Alumina-based Coating for Coke Reduction in Steam Crackers.

Alumina-based coatings have been claimed as being an advantageous modification in industrial ethylene furnaces. In this work, on-line experimentally measured coking rates of a commercial coating (CoatAlloy™) have pointed out its superiority compared to an uncoated reference material in an electrobalance set-up. Additionally, the effects of presulfiding with 500 ppmw DMDS per H2O, continuous addition of 41 ppmw S per HC of DMDS, and a combination thereof were evaluated during ethane steam cracking under industrially relevant conditions (Tgasphase = 1173 K, Ptot = 0.1 MPa, XC2H6 = 70%, dilution δ = 0.33 kgH2O/kgHC). The examined samples were further evaluated using online thermogravimetry, scanning electron microscopy and energy diffractive X-ray for surface and cross-section analysis together with X-ray photoelectron spectroscopy and wavelength-dispersive X-ray spectroscopy for surface analysis. The passivating coating illustrated a better performance than the reference Ni-Cr Fe-base alloy after application of an improved pretreatment, followed by piddling changes on the product distribution. Presulfiding of the coating affected negatively the observed coking rates in comparison with the reference alloy, so alternative presulfiding and sulfur addition strategies are recommended when using this barrier coating.

Quantitative on-line analysis of sulfur compounds in complex hydrocarbon matrices.

An improved method for on-line measurement of sulfur containing compounds in complex matrices is presented. The on-line system consists of a specifically designed sampling system connected to a comprehensive two-dimensional gas chromatograph (GC×GC) equipped with two capillary columns (Rtx®-1 PONA×SGE BPX50), a flame ionization detector (FID) and a sulfur chemiluminescence detector (SCD). The result is an unprecedented sensitivity down to ppm level (1 ppm-w) for various sulfur containing compounds in very complex hydrocarbon matrices. In addition to the GC×GC-SCD, the low molecular weight sulfur containing compounds such as hydrogen sulfide (H2S) and carbonyl sulfide (COS) can be analyzed using a thermal conductivity detector of a so-called refinery gas analyzer (RGA). The methodology was extensively tested on a continuous flow pilot plant for steam cracking, in which quantification of sulfur containing compounds in the reactor effluent was carried out using 3-chlorothiophene as internal standard. The GC×GC-FID/-SCD settings were optimized for ppm analysis of sulfur compounds in olefin-rich (ethylene- and propylene-rich) hydrocarbon matrices produced by steam cracking of petroleum feedstocks. Besides that is primarily used for analysis of the hydrocarbon matrix, FID of the GC×GC-FID/-SCD set-up serves to double check the amount of added sulfur internal standard which is crucial for a proper quantification of sulfur compounds. When vacuum gas oil containing 780 ppm-w of elemental sulfur in the form of benzothiophenes and dibenzothiophenes is subjected to steam cracking, the sulfur balance was closed, with 75% of the sulfur contained in the feed is converted to hydrogen sulfide, 13% to alkyl homologues of thiophene while the remaining 12% is present in the form of alkyl homologues of benzothiophenes. The methodology can be applied for many other conversion processes which use sulfur containing feeds such as hydrocracking, catalytic cracking, kerogen evolution, bio-waste pyrolysis, supercritical water treatment, etc.