Tin Oxide Nanoparticles via Solar Vapor Deposition for Hexavalent Chromium Remediation.

Tin oxide nanoparticles optimized to capture low concentrations of hexavalent chromium from water were developed through a facile, scalable, and low-cost one-step solar vapor deposition methodology. Considering the preservation of high electron donation capacity as the key to support the reduction of mobile Cr(VI) into insoluble forms, the growth of SnO nanoparticles was favored by the co-evaporation of SnO2 with Fe powders at various mass ratios. Characterization techniques indicated that the percentage and the stability of SnO is proportional to the Fe content in the target with a requirement of at least 50% wt to inhibit the formation of a passive SnO2 surface layer. The produced particles were evaluated regarding their efficiency to capture Cr(VI) under conditions similar to water treatment for drinking purposes (pH 7). It was revealed that passivation-free SnO nanoparticles deliver significant improvement in the adsorption capacity corresponding to the residual concentration of 25 µg/L, reaching a value of 1.74 mg/g for the sample prepared with 50% wt Fe in the target. The increase of water acidity was found responsible for the activation of more reduction sites on the particle surface, as reflected through the elevation of efficiency by more than 20% at pH 6.

Mapping the Magnetic Coupling of Self-Assembled Fe3O4 Nanocubes by Electron Holography.

The nanoscale magnetic configuration of self-assembled groups of magnetite 40 nm cubic nanoparticles has been investigated by means of electron holography in the transmission electron microscope (TEM). The arrangement of the cubes in the form of chains driven by the alignment of their dipoles of single nanocubes is assessed by the measured in-plane magnetic induction maps, in good agreement with theoretical calculations.

One-Step Route to Iron Oxide Hollow Nanocuboids by Cluster Condensation: Implementation in Water Remediation Technology.

The fabrication procedure of hollow iron oxide nanoparticles with a large surface to volume ratio by a single-step gas condensation process at ambient temperature is presented. Fe clusters formed during the sputtering process are progressively transformed into hollow cuboids with oxide shells by the Kirkendall mechanism at the expense of oxygen captured inside the deposition chamber. TEM and Raman spectroscopy techniques point to magnetite as the main component of the nanocuboids; however, the magnetic behavior exhibited by the samples suggests the presence of FeO as well. In addition, these particles showed strong stability after several months of exposure to ambient conditions, making them of potential interest in diverse technological applications. In particular, these hierarchical hollow particles turned out to be very efficient for both As(III) and As(V) absorption (326 and 190 mg/g, respectively), thus making them of strong interest for drinking water remediation.

Fe3O4@NiFexOy Nanoparticles with Enhanced Electrocatalytic Properties for Oxygen Evolution in Carbonate Electrolyte.

The design and engineering of earth-abundant catalysts that are both cost-effective and highly active for water splitting are crucial challenges in a number of energy conversion and storage technologies. In this direction, herein we report the synthesis of Fe3O4@NiFexOy core-shell nanoheterostructures and the characterization of their electrocatalytic performance toward the oxygen evolution reaction (OER). Such nanoparticles (NPs) were produced by a two-step synthesis procedure involving the colloidal synthesis of Fe3O4 nanocubes with a defective shell and the posterior diffusion of nickel cations within this defective shell. Fe3O4@NiFexOy NPs were subsequently spin-coated over ITO-covered glass and their electrocatalytic activity toward water oxidation in carbonate electrolyte was characterized. Fe3O4@NiFexOy catalysts reached current densities above 1 mA/cm2 with a 410 mV overpotential and Tafel slopes of 48 mV/dec, which is among the best electrocatalytic performances reported in carbonate electrolyte.

Tetravalent manganese feroxyhyte: a novel nanoadsorbent equally selective for As(III) and As(V) removal from drinking water.

The development of a single-phase Fe/Mn oxy-hydroxide (δ-Fe0.76Mn0.24OOH), highly efficient at adsorbing both As(III) and As(V), is reported. Its synthesis involves the coprecipitation of FeSO4 and KMnO4 in a kilogram-scale continuous process, in acidic and strongly oxidizing environments. The produced material was identified as a manganese feroxyhyte in which tetravalent manganese is homogeneously distributed into the crystal unit, whereas a second-order hollow spherical morphology is favored. According to this structuration, the oxy-hydroxide maintains the high adsorption capacity for As(V) of a single Fe oxy-hydroxide combined with enhanced As(III) removal based on the oxidizing mediation of Mn(IV). Ion-exchange between arsenic species and sulfates as well as the strongly positive surface charge further facilitate arsenic adsorption. Batch adsorption tests performed in natural-like water indicate that Mn(IV)-feroxyhyte can remove 11.7 µg As(V)/mg and 6.7 µg As(III)/mg at equilibrium pH 7, before residual concentration overcomes the regulation limit of 10 µg As/L for drinking water. The improved efficiency of this material, its low cost, and the possibility for scaling-up its production to industry indicate the high practical impact and environmental importance of this novel adsorbent.

Learning from nature to improve the heat generation of iron-oxide nanoparticles for magnetic hyperthermia applications.

The performance of magnetic nanoparticles is intimately entwined with their structure, mean size and magnetic anisotropy. Besides, ensembles offer a unique way of engineering the magnetic response by modifying the strength of the dipolar interactions between particles. Here we report on an experimental and theoretical analysis of magnetic hyperthermia, a rapidly developing technique in medical research and oncology. Experimentally, we demonstrate that single-domain cubic iron oxide particles resembling bacterial magnetosomes have superior magnetic heating efficiency compared to spherical particles of similar sizes. Monte Carlo simulations at the atomic level corroborate the larger anisotropy of the cubic particles in comparison with the spherical ones, thus evidencing the beneficial role of surface anisotropy in the improved heating power. Moreover we establish a quantitative link between the particle assembling, the interactions and the heating properties. This knowledge opens new perspectives for improved hyperthermia, an alternative to conventional cancer therapies.

Thermal, dielectrical and mechanical response of α and ß-poly(vinilydene fluoride)/Co-MgO nanocomposites.

Nanocomposites of the self-forming core-shell Co-MgO nanoparticles, which were of approximately 100 nm in diameter, and poly(vinylidene fluoride) (PVDF) polymer have been prepared. When the polymer is crystallized in the α-phase, the introduction of the nanoparticles leads to nucleation of the γ-phase of PVDF, increasing also the melting temperature of the polymer. With the introduction of the Co-MgO particles, the dielectric constant of the material slightly increases and the storage modulus decreases with respect to the values obtained for the pure polymer.

Self-assembled multifunctional Fe/MgO nanospheres for magnetic resonance imaging and hyperthermia.

A one-step process for the production of nanoparticles presenting advanced magnetic properties can be achieved using vapor condensation. In this article, we report on the fabrication of Fe particles covered by a uniform MgO epitaxial shell. MgO has a lower surface energy than Fe, which results in a core-shell crystal formation. The particles satisfy a few of technical requirements for the practical use in real clinics, such as a high biocompatibility in living cells in-vitro, an injection through blood vessels without any clothing problems in murine model, a high absorption rate for magnetic hyperthermia at small particle concentration, and the potential to be used as contrast agent in the field of diagnostic magnetic imaging. They are also able to be used in drug delivery and magnetic-activated cell sorting. FROM THE CLINICAL EDITOR: In this paper, the authors report on the synthesis of Fe particles covered by a uniform MgO epitaxial shell resulting in a core-shell crystal formation. The particles are proven to be useful as contrast agents for magnetic resonance imaging and have the potential to be useful as heating mediators for cancer therapy through hyperthermia. They also might be used in drug delivery and magnetic-activated cell sorting.