Maximising resource recovery from wastewater grown microalgae and primary sludge in an anaerobic membrane co-digestion pilot plant coupled to a composting process.

A pilot-scale microalgae (Chlorella spp.) and primary sludge anaerobic co-digestion (ACoD) plant was run for one year in an anaerobic membrane bioreactor (AnMBR) at 35 °C, 70 d solids retention time and 30 d hydraulic retention time, showing high stability in terms of pH and VFA concentration. The plant achieved a high degree of microalgae and primary sludge substrate degradation, resulting in a methane yield of 370 mLCH4·gVSinf-1. Nutrient-rich effluent streams (685 mgN·L-1 and 145 mgP·L-1 in digestate and 395 mgNH4-N·L-1 and 37 mgPO4-P·L-1 in permeate) were obtained, allowing posterior nutrient recovery. Ammonium was recovered from the permeate as ammonia sulphate through a hydrophobic polypropylene hollow fibre membrane contactor, achieving 99% nitrogen recovery efficiency. However, phosphorus recovery through processes such as struvite precipitation was not applied since only 26% of the phosphate was available in the effluent. Composting process of the digestate coming from the ACoD pilot plant was assessed on laboratory-scale Dewar reactors, as was the conventional sludge compost from an industrial WWTP digestion process, obtaining similar values from both. Sanitised (free of Escherichia coli and Salmonella spp.) and stable compost (respirometric index at 37 °C below 0.5 mgO 2 g organic matter-1·h-1) was obtained from both sludges.

Improving membrane photobioreactor performance by reducing light path: operating conditions and key performance indicators.

Microalgae cultivation has been receiving increasing interest in wastewater remediation due to their ability to assimilate nutrients present in wastewater streams. In this respect, cultivating microalgae in membrane photobioreactors (MPBRs) allows decoupling the solid retention time (SRT) from the hydraulic retention time (HRT), which enables to increase the nutrient load to the photobioreactors (PBRs) while avoiding the wash out of the microalgae biomass. The reduction of the PBR light path from 25 to 10 cm increased the nitrogen and phosphorus recovery rates, microalgae biomass productivity and photosynthetic efficiency by 150, 103, 194 and 67%, respectively.The areal biomass productivity (aBP) also increased when the light path was reduced, reflecting the better use of light in the 10-cm MPBR plant. The capital and operating operational expenditures (CAPEX and OPEX) of the 10-cm MPBR plant were also reduced by 27 and 49%, respectively. Discharge limits were met when the 10-cm MPBR plant was operated at SRTs of 3-4.5 d and HRTs of 1.25-1.5 d. At these SRT/HRT ranges, the process could be operated without a high fouling propensity with gross permeate flux (J20) of 15 LMH and specific gas demand (SGDp) between 16 and 20 Nm3air·m-3permeate, which highlights the potential of membrane filtration in MPBRs. When the continuous operation of the MPBR plant was evaluated, an optical density of 680 nm (OD680) and soluble chemical oxygen demand (sCOD) were found to be good indicators of microalgae cell and algal organic matter (AOM) concentrations, while dissolved oxygen appeared to be directly related to MPBR performance. Nitrite and nitrate (NOx) concentration and the soluble chemical oxygen demand:volatile suspended solids ratio (sCOD:VSS) were used as indicators of nitrifying bacteria activity and the stress on the culture, respectively. These parameters were inversely related to nitrogen recovery rates and biomass productivity and could thus help to prevent possible culture deterioration.

Selecting the most suitable microalgae species to treat the effluent from an anaerobic membrane bioreactor.

Conventional treatments for nutrient removal in wastewater are shifting to Anaerobic Membrane Bioreactors, which produce a high-quality effluent with minimum sludge production. The effluent resulting contains high nitrogen and phosphorus load that can be eliminated by microalgae culture. The aim of this study is to evaluate the ammonium and phosphorus removal rate of different microalgae species in the effluent of an anaerobic treatment. For that, 4 different microalgae species have been tested (Chlamydomonas reinhardtii, Scenedesmus obliquus, Chlorella vulgaris and Monoraphidium braunii) in batch monoculture and mixed conditions. Results indicate that all species are able to eliminate both P and N in the medium with high removal rates. However, a slight interspecies competition may boost these removal rates and productivity values ensuring, the success of the process.

Resource recovery from sulphate-rich sewage through an innovative anaerobic-based water resource recovery facility (WRRF).

This research work proposes an innovative water resource recovery facility (WRRF) for the recovery of energy, nutrients and reclaimed water from sewage, which represents a promising approach towards enhanced circular economy scenarios. To this aim, anaerobic technology, microalgae cultivation, and membrane technology were combined in a dedicated platform. The proposed platform produces a high-quality solid- and coliform-free effluent that can be directly discharged to receiving water bodies identified as sensitive areas. Specifically, the content of organic matter, nitrogen and phosphorus in the effluent was 45 mg COD·L-1, 14.9 mg N·L-1 and 0.5 mg P·L-1, respectively. Harvested solar energy and carbon dioxide biofixation in the form of microalgae biomass allowed remarkable methane yields (399 STP L CH4·kg-1 CODinf) to be achieved, equivalent to theoretical electricity productions of around 0.52 kWh per m3 of wastewater entering the WRRF. Furthermore, 26.6% of total nitrogen influent load was recovered as ammonium sulphate, while nitrogen and phosphorus were recovered in the biosolids produced (650 ± 77 mg N·L-1 and 121.0 ± 7.2 mg P·L-1).

Microalgae population dynamics growth with AnMBR effluent: effect of light and phosphorus concentration.

The aim of this study was to evaluate the effect of light intensity and phosphorus concentration on biomass growth and nutrient removal in a microalgae culture and their effect on their competition. The photobioreactor was continuously fed with the effluent from an anaerobic membrane bioreactor pilot plant treating real wastewater. Four experimental periods were carried out at different light intensities (36 and 52 µmol s-1 m-2) and phosphorus concentrations (around 6 and 15 mgP L-1). Four green algae - Scenedesmus, Chlorella, Monoraphidium and Chlamydomonas- and cyanobacterium were detected and quantified along whole experimental period. Chlorella was the dominant species when light intensity was at the lower level tested, and was competitively displaced by a mixed culture of Scenedesmus and Monoraphidium when light was increased. When phosphorus concentration in the photobioreactor was raised up to 15 mgP L-1, a growth of cyanobacterium became the dominant species in the culture. The highest nutrient removal efficiency (around 58.4 ± 15.8% and 96.1 ± 16.5% of nitrogen and phosphorus, respectively) was achieved at 52 µmol s-1 m-2 of light intensity and 6.02 mgP L-1 of phosphorus concentration, reaching about 674 ± 86 mg L-1 of volatile suspended solids. The results obtained reveal how the light intensity supplied and the phosphorus concentration available are relevant operational factors that determine the microalgae species that is able to predominate in a culture. Moreover, changes in microalgae predominance can be induced by changes in the growth medium produced by the own predominant species.

Wastewater nutrient removal in a mixed microalgae-bacteria culture: effect of light and temperature on the microalgae-bacteria competition.

The aim of this study was to evaluate the effect of light intensity and temperature on nutrient removal and biomass productivity in a microalgae-bacteria culture and their effects on the microalgae-bacteria competition. Three experiments were carried out at constant temperature and various light intensities: 40, 85 and 125 µE m-2 s-1. Other two experiments were carried out at variable temperatures: 23 ± 2°C and 28 ± 2°C at light intensity of 85 and 125 µE m-2 s-1, respectively. The photobioreactor was fed by the effluent from an anaerobic membrane bioreactor. High nitrogen and phosphorus removal efficiencies (about 99%) were achieved under the following operating conditions: 85-125 µE m-2 s-1 and 22 ± 1°C. In the microalgae-bacteria culture studied, increasing light intensity favoured microalgae growth and limited the nitrification process. However, a non-graduated temperature increase (up to 32°C) under the light intensities studied caused the proliferation of nitrifying bacteria and the nitrite and nitrate accumulation. Hence, light intensity and temperature are key parameters in the control of the microalgae-bacteria competition. Biomass productivity significantly increased with light intensity, reaching 50.5 ± 9.6, 80.3 ± 6.5 and 94.3 ± 7.9 mgVSS L-1 d-1 for a light intensity of 40, 85 and 125 µE m-2 s-1, respectively.

Short and long-term experiments on the effect of sulphide on microalgae cultivation in tertiary sewage treatment.

Microalgae cultivation appears to be a promising technology for treating nutrient-rich effluents from anaerobic membrane bioreactors, as microalgae are able to consume nutrients from sewage without an organic carbon source, although the sulphide formed during the anaerobic treatment does have negative effects on microalgae growth. Short and long-term experiments were carried out on the effects of sulphide on a mixed microalgae culture. The short-term experiments showed that the oxygen production rate (OPR) dropped as sulphide concentration increased: a concentration of 5mgSL-1 reduced OPR by 43%, while a concentration of 50mgSL-1 came close to completely inhibiting microalgae growth. The long-term experiments revealed that the presence of sulphide in the influent had inhibitory effects at sulphide concentrations above 20mgSL-1 in the culture, but not at concentrations below 5mgSL-1. These conditions favoured Chlorella growth over that of Scenedesmus.

Glophymed: an index to establish the ecological status for the Water Framework Directive based on phytoplankton in coastal waters.

Phytoplankton and its attributes (biomass, abundance, composition, and frequency and intensity of phytoplankton blooms) are essential to establish the ecological status in the Water Frame Directive. The aim of this study is to develop an index "Glophymed" based on all phytoplankton attributes for coastal water bodies according to the directive requirements. It is also developed an anthropogenic pressure index that takes into account population density, tourism, urbanization, industry, agriculture, fisheries and maritime transport for Comunitat Valenciana (Spain). Both indexes (Glophymed and human pressure index) based on a multisampling dataset collected monthly during several years, show a significant statistical correlation (r2 0.75 α<0.01) for typology IIA and (r2 0.93 α<0.01) for typology III-W. The relation between these indexes provides suitable information about the integrated management plans and protection measures of water resources since the Glophymed index is very sensitive to human pressures.

Determination of phytoplankton composition using absorption spectra.

Characterisation of phytoplankton communities in aquatic ecosystems is a costly task in terms of time, material and human resources. The general objective of this paper is not to replace microscopic counts but to complement them, by fine-tuning a technique using absorption spectra measurements that reduces the above-mentioned costs. Therefore, the objective proposed in this paper is to assess the possibility of achieving a qualitative determination of phytoplankton communities by classes, and also a quantitative estimation of the number of phytoplankton cells within each of these classes, using spectrophotometric determination. Samples were taken in three areas of the Spanish Mediterranean coast. These areas correspond to estuary systems that are influenced by both continental waters and Mediterranean Sea waters. 139 Samples were taken in 7-8 stations per area, at different depths in each station. In each sample, the absorption spectrum and the phytoplankton classes (Bacyllariophyceae (diatoms), Cryptophyceae, Clorophyceae, Chrysophyceae, Prasynophyceae, Prymnesophyceae, Euglenophyceae, Cyanophyceae, Dynophyceae and the Synechococcus sp.) were determined. Data were analysed by means of the Partial Least Squares (PLS) multivariate statistical technique. The absorbances obtained between 400 and 750 nm were used as the independent variable and the cell/l of each phytoplankton class was used as the dependent variable, thereby obtaining models which relate the absorbance of the sample extract to the phytoplankton present in it. Good results were obtained for diatoms (Bacillarophyceae), Chlorophyceae and Cryptophyceae.