Submicron aerosol pollution in Greater Cairo (Egypt): A new type of urban haze?

Greater Cairo, the largest megacity of the Middle East North Africa (MENA) region, is currently suffering from major aerosol pollution, posing a significant threat to public health. However, the main sources of pollution remain insufficiently characterized due to limited atmospheric observations. To bridge this knowledge gap, we conducted a continuous 2-month field study during the winter of 2019-2020 at an urban background site, documenting for the first time the chemical and physical properties of submicron (PM1) aerosols. Crustal material from both desert dust and road traffic dust resuspension contributed as much as 24 % of the total PM1 mass (rising to 66 % during desert dust events), a figure not commonly observed in urban environments. Our observations showed significant decreases in black carbon concentrations and ammonium sulfate compared to data from 15 years ago, indicating an important reduction in both local and regional emissions as a result of effective mitigation measures. The diurnal variability of carbonaceous aerosols was attributed to emissions emanating from local traffic at rush hours and nighttime open biomass burning. Surprisingly, semi-volatile ammonium chloride (NH4Cl) originating from local open biomass and waste burning was found to be the main chemical species in PM1 over Cairo. Its nighttime formation contributed to aerosol water uptake during morning hours, thereby playing a major role in the build-up of urban haze. While our results confirm the persistence of a significant dust reservoir over Cairo, they also unveil an additional source of highly hygroscopic (semi-volatile) inorganic salts, leading to a unique type of urban haze. This haze, with dominant contributors present in both submicron (primarily as NH4Cl) and supermicron (largely as dust) modes, underscores the potential implications of heterogeneous chemical transformation of air pollutants in urban environments.

Emission of volatile organic compounds from residential biomass burning and their rapid chemical transformations.

Biomass combustion releases a complex array of Volatile Organic Compounds (VOCs) that pose significant challenges to air quality and human health. Although biomass burning has been extensively studied at ecosystem levels, understanding the atmospheric transformation and impact on air quality of emissions in urban environments remains challenging due to complex sources and burning materials. In this study, we investigate the VOC emission rates and atmospheric chemical processing of predominantly wood burning emissions in a small urban centre in Greece. Ioannina is situated in a valley within the Dinaric Alps and experiences intense atmospheric pollution accumulation during winter due to its topography and high wood burning activity. During pollution event days, the ambient mixing ratios of key VOC species were found to be similar to those reported for major urban centres worldwide. Positive matrix factorisation (PMF) analysis revealed that biomass burning was the dominant emission source (>50 %), representing two thirds of OH reactivity, which indicates a highly reactive atmospheric mixture. Calculated OH reactivity ranges from 5 s-1 to an unprecedented 278 s-1, and averages at 93 ± 66 s-1 at 9 PM, indicating the presence of exceptionally reactive VOCs. The highly pronounced photochemical formation of organic acids coincided with the formation of ozone, highlighting the significance of secondary formation of pollutants in poorly ventilated urban areas. Our findings underscore the pressing need to transition from wood burning to environmentally friendly sources of energy in poorly ventilated urban areas, in order to improve air quality and safeguard public health.

Comprehensive chemical characterization of PM2.5 in the large East Mediterranean-Middle East city of Beirut, Lebanon.

The chemical composition of PM2.5 at two sites in Lebanon, a country in the East Mediterranean - Middle East region, is investigated in the spring and summer seasons. The average PM2.5 concentrations were of (29 ± 16) µg/m3 for Beirut urban site and (32 ± 14) µg/m3 for Beirut suburban site. This study showed that the geographic location of the East Mediterranean region, such as its proximity to the Mediterranean Sea and the dust storm intrusion are a significant contributor to the high PM levels from natural sources, which cannot be mitigated, rendering the PM2.5 WHO annual Air Quality guideline unattainable due to high natural background, which also applies to the entire Middle East region. Turkey and Eastern Europe are the dominant origin of air masses throughout our sampling days, suggesting the long-range transport as an important potential contributor to the high observed concentrations of V, Ni, and sulfate in this region most probably in other East Mediterranean countries than Lebanon too. Main local sources determined through the chemical speciation including organics are road transport, resuspension of dust and diesel private generators. A health risk assessment of airborne metals was performed and the carcinogenic risk for all the metals exceeded by 42 (adults) and 14 (children) times the acceptable risk level (10-6) at both sites. Vanadium was the predominant carcinogenic metal, emphasizing the need to replace energy production with cleaner energy on a regional level and highlighting the severe impact of air pollution on the health of inhabitants in this region's main cities.

Fine aerosol sources at an urban background site in the Eastern Mediterranean (Nicosia; Cyprus): Insights from offline versus online source apportionment comparison for carbonaceous aerosols.

A total of 348 daily PM2.5 samples were collected at an urban background site of Nicosia, capital of Cyprus, for one-year period (October 2018-October 2019) to assess the origin and sources of fine PM at the Eastern Mediterranean, a poorly characterized area of the world. The samples were analysed for water soluble ionic species, elemental and organic carbon, carbohydrates and trace metals, the combination of which were utilized to identify pollution sources by applying Positive Matrix Factorization (PMF). Six PM2.5 sources, namely long-range transport (LRT; 38 %), traffic (20 %), biomass burning (16 %), dust (10 %), sea salt (9 %) and heavy oil combustion (7 %), were identified. Despite sampling in an urban agglomeration, the chemical fingerprint of the aerosol is largely dictated by air mass origin rather than local sources. Springtime is characterized by the most elevated particulate levels due to the southerly air masses carrying particles from the Sahara Desert. Northerlies are observed throughout the year but are predominant during summer allowing the LRT source to peak (54 % during summer). Only during winter, due to extensive use of biomass combustion for domestic heating (36.6 % during winter), local sources dominate. A co-located online PMF source apportionment of submicron carbonaceous aerosols (Organic Aerosols, OA; Black Carbon) was performed by the means of an Aerosol Chemical Speciation Monitor (for OA) and an Aethalometer (for BC) for a four-month period. The comparison between the two methodologies allowed to better assess the robustness and limitations of the two methodologies. More specifically, LRT OA and biomass burning BC apportioned by the offline PMF showed a strong consistency with the online apportioned more oxidized oxygenated OA and BCwb, respectively; cross validating these sources. On the other hand, our traffic factor may contain additional hydrocarbon-like OA and BC from fossil fuel sources other than just vehicular emissions. Finally, the offline biomass burning OA source is likely to contain both primary and secondary OA.

Source apportionment of PM2.5 using organic/inorganic markers and emission inventory evaluation in the East Mediterranean-Middle East city of Beirut.

Source contributions to PM2.5 concentrations were evaluated in Greater Beirut (Lebanon), a typical East Mediterranean-Middle East (EMME) city, using Positive Matrix Factorization with two approaches. The first approach included only inorganic species (PMF-trad) and the other approach added organic markers (PMF-org). PMF-org identified 4 additional sources, and large discrepancies in contributions were observed for some major sources found in both approaches, highlighting the importance of including organic markers. The traffic factor was underestimated in PMF-trad by 2 to 7 folds. Moreover, results showed that this city is prone to high desert dust concentrations originating from uncontrollable dust storm events, like all cities in the Middle East. A PM2.5 mitigation plan taking into account the potency of the identified sources was developed. Sources like diesel generators or traffic presented smaller contributions in term of mass compared to desert dust, however the health impact of the latter is relatively small and actions should target sources with the highest potency. Local emission inventories in the EMME region are scarce and studies typically rely on global emission inventories for local air quality management plans, but these inventories significantly underestimate Beirut's road transport emissions by more than an order of magnitude.

Exposure to airborne SARS-CoV-2 in four hospital wards and ICUs of Cyprus. A detailed study accounting for day-to-day operations and aerosol generating procedures.

In any infectious disease, understanding the modes of transmission is key to selecting effective public health measures. In the case of COVID-19 spread, the strictness of the imposed measures outlined the lack of understanding on how SARS-CoV-2 transmits, particularly via airborne pathways. With the aim to characterize the transmission dynamics of airborne SARS-CoV-2, 165 and 62 air and environmental samples, respectively, were collected in four COVID-19 wards and ICUs in Cyprus and analyzed by RT-PCR. An alternative method for SARS-CoV-2 detection in air that provides comparable results but is less cumbersome and time demanding, is also proposed. Considering that all clinics employed 14 regenerations per hour of full fresh air inside patient rooms, it was hypothesized that the viral levels and the frequency of positive samples would be minimum outside of the rooms. However, it is shown that leaving the door opened in patient rooms hinders the efficiency of the ventilation system applied, allowing the virus to escape. As a result, the highest observed viral levels (135 copies m-3) were observed in the corridor of a ward and the frequency of positive samples in the same area was comparable to that inside a two-bed cohort. SARS-CoV-2 in that corridor was found primarily to lie in the coarse mode, at sizes between 1.8 and 10 µm. Similar to previous studies, the frequency of positive samples and viral levels were the lowest inside intensive care units. However, if a patient with sufficient viral load (Ct-value 31) underwent aerosol generating procedures, positive samples with viral levels below 45 copies m-3 were acquired within a 2 m distance of the patient. Our results suggest that a robust ventilation system can prevent unnecessary exposure to SARS-CoV-2 but with limitations related to foot traffic or the operations taking place at the time.

European aerosol phenomenology - 8: Harmonised source apportionment of organic aerosol using 22 Year-long ACSM/AMS datasets.

Organic aerosol (OA) is a key component of total submicron particulate matter (PM1), and comprehensive knowledge of OA sources across Europe is crucial to mitigate PM1 levels. Europe has a well-established air quality research infrastructure from which yearlong datasets using 21 aerosol chemical speciation monitors (ACSMs) and 1 aerosol mass spectrometer (AMS) were gathered during 2013-2019. It includes 9 non-urban and 13 urban sites. This study developed a state-of-the-art source apportionment protocol to analyse long-term OA mass spectrum data by applying the most advanced source apportionment strategies (i.e., rolling PMF, ME-2, and bootstrap). This harmonised protocol was followed strictly for all 22 datasets, making the source apportionment results more comparable. In addition, it enables quantification of the most common OA components such as hydrocarbon-like OA (HOA), biomass burning OA (BBOA), cooking-like OA (COA), more oxidised-oxygenated OA (MO-OOA), and less oxidised-oxygenated OA (LO-OOA). Other components such as coal combustion OA (CCOA), solid fuel OA (SFOA: mainly mixture of coal and peat combustion), cigarette smoke OA (CSOA), sea salt (mostly inorganic but part of the OA mass spectrum), coffee OA, and ship industry OA could also be separated at a few specific sites. Oxygenated OA (OOA) components make up most of the submicron OA mass (average = 71.1%, range from 43.7 to 100%). Solid fuel combustion-related OA components (i.e., BBOA, CCOA, and SFOA) are still considerable with in total 16.0% yearly contribution to the OA, yet mainly during winter months (21.4%). Overall, this comprehensive protocol works effectively across all sites governed by different sources and generates robust and consistent source apportionment results. Our work presents a comprehensive overview of OA sources in Europe with a unique combination of high time resolution (30-240 min) and long-term data coverage (9-36 months), providing essential information to improve/validate air quality, health impact, and climate models.