An in vitro comparison of the toxicological profiles of ground tire particles (TP) and actual tire and road wear particles (TRWP) emissions.

There is currently limited data on the potential effects of tire and road wear particles (TRWP) on human health. TRWP include tire fragments, but also road wear materials, dust, adsorbed gaseous pollutants and different types of inclusions that could affect their hazard profiles. Due to their availability and lower complexity, ground tire particles (TP) are often used in toxicological studies. However, this makes it difficult to draw firm conclusions about the potential hazard of actual TRWP. Here, we compared the in vitro toxicological profile of ground TP and actual TRWP emissions of similar size collected from road traffic. For this purpose, TP and TRWP were separately incubated with alveolar macrophages for 24 h, and the cellular response was evaluated in terms of cytotoxicity, proinflammatory response and oxidative stress. Both TP and TRWP induced neither significant cytotoxicity nor oxidative stress, but triggered a concentration-dependent proinflammatory response, as evidenced by increased TNF-α production. The level of TNF-α production was slightly higher with TRWP than with TP, independent of the particle dose. All in all, the pulmonary toxicity of TRWP could be due primarily to the tire tread inclusions and only marginally to other particle components (i.e. road wear materials, dust …). Although these preliminary results need to be confirmed by further analysis, they could be useful for tire manufacturers in the production of safer-by-design tires.

Realistic assessment of tire and road wear particle emissions and their influencing factors on different types of roads.

This study aims to examine tire and road wear particle (TRWP) emissions under realistic conditions in order to provide some valuable insights into understanding their sources and fate in the environment. TRWP emissions were evaluated with a fully instrumented vehicle driving on five representative road types: urban, ring road, suburban, highway, and rural. Multiple vehicle dynamic variables were recorded to assess the factors influencing these emissions. For the first time, emitted particles were collected on filters and analyzed by means of pyrolysis coupled with gas chromatography-mass spectrometry to determine the polymeric content of tires, in specifically quantifying styrene-butadiene rubber (SBR) and butadiene rubber (BR) pyrolytic markers. The measurements obtained from the five road types revealed similar size distributions for SBR + BR emissions, with maxima found in the (ultra)fine fraction (< 0.39 µm). Upon applying an SBR + BR-to-TRWP conversion factor, (ultra)fine fraction TRWP emissions proved to be the highest for suburban (64 ± 5 µg/km), followed by highway, urban, ring road and rural routes. The output represents up to 480 tons of TRWP per year emitted in the EU27, thus suggesting a widely impregnated atmospheric compartment capable of threatening human health. Furthermore, an analysis of variables revealed that acceleration, tire constraints, and constant sustained driving factors had specific impacts on TRWP emissions.

Physical and chemical characteristics of particles emitted by a passenger vehicle at the tire-road contact.

Non-exhaust emissions are now recognized as a significant source of atmospheric particulate matter and the trend towards a reduction of conventionally fueled internal combustion engine vehicles on the road is increasing their contribution to air pollution due to lower exhaust emissions. These particles include brake wear particles (BWP) and tire-road contact particles (TRCP), which are composed of tire wear particles (TWP), road wear particles (RWP) and resuspended road dust (RRD). The goal of this study has therefore been to design an original experimental approach to provide insight into the chemical composition of particles emitted at the tire-road contact, focusing on the micron (PM10-1µm) and submicron (PM1-0.1µm) fractions. Through this characterization, an examination of the different TRCP generated by different materials (tire, road surface, brake system) was conducted. To achieve this, TRCP were collected at the rear of the wheel of an instrumented vehicle during road and track tests, and a SEM-EDX analysis was performed. Our experimental conditions have allowed us to demonstrate that, at the individual particle scale, TRCP are consistently associated with road dust materials and particles solely composed of tire or road materials are practically non-existent. The contribution of BWP to TRCP is marked by the emission of Fe-rich particles, including heavy metals like Ba, Mn and Cr. TWP, which result from rubber abrasion, consist of C-rich particles abundant in Si, Zn, and S. RWP, mainly composed of Al, Si, Fe, and Ca, can be either part of RRD or internally mixed with emitted TWP. The findings of this study highlight the substantial role of RRD to TRCP emissions under real driving conditions. Consequently, it underscores the importance of examining them simultaneously to achieve a more accurate estimation of on-road traffic emissions beyond the vehicle exhaust.