A New Biphasic Dicalcium Silicate Bone Cement Implant.

This study aimed to investigate the processing parameters and biocompatibility of a novel biphasic dicalcium silicate (C2S) cement. Biphasic α´L + ß-C2Sss was synthesized by solid-state processing, and was used as a raw material to prepare the cement. In vitro bioactivity and biocompatibility studies were assessed by soaking the cement samples in simulated body fluid (SBF) and human adipose stem cell cultures. Two critical-sized defects of 6 mm Ø were created in 15 NZ tibias. A porous cement made of the high temperature forms of C2S, with a low phosphorous substitution level, was produced. An apatite-like layer covered the cement's surface after soaking in SBF. The cell attachment test showed that α´L + ß-C2Sss supported cells sticking and spreading after 24 h of culture. The cement paste (55.86 ± 0.23) obtained higher bone-to-implant contact (BIC) percentage values (better quality, closer contact) in the histomorphometric analysis, and defect closure was significant compared to the control group (plastic). The residual material volume of the porous cement was 35.42 ± 2.08% of the initial value. The highest BIC and bone formation percentages were obtained on day 60. These results suggest that the cement paste is advantageous for initial bone regeneration.

Assessment of Effects of Si-Ca-P Biphasic Ceramic on the Osteogenic Differentiation of a Population of Multipotent Adult Human Stem Cells.

A new type of bioceramic with osteogenic properties, suitable for hard tissue regeneration, was synthesised. The ceramic was designed and obtained in the Nurse's A-phase-silicocarnotite subsystem. The selected composition was that corresponding to the eutectoid 28.39 wt % Nurse's A-phase-71.61 wt % silicocarnotite invariant point. We report the effect of Nurse's A-phase-silicocarnotite ceramic on the capacity of multipotent adult human mesenchymal stem cells (ahMSCs) cultured under experimental conditions, known to adhere, proliferate and differentiate into osteoblast lineage cells. The results at long-term culture (28 days) on the material confirmed that the undifferentiated ahMSCs cultured and in contact with the material surface adhered, spread, proliferated, and produced a mineralised extracellular matrix on the studied ceramic, and finally acquired an osteoblastic phenotype. These findings indicate that it underwent an osteoblast differentiation process. All these findings were more significant than when cells were grown on plastic, in the presence and absence of this osteogenic supplement, and were more evident when this supplement was present in the growth medium (GM). The ceramic evaluated herein was bioactive, cytocompatible and capable of promoting the proliferation and differentiation of undifferentiated ahMSCs into osteoblasts, which may be important for bone integration into the clinical setting.

Coupled wave analysis of holographically induced transparency (HIT) generated by two multiplexed volume gratings.

We present a holographic system that can be used to manipulate the group velocity of light pulses. The proposed structure is based on the multiplexing of two sequential holographic volume gratings, one in transmission and the other in reflection geometry, where one of the recording beams must be the same for both structures. As in other systems such as grating induced transparency (GIT) or coupled-resonator-induced transparency (CRIT), by using the coupled wave theory it is shown that this holographic structure represents a classical analogue of the electromagnetically induced transparency (EIT). Analytical expressions were obtained for the transmittance induced at the forbidden band (spectral hole) and conditions where the group velocity was slowed down were analyzed. Moreover, the propagation of Gaussian pulses is analyzed for this system by obtaining, after further approximations, analytical expressions for the distortion of the transmitted field. As a result, we demonstrate the conditions where the transmitted pulse is slowed down and its shape is only slightly distorted. Finally, by comparing with the exact solutions obtained, the range of validity of all the analytical formulae was verified, demonstrating that the error is very low.

Nonparaxial diffraction analysis of Airy and SAiry beams.

We theoretically analyze Airy beams by solving the exact vectorial Helmholtz equation using boundary conditions at a diffraction aperture. As result, the diffracted beams are obtained in the whole space; thus, we demonstrate that the parabolic trajectories are larger than those previously reported, showing that the Airy beams start to form before the Fourier plane. We also demonstrate the possibility of using a new type of Airy beams (SAiry beams) with finite energy that can be generated at the focal plane of the lens due to diffraction by a circular aperture of a spherical wave modified by a cubic phase. The finite energy ensured by the principle of conservation of energy of a diffracted beam.