A fast and accurate radiative transfer model for aerosol remote sensing.

After several decades' development of retrieval techniques in aerosol remote sensing, no fast and accurate analytical Radiative Transfer Model (RTM) has been developed and applied to create global aerosol products for non-polarimetric instruments such as Ocean and Land Colour Instrument/Sentinel-3 (OLCI/Sentinel-3) and Meteosat Second Generation/Spinning Enhanced Visible and Infrared Imager (MSG/SEVIRI). Global aerosol retrieval algorithms are typically based on a Look-Up-Table (LUT) technique, requiring high-performance computers. The current eXtensible Bremen Aerosol/cloud and surfacE parameters Retrieval (XBAER) algorithm also utilizes the LUT method. In order to have a near-real time retrieval and achieve a quick and accurate "FIRST-LOOK" aerosol product without high-demand of computing resource, we have developed a Fast and Accurate Semi-analytical Model of Atmosphere-surface Reflectance (FASMAR) for aerosol remote sensing. The FASMAR is developed based on a successive order of scattering technique. In FASMAR, the first three orders of scattering are calculated exactly. The contribution of higher orders of scattering is estimated using an extrapolation technique and an additional correction function. The evaluation of FASMAR has been performed by comparing with radiative transfer model SCIATRAN for all typical observation/illumination geometries, surface/aerosol conditions, and wavelengths 412, 550, 670, 870, 1600, 2100 nm used for aerosol remote sensing. The selected observation/illumination conditions are based on the observations from both geostationary satellite (e.g. MSG/SEVIRI) and polar-orbit satellite (e.g. OLCI/Sentinel-3). The percentage error of the top of atmosphere reflectance calculated by FASMAR is within  ± 3% for typical polar-orbit/geostationary satellites' observation/illumination geometries. The accuracy decreases for solar and viewing zenith angles larger than 70∘. However, even in such cases, the error is within the range  ± 5%. The evaluation of model performance also shows that FASMAR can be used for all typical surfaces with albedo in the interval [ 0 - 1 ] and aerosol with optical thickness in the range [ 0.01 - 1 ] .

Retrieval of aerosol optical properties using MERIS observations: Algorithm and some first results.

The MEdium Resolution Imaging Spectrometer (MERIS) instrument on board ESA Envisat made measurements from 2002 to 2012. Although MERIS was limited in spectral coverage, accurate Aerosol Optical Thickness (AOT) from MERIS data are retrieved by using appropriate additional information. We introduce a new AOT retrieval algorithm for MERIS over land surfaces, referred to as eXtensible Bremen AErosol Retrieval (XBAER). XBAER is similar to the "dark-target" (DT) retrieval algorithm used for Moderate-resolution Imaging Spectroradiometer (MODIS), in that it uses a lookup table (LUT) to match to satellite-observed reflectance and derive the AOT. Instead of a global parameterization of surface spectral reflectance, XBAER uses a set of spectral coefficients to prescribe surface properties. In this manner, XBAER is not limited to dark surfaces (vegetation) and retrieves AOT over bright surface (desert, semiarid, and urban areas). Preliminary validation of the MERIS-derived AOT and the ground-based Aerosol Robotic Network (AERONET) measurements yield good agreement, the resulting regression equation is y = (0.92 × ± 0.07) + (0.05 ± 0.01) and Pearson correlation coefficient of R = 0.78. Global monthly means of AOT have been compared from XBAER, MODIS and other satellite-derived datasets.