Safety assessment of sand casting explosion accidents by testing cavity pressure of the sand mold to protect employee health.

Excessive cavity pressure may result in a sand casting explosion, and corresponding measures should be adopted to prevent these consequences. In this study, the pressure variations in the cavity were first investigated based upon on-site testing by taking the resin contents into consideration, and then the evolution characteristics of sand casting explosion accidents were analyzed in depth by system dynamics, chaos theory, and the bow-tie model. When the resin contents are 1.3 wt%, 1.4 wt%, and 1.5 wt%, the pressures of the gas vent increase by 27.0 Pa, 32.8 Pa, and 35.6 Pa, respectively. To reduce the pressure of the cavity, the resin content should be reduced. The evolutionary process of sand casting explosion accidents has a noticeable butterfly effect and randomness, whose occurrence is comprehensively affected by human, object, environment, management and emergency subsystems. The leading causes of sand casting explosion accidents mainly include the extensive gas evolution characteristics of foundry sand, cavity exhaust blockage, and inadequate safety monitoring. The leading consequences of sand casting explosion accidents mainly include casualties, secondary disasters, and social panic. The implications of these findings concerning sand casting explosion accidents can be regarded as the foundation for accident prevention in practice.

Evaluation of immunogenicity and cross-reactive responses of vaccines prepared from two chimeric serotype O foot-and-mouth disease viruses in pigs and cattle.

Foot-and-mouth disease (FMD) remains a very serious barrier to agricultural development and the international trade of animals and animal products. Recently, serotype O has been the most prevalent FMDV serotype in China, and it has evolved into four different lineages: O/SEA/Mya-98, O/ME-SA/PanAsia, O/ME-SA/Ind-2001 and O/Cathay. PanAsia-2, belonging to the O/ME-SA topotype, is prevalent in neighbouring countries and poses the risk of cross-border spread in China. This study aimed to develop a promising vaccine candidate strain that can not only provide the best protection against all serotype O FMDVs circulating in China but also be used as an emergency vaccine for the prevention and control of transboundary incursion of PanAsia-2. Here, two chimeric FMDVs (rHN/TURVP1 and rHN/NXVP1) featuring substitution of VP1 genes of the O/TUR/5/2009 vaccine strain (PanAsia-2) and O/NXYCh/CHA/2018 epidemic strain (Mya98) were constructed and evaluated. The biological properties of the two chimeric FMDVs were similar to those of the wild-type (wt) virus despite slight differences in plaque sizes observed in BHK-21 cells. The structural protein-specific antibody titres induced by the rHN/TURVP1 and wt virus vaccines in pigs and cows were higher than those induced by the rHN/NXVP1 vaccine at 28-56 dpv. The vaccines prepared from the two chimeric viruses and wt virus all induced the production of protective cross-neutralizing antibodies against the viruses of the Mya-98, PanAsia and Ind-2001 lineages in pigs and cattle at 28 dpv; however, only the animals vaccinated with the rHN/TURVP1 vaccine produced a protective immune response to the field isolate of the Cathay lineage at 28 dpv, whereas the animals receiving the wt virus and the rHN/NXVP1 vaccines did not, although the wt virus and O/GXCX/CHA/2018 both belong to the Cathay topotype. This study will provide very useful information to help develop a potential vaccine candidate for the prevention and control of serotype O FMD in China.

Quantitative Detection of the Foot-And-Mouth Disease Virus Serotype O 146S Antigen for Vaccine Production Using a Double-Antibody Sandwich ELISA and Nonlinear Standard Curves.

The efficacy of an inactivated foot-and-mouth disease (FMD) vaccine is mainly dependent on the integrity of the foot-and-mouth disease virus (FMDV) particles. At present, the standard method to quantify the active component, the 146S antigen, of FMD vaccines is sucrose density gradient (SDG) analysis. However, this method is highly operator dependent and difficult to automate. In contrast, the enzyme-linked immunosorbent assay (ELISA) is a time-saving technique that provides greater simplicity and sensitivity. To establish a valid method to detect and quantify the 146S antigen of a serotype O FMD vaccine, a double-antibody sandwich (DAS) ELISA was compared with an SDG analysis. The DAS ELISA was highly correlated with the SDG method (R2 = 0.9215, P<0.01). In contrast to the SDG method, the DAS ELISA was rapid, robust, repeatable and highly sensitive, with a minimum quantification limit of 0.06 µg/mL. This method can be used to determine the effective antigen yields in inactivated vaccines and thus represents an alternative for assessing the potency of FMD vaccines in vitro. But it still needs to be prospectively validated by analyzing a new vaccine preparation and determining the proper protective dose followed by an in vivo vaccination-challenge study to confirm the ELISA findings.

In situ hydroxyapatite nanofiber growth on calcium borate silicate ceramics in SBF and its structural characteristics.

A novel calcium silicate borate Ca11Si4B2O22 ceramic was firstly prepared by the conventional solid-state reaction. In vitro hydroxyapatite mineralization was investigated by soaking the ceramics in simulated body fluid (SBF) solutions at body temperature (37 °C) for various time periods. Scanning electron microscopy (SEM) and X-ray diffraction analysis (XRD) measurements were applied to investigate the samples before and after the immersion of ceramics in SBF solution. The elemental compositions of a hydroxyapatite layer on the ceramics during the mineralization were confirmed by X-ray energy-dispersive spectra (EDS). Meanwhile, the bending strength and elastic modulus of Ca11Si4B2O22 ceramics were also measured, which indicate that the biomaterials based on Ca11Si4B2O22 ceramics possess bioactivity and might be a potential candidate as biomaterials for hard tissue repair. The bioactive mineralization ability was evaluated on the base of its crystal structural characteristics, i.e., silanol (Si-OH) and B-OH groups can be easily induced on the surface of Ca11Si4B2O22 ceramics soaked in SBF solutions.

Probe spectrum measurements of Eu3+ ions as a relevant tool for monitoring in vitro hydroxyapatite formation in a new borate biomaterial.

CaB2O4 powders and ceramics were prepared by the conventional solid-state reaction. In vitro hydroxyapatite (HA) mineralization was investigated by soaking the samples in simulated body fluid (SBF) for various time periods. X-ray diffraction and structural refinements, scanning electron microscopy and X-ray energy-dispersive spectra measurements were applied to investigate apatite formation before and after immersion in SBF. HA can easily form flower-like nanostructures with nano-needles even when soaked in SBF for several hours. The in vitro bioactivity of CaB2O4 was attributed to easy formation of B-OH groups in the CaB2O4 structure when soaked in SBF solutions. In the process of mineralization, the luminescence evolution of Eu3+ ions, a well-known structural probe, was detected by photoluminescence spectra and photoluminescence decay curves. This suggested that the process of mineralization can be monitored by the luminescence intensity of Eu3+ ions in the mineralization products. The current study will open up a new and simple in vivo avenue for in situ monitoring of hydroxyapatite conversion using a fiber luminescence spectrometer.

Experimental studies with foot-and-mouth disease virus type Asia-1, responsible for the 2005 epidemic in China.

This study was carried out to investigate the biological characteristics of the foot-and-mouth disease (FMD) virus strain Asia-1 China/2005, which is responsible for the 2005 epidemic in China. The result showed that this strain is not host restricted, and could not only cause FMD in cattle and sheep but also in pigs by either inoculation or direct contact.

Development and validation of a 3ABC indirect ELISA for differentiation of foot-and-mouth disease virus infected from vaccinated animals.

Non-structural protein (NSP) 3ABC antibody is considered to be the most reliable indicator of present or past infection with foot-and-mouth disease virus (FMDV) in vaccinated animals. An indirect ELISA was established, using purified His-tagged 3ABC fusion protein as antigen, for detection of the antibody response to FMDV NSP 3ABC in different animal species. The method was validated by simultaneous detection of the early antibody responses to NSP and structural protein (SP) in FMDV Asia 1 infected animals. The performance of the method was also validated by detection of antibody in reference sera from the FMD World Reference Laboratory (WRL) in Pirbright, UK, and comparison with two commercial NSP ELISA kits. The results showed that the antibody response to SP developed more quickly than that to NSP 3ABC in FMDV infected animals. In contact-infected cattle, the antibody response to NSP 3ABC was significantly delayed compared with that to SP antibody. The early antibody responses to SP and NSP 3ABC in FMDV inoculated cattle and contact-infected or inoculated sheep and pigs were generally consistent. In pigs, 3ABC antibody was linked to the presence of clinical signs; however, in sheep, subclinical infection was detected by the development of 3ABC antibodies. Therefore, the antibody responses to 3ABC varied between host species. Eight out of 10 positive serum samples from FMD WRL were tested to be positive at cutoff value of 0.2. The rate of agreement with the ceditest FMDV-NS and the UBI NSP ELISA were 98.05% (302/308) and 93.2% (287/308), respectively. The prevalence of 3ABC antibodies reached 71.4% in some diseased cattle herds. The further work is required to evaluation the performance of this method in different animal species and different field situations.

[Expression of recombinant plasmid pcDNA3.1/P12X3C with multi-genes of foot-and-mouth disease virus in BHK-21 cells].

In order to obtain the gene P12X3C of Foot-and-Mouth Disease Virus (FMDV) that includes full length P1, 2A, 3C and a part of 2B, the site mutation strategy was used. After being digested by Kpn I and Xba I respectively, the gene P12X3C was cloned into the pcDNA3.1 (+) expression vector. The recombinant plasmid was checked by restriction enzyme analysis and nucleic acid sequencing, and then named pcDNA3.1/P12X3C. Further, BHK-21 cells was transfected with pcDNA3.1/P12X3C by using lipoid. The proteins of Foot-and-Mouth Disease Virus, which were expressed in BHK-21 cells, were confirmed by sandwich-ELISA and fluoroscopy. The result shows the gene P12X3C is cloned into eukaryotic expression plasmid, and the recombinant eukaryotic expression plasmid pcDNA3.1/P12X3C could express proteins of Foot-and-Mouth Disease Virus in BHK-21 cells, which have immunocompetence. This study demonstrates that delivery of a recombinant eukaryotic expression plasmid containing P12X3C coding regions results in the assembly of FMDV capsid structures, which will offer experimental base to DNA vaccine of FMDV.