Anthropogenic particle abundance and characteristics in seawater and intertidal sediments of the Tonkin Bay Coast (North Vietnam).

Microplastics (MPs, plastic items from 1 µm to 5 mm in size) are present in all environmental compartments. The evaluation of their concentration, fate, and spatial distribution is still a challenge for the scientific community. This concern is just debuting in developing countries, (i.e., Asia, South America, and Africa). This study deals with the MP contamination in the abiotic marine compartments of Northern Vietnam: seawater and intertidal sediments. Four sites located in the intertidal zone or near the coastline in Tonkin Bay, Vietnam were studied. A total of 16 samples (eight for each compartment) were collected in July 2020 (rainy season) and January 2021 (dry season). Anthropogenic particles (total observed fibers and fragments) were found at levels ranging from 3 to 303 particles/m3 in seawater and from 63 to 955 particles/kg dry weight in sediments. Most of these were fibers less than 300-µm long. Higher levels of seawater at the Nam Dinh site were found in the rainy season compared to the dry one. As the river flow was estimated six times higher during the rainy season than during the dry season, these results suggest the river discharge is a potential source of contamination for the coastal zone. The temporal variability was lower for the sediments than for the seawater, suggesting the long-term integration of the anthropogenic particles in this compartment. A small portion of sorted particles were analyzed by µFTIR (8.35%), and this sub-sample was only composed of fragments. Still, fragments were mostly composed of polypropylene (PP, 82%), polyethylene (PE, 9%), and polystyrene (PS, 9%). The fragment size was similar in the two studied compartments, but it was dependent on polymer types since PS fragments (140 ± 17 µm) were smaller than those made of PE (622 ± 123 µm) and PP (869 ± 905 µm). Future works should investigate the smallest fraction of MP (even nanoplastics) as well as find solutions in order to mitigate MP contamination in the marine environment.

Microplastic accumulation in sewer sediments and its potential entering the environment via combined sewer overflows: a study case in Paris.

During wet weather events, combined sewer overflows (CSOs) transfer large amount of particulate matter and associated pollutants into surrounding water bodies, thereby deteriorating the recipients' ecological health. Resuspension of sewer sediments during these events contributes significantly to pollution level of these discharges. However, how much this in-sewer process contributes to CSOs' quality regarding microplastic (MP) pollution is little known. Therefore, an investigation on sewer deposits inside the Parisian combined sewer network was carried out. The study found high MP concentrations stored in this matrix, ranging from 5 × 103 to 178 × 103 particle/kg dry weight. Polymer composition is similar to what found in raw wastewater, containing a high proportion of polyethylene and polypropylene. Thus, the results indicated the persistence of MPs in sewer network during transport during dry weather periods to treatment facilities. Once resuspension of sewer deposits happens, MPs can be released into water flow and get discharged along with CSOs. This highlights another potential pathway of MPs into freshwater environment.

Microplastic accumulation in bivalves collected from different coastal areas of Vietnam and an assessment of potential risks.

Microplastic (MP) pollution is an emerging problem in many areas around the world and in coastal areas of Vietnam, requiring more studies dedicated to the accumulation of this pollutant in the food chain as well as its potential risk to human health. This study investigated MP levels in tissues of five common bivalve species collected from aquaculture areas along the coast of Vietnam. MPs were found in all bivalve samples, with average values of 10.84 ± 2.61 items/individual or 2.40 ± 1.34 items/g wet weight. Impacts of feeding habits of bivalves showed influences on MP abundance in the samples. Fibers were the dominant shape of MPs recorded, most of which accumulated in the gills and digestive glands of all bivalve samples, with the majority falling within the size range of 300-2000 µm. MPs found in all studied species had relatively similar chemical compositions, mainly composed of polypropylene (PP) and polyethylene (PE). In this study, a diverse diet consisting of different bivalve species and detailed data on the consumption rate of these species were used to assess the human health risk of MPs dedicated to the coastal communities of Vietnam. The results suggested a significant part of MP uptake by human could be via bivalve consumption, in which removing viscera and proper depuration should be applied prior to eating, thereby reducing the risk.

Microplastics in sediments from urban and suburban rivers: Influence of sediment properties.

Although sediments are considered to be a major sink for microplastics (MP), there is still a relative lack of knowledge on the factors that influence the occurrence and abundance of MP in riverine sediments. The present study investigated the occurrence and distribution of MP in riverine sediments collected at twelve sites representative of different populated and urbanized rivers (To Lich, Nhue and Day Rivers) located in the Red River Delta (RRD, Vietnam, during dry and rainy seasons. MP concentrations ranged from 1600 items kg-1 dw to 94,300 items kg-1dw. Fiber shape dominated and MP were made of polypropylene (PP) and polyethylene (PE) predominantly. An absence of seasonal effect was observed for both fragments and fibers for each rivers. Decreasing MP concentrations trend was evidenced from the To Lich River, to the Nhue River and to the Day River, coupled with a decreasing fiber length and an increasing fragment area in the surface sediment from upstream to downstream. Content of organic matter was correlated to MP concentrations suggesting that, high levels of organic matter could be MP hotspots in urban rivers. Also, high population density as well as in highly residential areas are related to higher MP concentrations in sediments. Finally, a MP high ecological risk (RI: 866 to 4711) was calculated in the RDD.

Assessment of microplastic contamination in the Loire River (France) throughout analysis of different biotic and abiotic freshwater matrices.

The contamination of microplastics (MP) in freshwater environments represent a major way for the MP transport in the environment. The assessment of MP pollution in freshwater compartments is then important to visualize the pressure and the impacts on medium, and to set up necessary measures. In this context, this study focused on the influence of anthropogenic activities of a medium French city (Angers) on MP levels in samples collected from the Loire River, the longest river in France. Abiotic and biotic matrices were collected upstream and downstream Angers. A first analysis was performed based on microscopy to determine the size, colour and shape of suspected MP and a complementary analysis by µ-FTIR (micro-Fourier Transform InfraRed) was conducted to determine the composition of plastic particles. Three organisms belonging to different trophic levels were studied: when the MP level was expressed per individual, the lowest abundance of MP was found in Tubifex sp. Followed by Corbicula fluminea, while the highest was measured in Anguilla anguilla. To establish the relationship with their habitat, the presence of MP in sediment and water was also analysed. Therefore, this works constitutes a complete overview of the MP levels in freshwater abiotic and biotic matrices. Overall, the presence of MP in analysed samples did not follow a particular pattern, neither in the sites nor matrices: the characteristics depending on a multifactorial outcome (feeding mode, organism size …). However, correlation of MP pattern between clams and sediment was quite evident, while the one between worms and their habitat was not. This demonstrates the relevance of investigating plastic contamination both in biotic and abiotic matrices. Finally, a standardisation of sampling and analytical analysis protocols would be helpful to make comparisons between studies more robust.

Selection of a density separation solution to study microplastics in tropical riverine sediment.

Microplastics (MPs) are small (< 5 mm) plastic particles that are widely found in marine, freshwater, terrestrial and atmospheric environments. Due to their prevalence and persistence, MPs are considered an emerging contaminant of environmental concern. The separation and quantitation of MPs from freshwater sediments is a challenging and critical issue. It is necessary to identify the fate and sources of MPs in the environment, minimise their release and adverse effects. Compared to marine sediments, standardised methods for extracting and estimating the amount of MPs in freshwater sediments are relatively limited. The present study focuses on MP recovery efficiency of four commonly used salt solutions (NaCl, NaI, CaCl2 and ZnCl2) for isolating MPs during the density separation step from freshwater sediment. Known combinations of artificial MP particles (PS, PE, PVC, PET, PP and HDPE) were spiked into standard river sediment. Extraction using NaI, ZnCl2 and NaCl solutions resulted in higher recovery rates from 37 to 97% compared to the CaCl2 solution (28-83%) and varied between polymer types. Low-density MPs (PE, HDPE, PP and PS) were more effectively recovered (> 87%) than the denser polymers (PET and PVC: 37 to 88.8%) using NaCl, NaI and ZnCl2 solutions. However, the effective flotation of ZnCl2 and NaI solutions is relatively expensive and unsafe to the environment, especially in the context of developing countries. Therefore, considering the efficiency, cost and environmental criteria, NaCl solution was selected. The protocol was then tested by extracting MPs from nine riverine sediment samples from the Red River Delta. Sediments collected from urban rivers were highly polluted by MPs (26,000 MPs items·kg-1 DW) compared to sediments located downstream. Using a NaCl solution was found to be effective in this case study and might also be used in long-term and large-scale MP monitoring programmes in Vietnam.

Microplastics in Asian freshwater ecosystems: Current knowledge and perspectives.

Plastic pollution in freshwater ecosystems, including microplastics (MPs) smaller than 5 mm, has become an emerging global concern. Asia is considered a "hot spot" for plastic pollution due to rapid economic and demographic growth, together with rapid urbanization. Here, we provide an overview of the current knowledge on MP abundance, sources, fate, and transfer in Asian freshwater ecosystems based on publications from January 2014 to May 2021. MP contamination in freshwater compartments, including water, sediment, and biota, was found to vary strongly. In water, it ranged from 0.004 items m-3 in a moderately urbanized region to more than 500,000 items m-3 in a dumping river in a highly populated watershed. In the sediment, MP abundance ranged from 1 to more than 30,000 items kg-1 dry weight. Polyethylene (PE) and polypropylene (PP) were predominant in both water and sediment compartments. MP was detected in biota samples from all the studied species, but their abundance depended on the locations and species studied. Overall, MP characteristics (form, size, color, and polymer type) depended on sources and natural constraints (mainly hydrodynamics). This study also revealed that MP in Asian freshwater ecosystems mainly originated from domestic wastewater/runoff, followed by industrial emissions, fisheries and aquaculture wastewater. Plastic waste is not efficiently recycled or incinerated in Asia, leading to MP transfer and accumulation in the aquatic environment, and, more importantly, to ingestion by low to high trophic level organisms. This work highlights several knowledge gaps to guides future research to improve MP pollution management for the sustainable development of highly populated regions such as Asia.