Reliability, Familiarization Effect, and Comparisons Between a Predetermined and a Self-Determined Isometric-Squat Testing Protocol.

PURPOSE: This study examined the interday reliability of a predetermined and a self-determined isometric-squat test among youth soccer players. Familiarization effects were evaluated to determine the minimum number of trials necessary to obtain consistent outputs. Finally, differences between protocols were evaluated. METHODS: Thirty-one youth soccer players (mean [SD] age: 13.2 [1.0] y; body mass: 54.1 [3.4] kg; stature: 166.3 [11.2] cm; percentage of estimated adult height: 92.6% [3.6%]) from a top-tier professional academy completed 4 experimental sessions for each protocol: familiarization 1, familiarization 2, test, and retest sessions. Peak force; relative peak force; impulse from 0 to 50 milliseconds, 0 to 100 milliseconds, 0 to 150 milliseconds, and 0 to 200 milliseconds; and rate of force development from 0 to 50 milliseconds, 0 to 100 milliseconds, 0 to 150 milliseconds, and 0 to 200 milliseconds were measured. RESULTS: Both protocols displayed acceptable (intraclass correlation coefficient ≥.75 and coefficient of variation ≤10%) reliability statistics for all metrics apart from rate of force development of any time epoch. Differences were found between familiarization 2 and both test and retest sessions for peak force (P = .034 and .021, respectively) and relative peak force (P = .035 and .005, respectively) across both protocols. CONCLUSIONS: The isometric-squat test is a reliable test among youth soccer players. Two familiarization sessions seem to be sufficient to ensure data stabilization. Outputs between the self-determined and predetermined are comparable; however, the latter seems preferable due to improved testing time efficiency.

Change of direction frequency off the ball: new perspectives in elite youth soccer.

PURPOSE: The aim of this study was to investigate the frequency of change of directions (COD) and examine the influences of position, leg dominance and anthropometrics on COD in elite youth soccer match play. METHODS: Twenty-four elite male English Premier League (EPL) academy players (19.0 ± 1.9 years) were individually recorded during ten competitive U18s and U23s matches. Video footage of individual players was analysed using a manual notation system to record COD frequency, direction, estimated angle and recovery time. The influences of position, anthropometrics and leg dominance were accounted for. RESULTS: Elite youth soccer players performed on average 305 ± 50 CODs with on average 19.2 ± 3.9 seconds of recovery. The frequency of CODs was independent of position, leg dominance, anthropometry and occurred equally between left and right direction and forwards and backwards direction. CODs were mostly ≤90° (77%) and there were significantly less CODs in the 2nd half (-29, ES = 1.23, P< 0.001). The average and peak within match demands within 15 and 5-minute periods were 49 and 62 CODs, and 16 and 25 CODs, respectively. CONCLUSION: This study is the first to illustrate COD frequencies of elite youth soccer match play, providing practitioners guidance to prepare soccer players for competitive match demands.

Is the Planus Foot Type Associated With First Ray Hypermobility?

Background: Many foot pathologies have been associated with foot type. However, the association of first ray hypermobility remains enigmatic. The purpose of this study was to investigate first ray hypermobility among participants with planus and rectus foot types and its influence on static measures of foot structure. Methods: Twenty asymptomatic participants with planus (n = 23 feet) and rectus (n = 17 feet) foot types were enrolled. Several parameters of static foot structure (arch height index, arch height flexibility, first metatarsophalangeal joint flexibility, and first ray mobility) were measured. Participants were further stratified into groups with nonhypermobile (n = 26 feet) and hypermobile (n = 14 feet) first rays. First ray mobility ≥8 mm was used to define "first ray hypermobility". Generalized estimating equations, best-fit regression lines, and stepwise linear regression were used to identify significant differences and predictors between the study variables. Results: Overall, 86% of subjects categorized with first ray hypermobility exhibited a planus foot type. Arch height flexibility, weightbearing first ray mobility, and first metatarsophalangeal joint flexibility showed no significant between-group differences. However, weightbearing ray mobility and first metatarsophalangeal joint laxity were associated with partial weightbearing first ray mobility, accounting for 38% of the model variance. Conclusion: The planus foot type was found to be associated with first ray hypermobility. Furthermore, weightbearing first ray mobility and first metatarsophalangeal joint laxity were predictive of partial weightbearing first ray mobility, demonstrating an interaction between the translation and rotational mechanics of the first ray. Clinical Relevance: Association of first ray hypermobility with foot type and first metatarsophalangeal joint flexibility may help understand the sequela to symptomatic pathologies of the foot.

Finite Element Modeling of Planus and Rectus Foot Types for the Study of First Metatarsophalangeal and First Metatarsocuneiform Joint Contact Mechanics.

The foot is a highly complex biomechanical system for which finite element (FE) modeling has been used to evaluate its loading environment. However, there is limited knowledge of first metatarsophalangeal (MTP) and first metatarsocuneiform (MTC) joint contact mechanics. Our goal was to develop a framework for FE modeling of the medial forefoot which could accurately predict experimental measurements of first MTP and first MTC joint loading. Simulations of planus and rectus foot types were conducted for midstance of gait. A custom-built force-controlled cadaveric test-rig was used to derive intracapsular pressure sensor measurements of contact pressure, force, and area during quasi-static loading. The FE model was driven under the same boundary and loading conditions as the cadaver. Mesh sensitivity analyses and best-fit calibrations of moduli for first MTP and first MTC joint cartilage were performed. Consistent with previous experimental research, a lower compressive modulus was best-fit to the first MTP compared to first MTC joint at 10 MPa and 20 MPa, respectively. Mean errors in contact pressures, forces, and areas were 24%, 4%, and 40% at the first MTP joint and 23%, 12%, and 19% at the first MTC joint, respectively. The present developmental framework may provide a basis for future modeling of first MTP and first MTC joint contact mechanics. This study acts as a precursor to validation of realistic physiological loading across gait to investigate joint loading, foot type biomechanics, and surgical interventions of the medial forefoot.

Comparative Reliability of a Novel Electromechanical Device and Handheld Ruler for Measuring First Ray Mobility.

BACKGROUND: Quantifying first ray mobility is crucial to understand aberrant foot biomechanics. A novel device (MAP1st) that can perform measurements of first ray mobility in different weightbearing conditions, foot alignments, and normalization was tested. The reliability of these measurement techniques was assessed in comparison to a handheld ruler considered representative of the common clinical examination. METHODS: The study included 25 participants (50 feet). Two independent raters performed baseline, test-retest, and remove-replace measurements of first ray mobility with MAP1st and the handheld device. The effects of non-, partial, and full weightbearing in subtalar joint neutral and the resting calcaneal stance position were assessed. Measurement normalization relative to foot size was also investigated. Intra- and interclass correlation coefficients (ICCs) were calculated for each device between the 2 raters. In addition, Bland-Altman plots were constructed to determine if fixed biases or substantial outliers were present. RESULTS: Similar intrarater ICC values were found for both devices (≥0.85). However, interrater ICC values were substantially improved by MAP1st compared with the handheld device (0.58 vs 0.06). Bland-Altman plots demonstrated biases of 1.27 mm for the handheld ruler, and 2.88 to 0.05 mm and -1.16 to 0.00 for linear and normalized MAP1st measurements, respectively. Improved reliability was achieved with MAP1st for normalized assessments of first ray mobility while the foot was placed in partial- and full-weightbearing resting calcaneal stance positions. CONCLUSION: MAP1st provided reliable assessments of partial- and full-weightbearing first ray mobility. It should help investigators to explore the potential relationships between first ray function and aberrant foot biomechanics in future research. LEVEL OF EVIDENCE: Level II, prospective cohort study.

Physiological characteristics and acute fatigue associated with position-specific speed endurance soccer drills: production vs maintenance training.

Objective: The study aimed to compare the physiological characteristics and acute fatigue associated with position-specific speed endurance production (SEP) and maintenance (SEM) soccer drills.Methods: Twenty male soccer players performed a position specific drill consisting of 8 exercise bouts each lasting ~30 s interspersed by 150 s (SEP) and 60 s (SEM) of passive recovery. A selection of players (n = 10) completed neuromuscular assessments pre and post drill.Results: Players covered greater high speed (12%), very high speed (49%) and sprint (218%) running distances in SEP (P < 0.05, ES: 0.51-0.80). SEP resulted in greater peak (7%) and average (10%) running speeds (P < 0.01, ES: 0.70-0.93). Mean and peak heart rate responses were greater in SEM (4-10%, P < 0.01, ES: 0.97-1.84) whilst blood lactate concentrations were higher following SEP (6%, P < 0.05, ES: 0.42). Reductions in vertical countermovement jump height were more pronounced immediately after SEP (2%, P < 0.05, ES: 0.36) but 24 h post SEM (4%, P < 0.05, ES: 0.52). Horizontal countermovement jump performance was reduced immediately post SEP and SEM (3-5%, P < 0.01, ES: 0.22-0.38) and 24 h post SEM (4%, ES: 0.32).Conclusion: The data demonstrate that position-specific SEP and SEM drills overload different physiological indices and induce small impairments in some neuromuscular measures.

Effects of a Medial Knee Unloading Implant on Tibiofemoral Joint Mechanics During Walking.

The Atlas™ unicompartmental knee system is a second-generation extra-articular unloading implant for patients with mild to moderate medial knee osteoarthritis. The technology acts to reduce a portion of the weight-bearing load exerted on the medial knee during physical activity thereby, reducing the mechanical stress imposed on a degenerative joint. The purpose of the present study was to evaluate the effects of the Atlas™ on tibiofemoral joint mechanics during walking. A computer-aided design assembly of the Atlas™ was virtually implanted on the medial aspect of a previously validated finite element tibiofemoral joint model. Data for knee joint forces and moments from an anthropometrically matched male were applied to the model to quasi-statically simulate the stance phase of gait. Predictions of tibiofemoral joint mechanics were computed pre- and post-virtual implantation of the Atlas™. Compressive force in the medial tibiofemoral compartment was reduced by a mean of 53%, resulting in the decrement of mean cartilage-cartilage and cartilage-meniscus von Mises stress by 31% and 32%, respectively. The Atlas™ was not predicted to transfer net loading to the lateral compartment. The tibiofemoral joint model exhibited less internal-external rotation and anterior-posterior translation post-Atlas™, indicating a change in the kinematic environment of the knee. From a biomechanical perspective, extra-articular joint unloading may serve as a treatment option for patients recalcitrant to conservative care. Evaluation of mechanical changes in the tibiofemoral joint demonstrate the potential treatment mechanism of the Atlas™, in accordance with the available clinical data. © 2019 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 37:2149-2156, 2019.

Multivariate analyses of individual variation in soccer skill as a tool for talent identification and development: utilising evolutionary theory in sports science.

The development of a comprehensive protocol for quantifying soccer-specific skill could markedly improve both talent identification and development. Surprisingly, most protocols for talent identification in soccer still focus on the more generic athletic attributes of team sports, such as speed, strength, agility and endurance, rather than on a player's technical skills. We used a multivariate methodology borrowed from evolutionary analyses of adaptation to develop our quantitative assessment of individual soccer-specific skill. We tested the performance of 40 individual academy-level players in eight different soccer-specific tasks across an age range of 13-18 years old. We first quantified the repeatability of each skill performance then explored the effects of age on soccer-specific skill, correlations between each of the pairs of skill tasks independent of age, and finally developed an individual metric of overall skill performance that could be easily used by coaches. All of our measured traits were highly repeatable when assessed over a short period and we found that an individual's overall skill - as well as their performance in their best task - was strongly positively correlated with age. Most importantly, our study established a simple but comprehensive methodology for assessing skill performance in soccer players, thus allowing coaches to rapidly assess the relative abilities of their players, identify promising youths and work on eliminating skill deficits in players.