Novel PWO/ ZnO heterostructured nanocomposites: Synthesis, characterization, and photocatalytic performance.

Photocatalytic degradation is becoming an increasingly attractive method for addressing environmental remediation challenges. In this work, the novel pure PWO/ZnO and doped PWO: Er/ZnO: Ag heterostructure nanocomposites with premier photocatalytic efficiency were synthesized via a simple co-precipitation method followed by a solvothermal procedure. X-ray diffraction (XRD), diffuse reflectance spectroscopy (DRS), X-ray photoelectron spectroscopy (XPS), high-resolution transmission electron microscopy (HRTEM), energy dispersive X-ray (EDX), and ultraviolet-visible (UV-Vis) absorbance measurements techniques were employed to characterize the structural and optical properties. HRTEM images prove the possibility of intimate contact formation at the pure and doped PWO/ZnO heterostructure nanocomposite interfaces. The photocatalytic performance of the PWO/ZnO heterostructure nanocomposites in the degradation of the methylene blue (MB) and methyl orange (MO) dyes under UVA light was evaluated. The photocatalysts' ability in the mineralization of organic pollutants was confirmed by the TOC test. BET and zeta potential analyses were used to study the dye adsorption mechanisms. Additionally, adsorption isotherms and kinetics have been investigated to describe the adsorption of MB and MO into the samples. The degradation rates of MB with PWO/ZnO and PWO: Er/ZnO: Ag heterostructure nanocomposites were 4.7 and 6.6 times higher than those of PWO and PWO: Er nanoparticles. This rate for MO degradation is 5.2 and 3.5 times higher than that of pure PWO and PWO: Er nanoparticles, respectively. This study outlines an easy method to develop innovative, highly effective heterostructure nanocomposites capable of converting UVA light into photocatalytic performance.

Dielectric behavior of ceramic-graphene composites around the percolation threshold.

Al2O3/graphene and BaTiO3/graphene composites with different concentrations of the conductive second phase, both below and above the percolation threshold, were prepared by the traditional ceramic processing route followed by spark plasma sintering. It is shown that the addition of graphene pins the grain growth of the ceramic matrix grains, leading to a change of the microstructure at low filler concentrations. As a consequence, the composites exhibit two percolation thresholds and their dielectric properties are not only determined by the dielectric properties of the constituents and their relative fractions but also the microstructure of the composite must be considered. Additionally, a giant increase of the dielectric constant has been found around the percolation thresholds in barium titanate-graphene composites. In particular, values of the dielectric constant up to 45,000 and 15,000 were found at 1 kHz in composites containing 0.4 and 0.6 wt. % graphene, respectively.

Characterization of doped amorphous silicon thin films through the investigation of dopant elements by glow discharge spectrometry: a correlation of conductivity and bandgap energy measurements.

The determination of optical parameters, such as absorption and extinction coefficients, refractive index and the bandgap energy, is crucial to understand the behavior and final efficiency of thin film solar cells based on hydrogenated amorphous silicon (a-Si:H). The influence of small variations of the gas flow rates used for the preparation of the p-a-SiC:H layer on the bandgap energy, as well as on the dopant elements concentration, thickness and conductivity of the p-layer, is investigated in this work using several complementary techniques. UV-NIR spectrophotometry and ellipsometry were used for the determination of bandgap energies of four p-a-SiC:H thin films, prepared by using different B(2)H(6) and SiH(4) fluxes (B(2)H(6) from 12 sccm to 20 sccm and SiH(4) from 6 sccm to 10 sccm). Moreover, radiofrequency glow discharge optical emission spectrometry technique was used for depth profiling characterization of p-a-SiC:H thin films and valuable information about dopant elements concentration and distribution throughout the coating was found. Finally, a direct relationship between the conductivity of p-a-SiC:H thin films and the dopant elements concentration, particularly boron and carbon, was observed for the four selected samples.

[Antimicrobial resistance and bacterial virulence]. / Resistencia a los antimicrobianos y virulencia bacteriana.

Hospitals are places with high selective pressure by antimicrobial agents. For this reason, bacteria producing nosocomial infections need to be not only virulent, but also resistant to antimicrobial agents. In the present review we analyse the effect of the acquisition of an antibiotic resistance phenotype in bacterial fitness and virulence. Besides that, we review as well the existence of common mechanisms for resistance to antimicrobial agents and bacterial virulence. In this line, we highlight the role of multidrug efflux pumps on bacterial virulence. Since opportunistic pathogens frequently have an environmental origin, we also discuss the role of natural ecosystems, as well as their potential contamination, on the selection of bacteria resistant to antimicrobial agents.