RESUMO
Devices based on rapid, paper-based, isothermal nucleic acid amplification techniques have recently emerged with the potential to fill a growing need for highly sensitive point-of-care diagnostics throughout the world. As this field develops, such devices will require optimized materials that promote amplification and sample preparation. Herein, we systematically investigated isothermal nucleic acid amplification in materials currently used in rapid diagnostics (cellulose paper, glass fiber, and nitrocellulose) and two additional porous membranes with upstream sample preparation capabilities (polyethersulfone and polycarbonate). We compared amplification efficiency from four separate DNA and RNA targets (Bordetella pertussis, Chlamydia trachomatis, Neisseria gonorrhoeae, and Influenza A H1N1) within these materials using two different isothermal amplification schemes, helicase dependent amplification (tHDA) and loop-mediated isothermal amplification (LAMP), and traditional PCR. We found that the current paper-based diagnostic membranes inhibited nucleic acid amplification when compared to membrane-free controls; however, polyethersulfone allowed for efficient amplification in both LAMP and tHDA reactions. Further, observing the performance of traditional PCR amplification within these membranes was not predicative of their effects on in situ LAMP and tHDA. Polyethersulfone is a new material for paper-based nucleic acid amplification, yet provides an optimal support for rapid molecular diagnostics for point-of-care applications.
Assuntos
Técnicas e Procedimentos Diagnósticos , Técnicas de Amplificação de Ácido Nucleico/métodos , Papel , Sistemas Automatizados de Assistência Junto ao Leito , Polímeros/química , Sulfonas/química , DNA Helicases/metabolismo , DNA Bacteriano/genética , Vírus da Influenza A Subtipo H1N1/genética , Membranas Artificiais , Porosidade , RNA Viral/genéticaRESUMO
A novel whole ceiling upper-room ultraviolet germicidal irradiation (UVGI) system [eggcrate ultraviolet (UV)] has been developed that incorporates open-cell 'eggcrate'-suspended ceiling panels and bare UV lamps with a ceiling fan. Upper-room UVGI is more effective for air disinfection than mechanical ventilation at much lower installation and operating costs. Conventional upper-room UVGI fixtures employ multiple tightly spaced horizontal louvers to confine UV to the upper-room. These louvered fixtures protect occupants in the lower-room from UV-induced eye and skin irritation, but at a major cost to fixture efficiency. Using a lamp and ballast from a conventional upper-room UVGI fixture in the eggcrate UV system, the germicidal efficacy was markedly improved even though the UV radiation emitted by the lamp was unchanged. This fundamental change in the application of upper-room UVGI air disinfection should permit wider, more effective application of UVGI globally to reduce the spread of airborne infection.
Assuntos
Microbiologia do Ar , Desinfecção/instrumentação , Ambiente Controlado , Raios UltravioletaRESUMO
Decades of contradictory results have obscured the exact role of adsorbed fibronectin in the adhesion of the bacterium, Staphylococcus epidermidis, to biomaterials. Here, the ability of adsorbed fibronectin (FN) or bovine serum albumin (BSA) to modulate S. epidermidis adhesion to various biomaterials is reported. FN or BSA was adsorbed in increasing surface densities up to saturated monolayer coverage onto various common biomaterials, including poly(ethylene terephthalate), fluorinated ethylene propylene, poly(ether urethane), silicone, and borosilicate glass. Despite the wide range of surface characteristics represented, adsorption isotherms varied only subtly between materials for the two proteins considered. S. epidermidis adhesion to the various protein-coated biomaterials was quantified in a static-fluid batch adhesion assay. Although slight differences in overall adherent cell numbers were observed between the various protein-coated substrata, all materials exhibited significant dose-dependent decreases in S. epidermidis adhesion with increasing adsorption of either protein (FN, BSA) to all surfaces. Results here indicate that S. epidermidis adhesion to FN-coated surfaces is not a specific adhesion (i.e., receptor: ligand) mediated process, as no significant difference in adhesion was found between FN- and BSA-coated materials. Rather, results indicate that increasing surface density of either FN or BSA actually inhibited S. epidermidis adhesion to all biomaterials examined.