine), phytic acid, titanium oxide, and urushiol. The underlying coating accommodated abundance of phytic acid, which imparted excellent flame retardancy to cotton fabric, and the top coating composed of the polyurushiol­titanium complex endowed cotton fabric with high hydrophobicity that the water contact angle (WCA) was up to 149.8°. The hydrophobicity also guaranteed effective protection of the underlying phytic acid against chemical solvents and abrasion. Besides, the hydrophobic coating allowed cotton fabric for good self-cleaning and effective oil-water separation. Therefore, the preparation of phytic acid@polyurushiol­titanium complex coated cotton fabric offers a promising approach to construct durable biomass-coated cellulose-based fabric with multifunctionality.

Measurement of Optical Properties of CH3NH3PbX3 (X = Br, I) Single Crystals Using Terahertz Time-Domain Spectroscopy.

Organometallic lead bromide and iodide perovskite single crystals (PSCs) are potential candidates for terahertz applications. Herein, we performed terahertz time-domain spectroscopy (THz-TDS) in the frequency range of 0.1-3.0 THz on different thicknesses of MAPbBr3 (0.3, 0.6, and 0.8 mm) and MAPbI3 (0.6, 0.8, 0.9, 1.3, and 2.3 mm). The measurements were carried out with respect to the position (along the focal area), azimuthal rotation of the PSCs, and incidence angles of the reference THz pulse on the PSCs' surface. Based on the transmitted THz pulses from PSCs from the above measurements, we calculated the real and imaginary parts of the refractive index, dielectric constants, absorption coefficients, and dark conductivity. These optical parameters tend to increase with decreases in the PSCs' thicknesses. The transmission spectra of the terahertz electric field indicate that the measured optical properties do not vary significantly with the position and orientation of PSCs. The real parts of the refractive index and dielectric constants are higher than the imaginary values for both PSCs. On the other hand, a slight blueshift in the optical phonon vibrations corresponding to Pb-Br/I-Pb and Pb-Br/I bonds is observed with an increase in thickness. Interestingly, the phonon vibrations do not vary with the incidence angle of the THz pulses on the same crystal's surface. The optical parameters based on THz-TDS reveal that the PSCs satisfy the requirement for tunable THz devices which need suitable, sensitive, and stable absorption properties between 0.1 and 3 THz.

Long-Time Persisting Superhydrophilicity on Sapphire Surface via Femtosecond Laser Processing with the Varnish of TiO2.

The acquiring of superhydrophilic surfaces attracts the strong interest in self-cleaning, anti-fogging and anti-icing fields based on the unique features. However, the persistent time of superhydrophilic surfaces is still facing a big challenge because of easily adsorbing hydrophobic groups. Here, we propose a strategy to achieve a superhydrophilicity persisting for an unprecedently long time on sapphire surfaces, by compounding the femtosecond laser-induced hierarchical structures and the subsequent varnish of TiO2. The superhydrophilic effect (with a contact angle of CA = 0°) created by our method can be well prolonged to at least 180 days, even for its storage in air without additional illumination of UV lights. Based on comprehensive investigations, we attribute the underlying mechanisms to the coordination of laser-induced metal ions on the material surface via TiO2 doping, which not only prevents the adsorption of the nonpolar hydrocarbon groups, but also modulates the photo-response properties of TiO2. In addition, further experiments demonstrate the excellent anti-fogging properties of our prepared samples. This investigation provides a new perspective for further enhancing the durability of superhydrophilicity surfaces.

Metal Ion-Catalyzed Low-Temperature Curing of Urushiol-Based Polybenzoxazine.

In this work, urushiol-based polybenzoxazine is cured by the Lewis acid (FeCl3, AlCl3, and CuCl2) at low temperature instead of high thermal curing temperature. The effect of the Lewis acid on structures and properties of the polymers is revealed. The relating urushiol-based benzoxazine monomer (BZ) was synthesized by natural urushiol, formaldehyde, and n-octylamine. The monomer was reacted with the Lewis acid with a molar ratio of 6:1 (Nmonomer: NMetal) at 80°C to obtain films that can be cured at room temperature. The chemical structures of benzoxazine monomers were identified by Fourier-transform infrared spectroscopy (FTIR) and 1H nuclear magnetic resonance spectroscopy (1H-NMR). The interaction between the metal ion and the polymers is revealed by X-ray photoelectron spectroscopy (XPS) and attenuated total reflectance-FTIR (ATR-FTIR). The effect of the Lewis acid on the mechanical properties, wettability, and thermal stability was investigated. The results show that the benzoxazine cured by Cu2+ has a better performance than that cured by Al3+ and Fe3+.

Facile construction of lamellar-like phosphorus-based triazole-zinc complex for high-performance epoxy resins.

Epoxy resins (EP) possessing superior flame retardancy, mechanical properties and glass transition temperature are urgently needed to meet the ever-increasing requirement of high performance for the practical application of EP. Herein, lamellar-like phosphorus-based triazole-zinc complex (Zn-PT) was firstly constructed through coordination reaction in a facile condition to address the above issue. The results revealed that Zn-PT was well dispersed in epoxy matrix, and with 3 wt% Zn-PT, the tensile strength, flexural strength and modulus of epoxy composites were remarkably increased from 71, 112 and 2982 MPa of neat epoxy resin (EP) to 80, 162 and 3482 MPa respectively. The glass transition temperature was higher than EP. Besides, the limiting oxygen index (LOI) increased to 28.3%, and UL-94V-1 level was available. Meanwhile, the cone calorimeter test (CCT) results showed that epoxy composites displayed less heat release and smoke production. Generally, this work provides a feasible strategy to prepare high-performance epoxy composites, which has the potential to satisfy the requirement of epoxy in the practical application.

From herbicide to flame retardant: The lamellar-like phosphorus-bridged amitrole toward high fire safety epoxy resin with light smoke and low toxicity.

In an attempt to alleviate the harmful impact of the flammability of epoxy resin on the environment, amitrole, a herbicide, has been converted to a novel flame retardant (PBA) with lamellar morphology through organophosphorus modification. This material has been utilized to fabricate fire safe epoxy thermosets (EP). EP containing 7.5 wt% PBA undergoes quick self-extinguishment upon ignition. This blend displays a high limiting oxygen index (LOI) value of 34%. More importantly, hazardous products (heat, smoke, toxic gases including CO/CO2) released during combustion of EP, are strongly suppressed in the presence of PBA. The mechanical properties of EP-PBA blends are comparable to those of virgin EP. The tensile strength of EP containing PBA is 90% of that of unmodified EP. The flexural strength of PBA blends is somewhat greater than that for EP containing no additive. A tactful strategy for the transformation of amitrole, a potential environmental contaminant to a benign flame retardant for polymers has been developed.

Selenium Deficiency in Chickens Induces Intestinal Mucosal Injury by Affecting the Mucosa Morphology, SIgA Secretion, and GSH-Px Activity.

The small intestine is one of the target organs of dietary selenium (Se) deficiency. Our objective was to investigate the effects of Se deficiency on small intestinal mucosa morphology and function in chickens. In the present study, 1-day (d)-old chickens were fed either a commercial diet with 0.15 mg/kg Se (control group) or a Se-deficient diet with 0.016 mg/kg Se (Se-group). The average daily weight gain, Se content in the blood, secretory immunoglobulin A (SIgA) secretion, and glutathione peroxidase (GSH-Px) activity in the small intestine in chickens were examined after 10, 20, 30, and 40 days of feeding. We also observed the morphology of the small intestine and recorded the number of intraepithelial lymphocytes (IELs). The average daily weight gain decreased; the level of Se in the blood decreased significantly; and SIgA secretion and GSH-Px activity in the duodenum, jejunum, and ileum decreased to different degrees. Histological analysis showed that the villus length, crypt depth, mucosal thickness, and number of IELs in the small intestine decreased to different extents in different periods. In the Se-group, longer feeding times were associated with more severe injury to physiological structure and function in the intestinal mucosa in chickens. In conclusion, Se deficiency induced injury of the mucosal immune barrier and physical barrier of the small intestine, and decreased the growth performance and antioxidant capacity in chickens.

Facile one-pot synthesis of silver nanoparticles encapsulated in natural polymeric urushiol for marine antifouling.

Silver nanoparticle-based coatings have been regarded as promising candidates for marine antifouling. However, current toxic fabrication methods also lead to environment risks. Nanoparticle agglomeration, poor compatibility with polymer, and rapid release of Ag+ result in short-term efficacy. In this study, a facile one-pot synthesis method of silver nanoparticles (AgNPs) encapsulated in polymeric urushiol (PUL) was developed. AgNPs were synthesized in situ by natural urushiol, serving as a reductant, dispersant and surfactant. Simultaneously, silver nitrate catalyzed the polymerization of urushiol into PUL. This in situ reduction method made AgNPs uniformly distributed in the polymer matrix. The binding between the AgNPs and the PUL resulted in the stable release of Ag+. Results showed the antibacterial rate of a 0.1% AgNPs coating is 100% in laboratory experiments. This environment-friendly coating showed good microbial inhibition performance with long-term (120 days) marine antifouling efficacy. This study shows the potential of preparing an eco-friendly coating with long-term marine antifouling ability.

Correction: Facile one-pot synthesis of silver nanoparticles encapsulated in natural polymeric urushiol for marine antifouling.

[This corrects the article DOI: 10.1039/D0RA02205E.].

High-Efficiency Fog Collector: Water Unidirectional Transport on Heterogeneous Rough Conical Wires.

An artificial periodic roughness-gradient conical copper wire (PCCW) can be fabricated by inspiration from cactus spines and wet spider silks. PCCW can harvest fog on periodic points of the conical surface from air and transports the drops for a long distance without external force, which is attributed to dynamic as-released energy generated from drop deformation in drop coalescence, in addition to both gradients of geometric curve (inducing Laplace pressure) and periodic roughness (inducing surface energy difference). It is found that the ability of fog collection can be related to various tilt-angle wires, thus a fog collector with an array system of PCCWs is further designed to achieve a continuous process of efficient water collection. As a result, the effect of water collection on PCCWs is better than previous results. These findings are significant to develop and design materials with water collection and water transport for promising application in fogwater systems to ease the water crisis.

[Biodistribution and Postmortem Redistribution of Emamectin Benzoate in Intoxicated Mice].

OBJECTIVE: To investigate the lethal blood level, the target organs and tissues, the toxicant storage depots and the postmortem redistribution in mice died of emamectin benzoate poisoning. METHODS: The mice model of emamectin benzoate poisoning was established via intragastric injection. The main poisoning symptoms and the clinical death times of mice were observed and recorded dynamically in the acute poisoning group as well as the sub-acute poisoning death group. The pathological and histomorphological changes of organs and tissues were observed after poisoning death. The biodistribution and postmortem redistribution of emamectin benzoate in the organs and tissues of mice were assayed by the enzyme-linked immunosorbent assay (ELISA) at 0h, 24h, 48h and 72h after death. The lethal blood concentrations and the concentrations of emamectin benzoate were detected by high performance liquid chromatography (HPLC) at different time points after death. RESULTS: The symptoms of nervous and respiratory system were observed within 15-30 min after intragastric injection. The average time of death was (45.8 ± 7.9) min in the acute poisoning group and (8.0 ± 1.4) d in the sub-acute poisoning group, respectively. The range of acute lethal blood level was 447.164 0-524.463 5 mg/L. The pathological changes of the organs and tissues were observed via light microscope and immunofluorescence microscope. The changes of emamectin benzoate content in the blood, heart, liver, spleen, lung, kidney and brain of poisoning mice showed regularity within 72 h after death (P < 0.05). CONCLUSION: The target organs of emamectin benzoate poisoning include heart, liver, kidney, lung, brain and contact position (stomach). The toxicant storage depots are kidney and liver. There is emamectin benzoate postmortem redistribution in mice.