Effect of TiB Orientation on Near-Threshold Fatigue Crack Propagation in TiB-Reinforced Ti-3Al-2.5V Matrix Composites Treated with Heat Extrusion.

TiB-reinforced Ti-3Al-2.5V matrix composites, in which TiB whiskers are oriented parallel to the direction of heat extrusion, were fabricated via mechanical alloying and hot isostatic pressing (HIP). To investigate the near-threshold fatigue crack propagation in TiB-reinforced Ti-3Al-2.5V matrix composites, stress intensity factor K-decreasing tests were conducted for disk-shaped compact specimens having two different orientations of TiB whiskers at force ratios from 0.1 to 0.8 under ambient conditions. The crack growth rates, da/dN, for the composites incorporating TiB whiskers oriented perpendicular to the direction of crack growth were constantly lower than those obtained in the case where the orientation was parallel at the same stress intensity range ΔK, while the threshold stress intensity range, ΔKth, was higher. This effect can be explained by the increase in the degree of roughness-induced crack closure resulting from the perpendicular TiB, because fatigue cracks preferentially propagated across the boundaries between the matrix and the TiB in certain regions. In contrast, the effective threshold stress intensity range, ΔKeff,th, for composites was unaffected by the TiB orientation at low force ratios.

Evaluation of Interfacial Fracture Toughness and Interfacial Shear Strength of Typha Spp. Fiber/Polymer Composite by Double Shear Test Method.

The aim of this paper is to evaluate the Mode II interfacial fracture toughness and interfacial shear strength of Typha spp. fiber/PLLA and Typha spp. fiber/epoxy composite by using a double shear stress method with 3 fibers model composite. The surface condition of the fiber and crack propagation at the interface between the fiber and the matrix are observed by scanning electron microscope (SEM). Alkali treatment on Typha spp. fiber can make the fiber surface coarser, thus increasing the value of interfacial fracture toughness and interfacial shear strength. Typha spp. fiber/epoxy has a higher interfacial fracture value than that of Typha spp. fiber/PLLA. Interfacial fracture toughness on Typha spp. fiber/PLLA and Typha spp. fiber/epoxy composite model specimens were influenced by the matrix length, fiber spacing, fiber diameter and bonding area. Furthermore, the interfacial fracture toughness and the interfacial fracture shear stress of the composite model increased with the increasing duration of the surface treatment.