A comparison of speciated atmospheric mercury at an urban center and an upwind rural location.

Gaseous elemental mercury (GEM), particulate mercury (PHg) and reactive gaseous mercury (RGM) were measured every other hour at a rural location in south central Wisconsin (Devil's Lake State Park, WI, USA) between April 2003 and March 2004, and at a predominantly downwind urban site in southeastern Wisconsin (Milwaukee, WI, USA) between June 2004 and May 2005. Annual averages of GEM, PHg, and RGM at the urban site were statistically higher than those measured at the rural site. Pollution roses of GEM and reactive mercury (RM; sum of PHg and RGM) at the rural and urban sites revealed the influences of point source emissions in surrounding counties that were consistent with the US EPA 1999 National Emission Inventory and the 2003-2005 US EPA Toxics Release Inventory. Source-receptor relationships at both sites were studied by quantifying the impacts of point sources on mercury concentrations. Time series of GEM, PHg, and RGM concentrations were sorted into two categories; time periods dominated by impacts from point sources, and time periods dominated by mercury from non-point sources. The analysis revealed average point source contributions to GEM, PHg, and RGM concentration measurements to be significant over the year long studies. At the rural site, contributions to annual average concentrations were: GEM (2%; 0.04 ng m(-3)); and, RM (48%; 5.7 pg m(-3)). At the urban site, contributions to annual average concentrations were: GEM (33%; 0.81 ng m(-3)); and, RM (64%; 13.8 pg m(-3)).

Sources of speciated atmospheric mercury at a residential neighborhood impacted by industrial sources.

Speciated measurements of atmospheric mercury plumes were obtained at an industrially impacted residential area of East St. Louis, IL. These plumes were found to result in extremely high mercury concentrations at ground level that were composed of a wide distribution of mercury species. Ground level concentrations as high as 235 ng m(-3) for elemental mercury (Hg0) and 38 300 pg m(-3) for reactive mercury species (reactive gaseous (RGM) plus particulate (PHg) mercury) were measured. The highest mercury concentrations observed during the study were associated with plumes that contained high concentrations of all mercury species (Hg0, RGM, and PHg) and originated from a source located southwest of the sampling site. Variations in proportions of Hg0/RGM/PHg among plumes, with Hg0 dominating some plumes and RGM and/or PHg dominating others, were attributed to differences in emissions from different sources. Correlations between mercury plumes and elevated NO(x) were not observed; however, a correlation between elevated SO2 and mercury plumes was observed during some but not all plume events. Despite the presence of six coal-fired power plants within 60 km of the study site, wind direction data along with Hg/SO2 and Hg/NO(x) ratios suggest that high-concentration mercury plumes impacting the St. Louis-Midwest Particle Matter Supersite are attributable to local point sources within 5 km of the site.

Synthesis and characterization of metal sulfide clusters for toxicological studies.

Zinc sulfide clusters were synthesized and characterized at low micromolar concentrations to assess the effect of metal-sulfide ligands on metal toxicity to aquatic organisms in oxic environments. Recommended preparation times are greater than 2 h initial reaction of equimolar sodium sulfide and zinc nitrate, followed by oxic aeration for 3 d. Ionic strength, pH, and anoxic stabilization time were found to be relatively unimportant in controlling the final yield. Adsorptive losses of zinc sulfide (ZnS) clusters to surfaces, however, were significant for a variety of vessel materials and membrane filters. Ionic strength and pH were found to be important factors controlling the extent of adsorptive losses with minimal loss for pHs greater than 9 and for soft waters. The Ag(I), Cu(II), and Hg(II) as metal sulfides completely suppress the analysis of sulfide, whereas Pb(II), Mn(II), and Co(II) partially suppress the analysis of sulfide by the methylene blue technique. Ultraviolet and fluorescence spectra are shown for synthesized ZnS clusters.