Efficacy of a new sonic powered toothbrush versus a manual toothbrush in a young population. A randomized cross-over clinical trial.

OBJECTIVE: To compare the effectiveness of dental plaque removal between a new sonic toothbrush and a manual toothbrush. METHODS: In total, 75 healthy dental students participated in this randomized double-blind crossover clinical trial. Subjects were randomly assigned to one of the two groups (manual or sonic toothbrush) and underwent a single toothbrushing exercise. Seven days after, patients were asked to repeat the same procedure with the other toothbrush. Plaque scores were recorded before and after brushing. RESULTS: A significant mean reduction in the full-mouth plaque index was observed after the use of both type of brushes: 46.2% ± 0.28% (p = 0.000) and 50.5% ± 0.24% (p = 0.000) for the manual and sonic toothbrush, respectively. However, there were no statistically significant differences between the two types of brushes (p = 0.277). Regarding plaque reduction on the distinct tooth surfaces, differences between the groups reached statistical significance in favour of the sonic toothbrush only on the buccal sites (p = 0.003). CONCLUSIONS: Both devices lead to similar plaque score reduction after a single tooth brushing.

Efficacy of professionally administered chemical agents as an adjunctive treatment to sub-marginal instrumentation during the therapy of peri-implant mucositis.

AIM: To evaluate the efficacy of professionally administered chemical agents as an adjunctive treatment to sub-marginal instrumentation (SMI) in the therapy of peri-implant mucositis. MATERIALS AND METHODS: The primary outcome criteria were reduction in bleeding on probing (BOP), whereas resolution of disease, elimination of suppuration, including suppuration on probing, reduction of peri-implant probing pocket depth, reduction of plaque, and patient-reported outcome measures were considered as secondary outcome parameters. A literature search was performed on three electronic databases (01/1980 to 05/2022) focused on clinical studies with at least 3 months of follow-up, and meta-analyses were performed when appropriate. RESULTS: From a total of 139 publications, 40 articles were identified for full-text reading, and 5 randomized controlled clinical trials (RCTs) on antimicrobial photodynamic therapy (aPDT), 1 RCT on chlorhexidine (CHX), and 1 RCT on sodium hypochlorite (NaOCl) were included. Three studies had a low risk of bias and four had a mid-level (some concerns) risk of bias. The application of aPDT, 0.95% NaOCl, or 0.12% CHX as an adjunctive treatment to SMI showed no difference in changes in BOP and PD compared with SMI alone (p > .05). CONCLUSIONS: Within the limitations of this review and based on a low level of evidence from seven RCTs, it is concluded that the professional adjunctive topical application of aPDT, 0.95% NaOCl, and 0.12% CHX may not be effective to improve changes for BOP and PD when compared with SMI alone.

Ridge preservation in molar sites comparing xenograft versus mineralized freeze-dried bone allograft: A randomized clinical trial.

OBJECTIVES: The main objective of the study was to compare the dimensional ridge changes and the histological composition after the use of an allograft or xenograft and a resorbable membrane in ridge preservation in molar sites and to evaluate the influence of bone plate thickness on dimensional changes and the need of lateral sinus augmentation following ridge preservation. MATERIALS AND METHODS: Twenty-four patients in need of maxillary or mandibular first or second molar extraction and subsequent implant placement were included and randomly assigned to a group; allograft or xenograft, plus a collagen membrane. Cone-beam computed tomographies were obtained after molar extraction and after 5 months. A bone sample was harvested at the time of implant placement and analyzed by histomorphometry. RESULTS: Bone ridge was reduced significantly. Major changes in width occurred at 1 mm from the bone crest (-2.93 ± 2.28 mm) (p = .0002), while in height, the greatest reduction occurred at the buccal area (-1.97 ± 2.21 mm) (p = .0006). However, differences between groups were not significant. Thicker buccal bone plates exhibited less bone remodeling, while histologically, both biomaterials resulted in similar tissue composition. The resulting available bone height in the implant site measured 7.30 ± 3.53 mm initially and 6.8 ± 3.61 mm after 5 months which allowed implant placement without the need for lateral sinus augmentation in all cases. Still, 55% of the preserved areas needed transcrestal sinus lift. CONCLUSION: Ridge preservation in molar sites using a mineralized allograft or xenograft provides similar dimensional and histomorphometrical results after 5 months.

Fracture Resistance in Non-Vital Teeth: Absence of Interproximal Ferrule and Influence of Preparation Depth in CAD/CAM Endocrown Overlays-An In Vitro Study.

There is ample evidence to support the use of endocrowns to restore endodontic teeth. However, the influence of the position of the interproximal margins on fracture strength has not yet been studied. The aim was to determine the relationship between the apicocoronal position of the interproximal restorative margins and fracture resistance in nonvital teeth restored with CAD/CAM endocrown overlays. Forty extracted human maxillary premolars were prepared for endocrown overlay restorations without ferrule on the interproximal aspects and classified according to the position of the interproximal restoration margins in relation to the alveolar crest: 2 mm (group A), 1 mm (group B), 0.5 mm (group C), and 0 mm (group D). Fracture strength was measured using a universal testing machine applying a compressive force to the longitudinal tooth axis. Group A had a mean fracture resistance of 859.61 (±267.951) N, group B 1053.9 (±333.985) N, group C 1124.6 (±291.172) N, and group D 780.67 (±183.269) N, with statistical differences between groups. Group C had the highest values for fracture strength compared to the other groups (p < 0.05). The location of the interproximal margins appears to influence the fracture resistance of CAD/CAM endocrown overlays. A distance of 0.5 mm between the interproximal margin and the alveolar crest was associated with increased fracture resistance.

Biologically oriented preparation technique for surgically extruded teeth: A clinical report.

Surgical extrusion allows a ferrule to be obtained without the use of orthodontic extrusion or the need to remove hard and soft tissues. However, after the healing period, the soft tissue of the extruded tooth might become thinner, creating an unesthetic gingival margin. Unlike other preparation techniques, the biologically oriented preparation technique provides increased long-term gingival thickness. This article describes the treatment of 3 patients with teeth with no ferrule that were surgically extruded and restored with the biologically oriented preparation technique .

Keratinized tissue gain after free gingival graft augmentation procedures around teeth and dental implants: A prospective observational study.

AIM: The primary goal was to compare the amount of keratinized tissue width (KTW) gain after free gingival graft (FGG) procedures around implants and teeth after 6 and 12 months of healing. MATERIALS AND METHODS: Patients with mucogingival defects (<2 mm of KT) around teeth and implants underwent a gingival augmentation procedure by means of a FGG. Clinical measurements were performed with an individual stent to determine keratinized tissue width (KTW), length (KTL), graft shrinkage (GS) and gingival margin position (GMP) at 2 weeks, 6 weeks, 3 months, 6 months and 12 months after surgery. RESULTS: Twenty-nine patients (35 sites) participated in this prospective study. After surgery, KTW decreased and GS increased significantly in both treatment groups during the whole follow-up period, but the biggest changes were observed at 6 weeks. When comparing both treatment groups, implant sites showed significantly more reduction in KTW and more GS. Thus, at 12 months, KTW and GS reduced 2.03 ± 2.1 mm and 36.74 ± 38.2% in the teeth group and 2.91 ± 12.03 mm and 61.8 ± 36.25% around implants, respectively. CONCLUSIONS: A significantly greater reduction in KTW and more GS might be expected at implant sites.

Molecular signatures of extracellular vesicles in oral fluids of periodontitis patients.

OBJECTIVE: To characterize extracellular vesicles (EVs) in gingival crevicular fluid (GCF) and saliva samples from healthy/gingivitis and periodontitis patients and correlate them with clinical inflammatory periodontal parameters. MATERIAL AND METHOD: An exploratory study, including 86 subjects, was conducted. Clinical and periodontal data were recorded, and oral fluid samples were obtained. EVs were precipitated by ExoQuick-TC™ and characterized by nanoparticle tracking (NanoSight™), Western blot (WB), transmission electron microscopy (TEM), and ELISA analysis. RESULTS: TEM showed nanoparticles morphologically compatible with EVs, and WB analysis revealed bands of specific EV markers (CD9, TSG101, and Alix) in both oral fluids of periodontitis and healthy/gingivitis subjects. The total concentration of EVs in GCF was increased in periodontitis patients compared to healthy/gingivitis subjects (p = .017). However, we did not observe differences in the EV concentration of saliva samples (p = .190). The size of GCF-EVs was 144.2 nm in periodontitis and 160.35 nm in healthy/gingivitis patients (p = .038). The CD63 exosome marker was increased in GCF of periodontitis patients (p = .00001). The total concentration of EVs in GCF was correlated with bleeding on probing (rho = 0.63, p = .002), periodontal probing depth (rho = 0.56, p = .009), and clinical attachment level (rho = 0.48, p = .030). CONCLUSION: Periodontitis patients have an increased concentration of EVs in GCF, and their role in periodontitis should be clarified.

Stability of the gingival margin after an aesthetic crown lengthening procedure in the anterior region by means of a replaced flap and buccal osseous surgery: a prospective study.

OBJECTIVES: The main objective of this study was to assess changes in the position of the gingival margin (GM) after performing an aesthetic crown lengthening (ACLP) by means of submarginal incisions, buccal osseous surgery, and a replaced flap after a healing period of 6 months. METHODS: Twenty-one patients who needed a surgical crown lengthening in the maxillary anterior teeth were included. An individual stent was fabricated to record changes in the position of the GM. Clinical measurements were recorded pre-surgically; immediately post-surgically (baseline); and at 42, 90, and 180 days. RESULTS: After the ACLP, the GM displacement did not change significantly after 42, 90, and 180 days (4.32 ± 1.17 mm, 4.29 ± 1.14 mm, and 4.26 ± 1.11 mm, respectively). Tissue rebound seems to be related to the distance from the GM to the alveolar bone (AB) at the time of suturing (GM-AB(X)). When GM-AB(X) was ≤ 2 mm, 3 mm, and ≥ 4 mm, the GM rebound at 6 months was 0.94 ± 0.53 mm, 0.10 ± 0.28 mm, and - 0.26 ± 0.40 mm, respectively. These differences were statistically significant (P < 0.001). CONCLUSIONS: An ACLP releasing the flap up to the mucogingival junction, with a ≥ 3-mm distance from the bone crest to the gingival margin can lead to a stable GM position at 42, 90, and 180 days. CLINICAL RELEVANCE: This article focuses on variables affecting the stability of the GM, which is a critical factor that may compromise the biological and aesthetic long-term outcomes.

In vitro evaluation of the root surface microtopography following the use of two polishing systems by Confocal Microscopy (CFM) and Scanning Electron Microscope (SEM).

OBJECTIVES: To compare and evaluate the root surface roughness after using two polishing instruments for root planing. MATERIALS AND METHODS: This comparative study was carried out on a sample of ten extracted human teeth with twenty interproximal root surfaces. Control group 1 and 2: (n=20 root surface): Gracey Curettes, 15 vertical strokes. Test group 1 (n=10): control group 1 + Termination Diamond Curettes (TDC), 15 strokes. Test group 2 (n=10): control group 2 + Termination Diamond Burs -15 µm (TDB), with irrigation for 15 seconds at 3000 rpm. The root surface was planed with the polishing instruments and test measurements were obtained with Confocal Microscopy (CFM) and Scanning Electron Microscope (SEM). The primary outcome variable was surface roughness (Ra). RESULTS: CFM showed that the TDC, mean changes in surface roughness (Ra) were reduced by 0.11 ± 0.14 (p-value = 0.000), and the TDB, Ra: were reduced by 0.27 ± 0.86 (p-value = 0.037). Non-statistically significant differences were observed in Ra (p-value = 0.581) between the two polishing instruments. SEM showed that the Group 2 showed a generally rougher surface with more parallel grooves than Group 1. CONCLUSION: There are no statistically significant differences between these two polishing systems, although TDB seems to reduce the surface roughness more than the TDC after being treated with Gracey Curettes.