Synthesis and Characterization of Syndiotactic Polystyrene-Polyethylene Block Copolymer.

The direct synthesis of syndiotactic polystyrene-block-polyethylene copolymer (sPS-b-PE) with a diblock structure has been achieved. The synthetic strategy consists of the sequential stereocontrolled polymerization of styrene and ethylene in the presence of a single catalytic system: cyclopentadienyltitanium(IV) trichloride activated by modified methylaluminoxane (CpTiCl3/MMAO). The reaction conditions suitable for affording the partially living polymerization of these monomers were identified, and the resulting copolymer, purified from contaminant homopolymers, was fully characterized. Gel permeation chromatography coupled with two-dimensional NMR spectroscopy COSY, HSQC, and DOSY confirmed the block nature of the obtained polymer, whose thermal behaviour and thin film morphology were also investigated by differential scanning calorimetry, powder wide angle x-ray diffraction, and atomic force microscopy.

High Conversion of Styrene, Ethylene, and Hydrogen to Linear Monoalkylbenzenes.

1-Alkylbenzenes as a precursor of surfactants, can be produced from ethylene, styrene, and hydrogen. These intermediates, lacking tertiary carbons, are environmentally more benign than commercial ones that bear the aromatic ring linked to an internal carbon of the aliphatic chain. The one-pot synthesis of highly linear 1-alkylbenzenes (LABs) through the homogeneous catalysis of olefin poly-insertion from cheap and largely available reagents can be carried out with a high turnover and selectivity. A purposely designed reactor that allows for the fine control of the three components feed, along with temperature, plays a key role in this achievement. A turnover of 194 g of LABs per mmol of catalyst per hour can be obtained with the simultaneous removal of polyethylene as a by-product.

Solution Structure and Reactivity with Metallocenes of AlMe2 F: Mimicking Cation-Anion Interactions in Metallocenium-Methylalumoxane Inner-Sphere Ion Pairs.

The solution structure of AlMe2 F and its reactivity with a prototypical ansa-metallocene have been investigated by advanced NMR techniques, in an attempt to indirectly shed some light on the structure and working principles of methylalumoxane (MAO) mixtures in olefin polymerization. In solution, AlMe2 F gives rise to a complex equilibrium of oligomeric species, including a heterocubane [(Me2 Al)4 F4 ] tetramer, resembling the behavior of MAO. This complex mixture reacts with (ETH)ZrMe2 (ETH=rac-[ethylenebis(4,5,6,7-tetrahydro-1-indenyl)]) to afford [(ETH)ZrMeδ+ (µ-F)(AlMe2 F)n AlMe3δ- ] inner-sphere ion pairs through successive insertions/deinsertions of AlMe2 F units into the Zr⋅⋅⋅(µ-F) bond.

Olefin⁻Styrene Copolymers.

In this review are reported some of the most relevant achievements in the chemistry of the ethylene⁻styrene copolymerization and in the characterization of the copolymer materials. Focus is put on the relationship between the structure of the catalyst and that of the obtained copolymer. On the other hand, the wide variety of copolymer architecture is related to the properties of the material and to the potential utility.

Aluminium alkyl complexes supported by [OSSO] type bisphenolato ligands: synthesis, characterization and living polymerization of rac-lactide.

Aluminium alkyl complexes [(OSSO)AlR](1-3: R = Me, Et) were isolated in good yields from the protonolysis reaction of AlR3 with the corresponding tetradentate 1,omega-dithiaalkanediyl-bridged bisphenols (1,4-dithiabutanediyl-bis(6-tert-butyl-4-methylphenol), etbmpH2; ortho-xylylenedithio-bis(6-tert-butyl-4-methylphenol), xytbmpH2). The monomeric structures of all three complexes were confirmed by X-ray diffraction studies. Complexes 1 and 2 have an isotypic packing arrangement. The aluminium center is coordinated by the etbmp ligand and one alkyl group with distorted trigonal bipyramidal geometry. Complex 3 shows Cs symmetry with square pyramidal geometry around the metal center. Substitution reaction of complex 1 with trityl alcohol gave the monomeric alkoxide complex [(etbmp)Al(OCPh3)] 4, which has a similar trigonal bipyramidal geometry around the aluminium atom as complex 1. In the presence of isopropanol, complexes 1-3 initiated the living ring-opening polymerization of rac-lactide (PDI = 1.03-1.06, Mw/Mn). The ligand structure influenced the tacticity of the obtained polymer, with complex 3 giving heterotactic-enriched polylactides.