Assuntos
Imunoconjugados , Humanos , Imunoconjugados/uso terapêutico , Oncologia , Anticorpos MonoclonaisRESUMO
The SuperCam instrument, onboard the Perseverance rover (Mars 2020 mission) is designed to perform remote analysis on the Martian surface employing several spectroscopic techniques such as Laser Induced Breakdown Spectroscopy (LIBS), Time-Resolved Raman (TRR), Time-Resolved Fluorescence (TRF) and Visible and Infrared (VISIR) reflectance. In addition, SuperCam also acquires high-resolution images using a color remote micro-imager (RMI) as well as sounds with its microphone. SuperCam has three main subsystems, the Mast Unit (MU) where the laser for chemical analysis and collection optics are housed, the Body Unit (BU) where the different spectrometers are located inside the rover, and the SuperCam Calibration Target (SCCT) located on the rover's deck to facilitate calibration tests at similar ambient conditions as the analyzed samples. To perform adequate calibrations on Mars, the 22 mineral samples included in the complex SCCT assembly must have a very homogeneous distribution of major and minor elements. The analysis and verification of such homogeneity for the 5-6 replicates of the samples included in the SCCT has been the aim of this work. To verify the physic-chemical homogeneity of the calibration targets, micro Energy Dispersive X-ray Fluorescence (EDXRF) imaging was first used on the whole surface of the targets, then the relative abundances of the detected elements were computed on 20 randomly distributed areas of 100 × 100 µm. For those targets showing a positive Raman response, micro-Raman spectroscopy imaging was performed on the whole surface of the targets at a resolution of 100 × 100 µm. The %RSD values (percent of relative standard deviation of mean values) for the major elements measured with EDXRF were compared with similar values obtained by two independent LIBS set-ups at spot sizes of 300 µm in diameter. The statistical analysis showed which elements were homogeneously distributed in the 22 mineral targets of the SCCT, providing their uncertainty values for further calibration. Moreover, nine of the 22 targets showed a good Raman response and their mineral distributions were also studied. Those targets can be also used for calibration purposes of the Raman part of SuperCam using the wavenumbers of their main Raman bands proposed in this work.
Assuntos
Meio Ambiente Extraterreno , Marte , Calibragem , Meio Ambiente Extraterreno/química , Minerais/análise , Análise Espectral Raman/métodosRESUMO
SuperCam is a highly integrated remote-sensing instrumental suite for NASA's Mars 2020 mission. It consists of a co-aligned combination of Laser-Induced Breakdown Spectroscopy (LIBS), Time-Resolved Raman and Luminescence (TRR/L), Visible and Infrared Spectroscopy (VISIR), together with sound recording (MIC) and high-magnification imaging techniques (RMI). They provide information on the mineralogy, geochemistry and mineral context around the Perseverance Rover. The calibration of this complex suite is a major challenge. Not only does each technique require its own standards or references, their combination also introduces new requirements to obtain optimal scientific output. Elemental composition, molecular vibrational features, fluorescence, morphology and texture provide a full picture of the sample with spectral information that needs to be co-aligned, correlated, and individually calibrated. The resulting hardware includes different kinds of targets, each one covering different needs of the instrument. Standards for imaging calibration, geological samples for mineral identification and chemometric calculations or spectral references to calibrate and evaluate the health of the instrument, are all included in the SuperCam Calibration Target (SCCT). The system also includes a specifically designed assembly in which the samples are mounted. This hardware allows the targets to survive the harsh environmental conditions of the launch, cruise, landing and operation on Mars during the whole mission. Here we summarize the design, development, integration, verification and functional testing of the SCCT. This work includes some key results obtained to verify the scientific outcome of the SuperCam system.
RESUMO
Understanding the mechanism and limits of strain transfer between supported 2D systems and their substrate is a most needed step toward the development of strain engineering at the nanoscale. This includes applications in straintronics, nanoelectromechanical devices, or new nanocomposites. Here, we have studied the limits of biaxial compressive strain transfer among SiO2, diamond, and sapphire substrates and graphene. Using high pressure-which allows maximizing the adhesion between graphene and the substrate on which it is deposited-we show that the relevant parameter governing the graphene mechanical response is not the applied pressure but rather the strain that is transmitted from the substrate. Under these experimental conditions, we also show the existence of a critical biaxial stress beyond which strain transfer become partial and introduce a parameter, α, to characterize strain transfer efficiency. The critical stress and α appear to be dependent on the nature of the substrate. Under ideal biaxial strain transfer conditions, the phonon Raman G-band dependence with strain appears to be linear with a slope of -60 ± 3 cm-1/% down to biaxial strains of -0.9%. This evolution appears to be general for both biaxial compression and tension for different experimental setups, at least in the biaxial strain range -0.9% < ε < 1.8%, thus providing a criterion to validate total biaxial strain transfer hypotheses. These results invite us to cast a new look at mechanical strain experiments on deposited graphene as well as to other 2D layered materials.
RESUMO
BACKGROUND/AIMS: Stratum corneum (SC) removal is needed in biopharmaceutical studies or in evaluating the barrier function. The most common technique is the tape stripping method. However, it results in neither a homogeneous nor a complete removal. METHODS: The removal qualities of tape stripping, cyanoacrylate skin surface biopsy and trypsinization were estimated in vitro via histological imaging and confocal Raman microspectroscopy (CRM) and compared. In addition, the potential of the noninvasive CRM as a replacement method is discussed. RESULTS: Comparison between the 3 methods showed, as expected, that the tape stripping method did not result in a uniform removal over the whole surface even after 28 strips. The trypsinization and cyanoacrylate skin surface biopsies allowed a complete and uniform removal of the SC after defining a standard protocol (2 cyanoacrylate strips with a polymerization time of 15 min). CONCLUSION: The feasibility of CRM to control SC removal was demonstrated in vitro. Tape stripping is a simple method, but it is influenced by many extrinsic factors and axial drug quantification is difficult. With trypsinization and cyanoacrylate methods, the entire SC is removed so that quantification over the whole SC is possible but not an axial drug screening.
Assuntos
Microscopia Confocal , Pele/química , Manejo de Espécimes/métodos , Análise Espectral Raman , Água/análise , Adesivos , Animais , Biópsia/métodos , Cianoacrilatos , Pele/citologia , Suínos , TripsinaRESUMO
We monitored alcoholic fermentation in Saccharomyces cerevisiae as a function of high hydrostatic pressure. Ethanol production from 0.15 M glucose was measured by Raman spectroscopy in situ in a diamond-anvil cell. At 10 MPa, fermentation proceeds three times faster than at ambient pressure and the fermentation yield is enhanced by 5% after 24 h. Above 20 MPa, the reaction kinetics slows down with increasing pressure. The pressure above which no more ethanol is produced is calculated to be 87 +/- 7 MPa. These results indicate that the activity of one or several enzymes of the glycolytic pathway is enhanced at low pressure up to 10 MPa. At higher pressures, they become progressively repressed, and they are completely inhibited above 87 MPa. Although fermentation was predicted to stop at ca. 50 MPa, due to the loss of activity of phosphofructokinase, the present study demonstrates that there is still an activity of ca. 30% of that measured at ambient pressure at 65 MPa. This study also validates the use of Raman spectroscopy for monitoring the metabolism of living microorganisms.