RESUMO
The International Commission on Radiological Protection (ICRP), recently expressed concern that "a shortage of investment in training, education, research, and infrastructure seen in many sectors and countries may compromise society's ability to properly manage radiation risks" and in 2022 announced the "Vancouver call for action to strengthen expertise in radiological protection worldwide". As representatives of organisations in formal relations with ICRP, we decided to promote this position paper to declare and emphasise that strengthening the expertise in radiological protection is a collective priority for all of us.
Assuntos
Agências Internacionais , Proteção Radiológica , HumanosRESUMO
The European Association of National Metrology Institutes (EURAMET) within its research programme European Metrology Programme for Innovation and Research (EMPIR) funded project EMPIR 19NET03 supportBSS that contributes to the establishment of a European Metrology Network (EMN) for Radiation Protection (RP). The EMN-RP was established in September 2021 with the intent to work as a meeting point for the metrology community and all stakeholders in the field of ionising radiation regulation, thus providing quality assurance for measurements in each of the exposure situations contemplated in the European Legislation. Within project EMPIR 19NET03, work package 3 aims at the preparation of a Strategic Research Agenda (SRA) by identifying the metrology needs to support the European legislation and regulation in Radiation Protection and of two Roadmaps for metrology services, one under the European Council Directive 2013/59/EURATOM and the other under the EURATOM Treaty. Following a Gaps Workshop held in September 2020 and a second internal workshop that took place in April 2022, a questionnaire was prepared for distribution to the stakeholders, e.g. RP platforms and authorities, academia, industry, among other, together with an accompanying paper. In this paper, the authors present the state of the art of European legislation in RP, address the importance of metrology, the practices and activities that need metrology to meet the requirements set in the regulations, emphasise the need for quality assured measurements in all fields, highlight the stakeholders contributions in their specific area and show their vision of the EMN-RP.
Assuntos
Proteção Radiológica , União Europeia , Indústrias , Radiação IonizanteRESUMO
In the framework of the EMPIR project traceRadon, stable atmospheres with low-level radon activity concentrations have to be produced for calibrating radon detectors designed to measure outdoor air activity concentrations. The traceable calibration of these detectors at very low activity concentrations is of special interest to the radiation protection, climate observation, and atmospheric research communities. Radiation protection networks (such as the EUropean Radiological Data Exchange Platform (EURDEP)) and atmospheric monitoring networks (such as the Integrated Carbon Observation System (ICOS)) need reliable and accurate radon activity concentration measurements for a variety of reasons, including: the identification of Radon Priority Areas (RPA); improving the sensitivity and reliability of radiological emergency early warning systems (Melintescu et al., 2018); for more reliable application of the Radon Tracer Method (RTM) to estimate greenhouse gas (GHG) emissions; for improved global "baseline" monitoring of changing GHG concentrations and quantification of regional pollution transport (Chambers et al., 2016), (Chambers et al., 2018); and for evaluating mixing and transport parameterisations in regional or global chemical transport models (CTMs) (Zhang et al., 2021), (Chambers et al., 2019). To achieve this goal, low activity sources of radium with a variety of characteristics were produced using different methods. Sources ranging from MBq 226Ra down to several Bq 226Ra were developed and characterised during the evolution of production methods, and uncertainties below 2 % (k=1) were achieved through dedicated detection techniques, even for the lowest activity sources. The uncertainty of the lowest activity sources was improved using a new online measurement technique for which the source and detector were combined in the same device. This Integrated Radon Source Detector device, henceforth an IRSD, reaches a counting efficiency approaching 50 % through detection under quasi 2π sr solid-angle. At the time of this study the IRSD was already produced with 226Ra activities between 2 Bq and 440 Bq. To compare the working performance of the developed sources (i.e., to establish a reference atmosphere), study the stability of the sources, and to establish traceability to national standards, an intercomparison exercise was carried out at the PTB facility. Here we present the various source production techniques, the determination of their radium activity, and determination of their radon emanation (including assigned uncertainties). This includes details of the implementation of the intercomparison set-up, and a discussion of the results of the source characterisations.
RESUMO
Laser resonance ionization at the RISIKO 30 kV mass separator has been used to produce isotopically and isobarically pure and well quantified 222Rn emanation standards. Based upon laser-spectroscopic preparation studies, ion implantation into aluminum and tungsten targets has been carried out, providing overall implantation efficiencies of 40% up to 60%. The absolute implanted activity of 226Ra was determined by the technique of defined solid-angle α-particle spectrometry, where excellent energy resolution was observed. The 222Rn emanation coefficient of the produced targets was studied using α-particle and γ-ray spectrometry, and yielded results between 0.23 and 0.34, with relative uncertainty on the order of 1%. No dependence exceeding a 1% change of the emanation on humidity could be identified in the range of 15 %rH to 75 %rH, whereas there were hints of a slight correlation between the emanation and temperature. Additionally, and as expected, the emanation coefficient was found to be dependent on the target material as well as the implanted dose.
RESUMO
In this work, a novel approach for the standardization of low-level 222Rn emanation is presented. The technique is based on the integration of a 222Rn source, directly, with an α-particle detector, which allows the residual 222Rn to be continuously monitored. Preparation of the device entails thermal physical vapor deposition of 226RaCl2 directly onto the surface of a commercially available ion implanted Si-diode detector, resulting in a thin-layer geometry. This enables continuous collection of well resolved α-particle spectra of the nuclei, decaying within the deposited layer, with a detection efficiency of approximately 0.5 in a quasi 2π geometry. The continuously sampled α-particle spectra are used to derive the emanation by statistical inversion. It is possible to achieve this with high temporal resolution due to the small background and the high counting efficiency of the presented technique. The emanation derived in this way exhibits a dependence on the relative humidity of up to 15% in the range from 20% rH to 90% rH. Traceability to the SI is provided by employing defined solid-angle α-particle spectrometry to characterize the counting efficiency of the modified detectors. The presented technique is demonstrated to apply to a range covering the release of at least 1 to 210 222Rn atoms per second, and it results in SI-traceable emanation values with a combined standard uncertainty not exceeding 2%. This provides a pathway for the realization of reference atmospheres covering typical environmental 222Rn levels and thus drastically improves the realization and the dissemination of the derived unit of the activity concentration concerning 222Rn in air.
Assuntos
Poluentes Radioativos do Ar , Monitoramento de Radiação , Radônio , Poluentes Radioativos do Ar/análise , Radônio/análiseRESUMO
New emanation sources for Rn-222 have been developed by electrodeposition of Ra-226 onto stainless-steel discs. With a high resolution of up to 20â¯keV FWHM in the Ra-226 peak at 4.87â¯MeV, defined solid-angle alpha-particle spectrometry is the method of choice to determine the deposited Ra-226 activity. The amount of emanating Rn-222 is determined by gamma-ray spectrometry using HPGe-detectors. The measurement is based on the distorted equilibrium of the Ra-226 decay chain due to Rn-222 emanation. Comparative gamma-ray spectrometric measurements with sealed, Rn-222 tight sources of the same type and geometry make the knowledge of emission probabilities and detection efficiency unnecessary. The new emanation sources allow the production of stable reference atmospheres in the regime below 300 Bqâ m-3 with uncertainties not exceeding 2% for kâ¯=â¯1.
RESUMO
For routine calibration of dosemeters used for environmental radiation monitoring, a low dose rate 137Cs gamma ray calibration field that fully satisfies the requirement of the ISO 4037 series was established in the Facility of Radiation Standards in Japan Atomic Energy Agency. Two different methods were employed to determine the reference air kerma rate, namely a conventional ionisation chamber and a G(E) function method used a newly developed scintillation spectrometer. To fulfil the requirement of the ISO 4037 and suppress scattering of Cs gamma ray within the room as far as possible, a suitable lead collimator was introduced to limit the irradiation area at test points and placed at the middle height in an irradiation room with a grating floor. From measured results of de-convoluted photon fluence spectrum and the variation of evaluated reference air kerma rates between 1.0 m and 3.0 m from the centre of the source, gamma ray scattering from the room structures was found to be negligible. The reference air kerma rate at distances between1.0 m and 3.0 m could be then interpolated by simply considering the inverse square law of the distance and air attenuation. The resulting Cs gamma ray calibration field could provide ambient dose equivalent rates of 0.7-7.2 µSv h-1 for use with environmental radiation monitoring devices. Finally, we attempted to calibrate a widely used NaI(Tl) scintillation survey metre, obtaining a quite satisfactory calibration factor. These results also imply that such survey metres can be employed to monitor affected areas and assess the progress of decontamination, as they can provide appropriate measurements of the ambient dose equivalent rate.
Assuntos
Radioisótopos de Césio/análise , Raios gama , Monitoramento de Radiação/instrumentação , Monitoramento de Radiação/normas , Contagem de Cintilação/instrumentação , Calibragem , Humanos , Método de Monte Carlo , Monitoramento de Radiação/métodos , Contagem de Cintilação/métodosRESUMO
Closed nuclear track detectors are widely used for the determination of Rn-222 exposures. There are also partial open systems available, which are specially designed for the determination of the exposure to Rn-220, which is a relevant exposure in special workplaces or in specific regions of the world. This paper presents data and a detail analysis of how to determine the cross-correlation by calibration in pure Rn-222 and pure Rn-220 atm. By these means calibration coefficients for the analysis of real mixed atmospheres can be obtained. The respective decision threshold, detection limit and limits of the confidence interval were determined according to ISO 11929 (ISO 11929:2010, 2010). The exposure of detectors was performed at the radon reference chamber and the thoron progeny chamber of the Physikalisch-Technische Bundesanstalt (PTB). The analysis of track response was done at Parc RGM, while the analytical routines were developed in the Leibniz University Hanover, Institute Radioökologie und Strahlenschutz IRS at the working Group AK SIGMA (Arbeitskreis Nachweisgrenzen).
RESUMO
The upcoming revision of Council Directive 96/29/Euratom in the form of the proposed basic safety standards for protection against the dangers arising from exposure to ionizing radiation (BSS) evokes new challenges for the metrology institutes. In the case of the two radon isotopes, the corresponding public exposure will be part of legal metrology for the first time. Since the levels of activity concentration that are laid down in the draft of the BSS cover the range from 200 Bq/m(3) to 300 Bq/m(3) in general (with an exceptional top level of 1000 Bq/m(3)), new calibration procedures for existing commercial monitors with their limited counting statistic have to be developed. This paper gives an overview how this metrological challenge can be overcome.
Assuntos
Monitoramento de Radiação/instrumentação , Radônio/análise , Calibragem , Exposição Ambiental , Radônio/normasRESUMO
A large volume transfer standard has been developed to calibrate commercial radon measurement devices in a homogeneous Rn-222 reference atmosphere. The transfer standard serves for the realization, maintenance and dissemination of the unit Bq/m(3) below 1 kBq/m(3). The transfer standard consists of a multi-wire impulse ionization chamber, electronic measurement equipment and the corresponding software. The multi-wire impulse ionization chamber is composed of two parallel printed boards. Between the boards, 478 vertical electrode wires are soldered in to include a volume of 10 L. In the dependency of the energy, the α-particles of Rn-222 and the decay products are detected in the active volume of the multi-wire impulse ionization chamber. By means of the measurement software an α-energy spectrum is produced. Via different algorithms, the activity concentration of the Rn-222 reference atmosphere is determined.
RESUMO
In order to calibrate measurement devices for the activity concentration of Rn-222 (radon) in air below 1,000 Bq/m(3), a constant for long time (>5d), homogeneous reference atmosphere is created by a certified activity in a certified volume. The PTB developed this reference atmosphere from 150 Bq/m(3) to 2,000 Bq/m(3) based on the precisely known emanation of Rn-222 from a Ra-226 activity standard. This set-up reduces uncertainties and increases the range of traceability for commercial radon measurement devices. Thus, a gap in radon metrology is closed. The new primary standard for reference atmospheres is realised with a combined relative standard uncertainty of 1.1%.
Assuntos
Poluentes Radioativos do Ar/análise , Poluentes Radioativos do Ar/normas , Atmosfera/análise , Monitoramento de Radiação/métodos , Monitoramento de Radiação/normas , Radônio/análise , Radônio/normas , Alemanha , Doses de Radiação , Valores de ReferênciaRESUMO
Due to the short half-life of Rn-220, a primary standard for activity concentration of Rn-220 (thoron) in air (i.e. a homogeneous reference atmosphere consisting of a certified activity in a certified volume) has been considered unachievable in the past. Traceability of Rn-222 reference atmospheres is achievable using radon gas activity standards (Picolo, 1996; Dersch, 1998) and standard volumes, and is an established method (Paul et al., 2002). For the short-lived radionuclide Rn-220 this procedure is not feasible, since no Rn-220 gas activity standard with a reasonable activity can be produced. This leads to a lack of traceability for measurements of Rn-220 activity concentration: only atmospheres monitored by reference instruments (i.e. secondary standards) are available. The new primary standard for the activity concentration of (220)Rn developed by PTB now closes this gap in radon metrology.
Assuntos
Poluentes Radioativos do Ar/normas , Radônio/normas , Ar/análise , Poluentes Radioativos do Ar/análise , Métodos , Radônio/análise , Padrões de Referência , Pesos e MedidasRESUMO
Following completion of the project "Generation and characterisation of reference atmospheres of thoron decay products for the calibration of measuring devices for thoron decay products", the Physikalisch-Technische Bundesanstalt (PTB) now operates a thoron progeny chamber in which (220)Rn (thoron), (222)Rn and its progenies can be made available under almost all ambient conditions. This allows all measuring systems to be calibrated under realistic climatic conditions with an accuracy unique worldwide.