Polycyclic aromatic hydrocarbons (PAHs) in Greater Cairo water supply systems.

Polycyclic aromatic hydrocarbons (PAHs) pose a constant threat to the environment and public health. There are numerous activities in the Greater Cairo area that emit and release significant amounts of PAHs. Concentrations of these PAHs are released into the air and mixed with surface water, limiting its use. In this study, 17 PAH compounds are mapped at eight sites along the Nile River and its tributaries in Greater Cairo. In addition, their removal efficiency is evaluated with the conventional treatment in eight water treatment plants. PAHs were analyzed using GC-MS from January to December 2018. Naphthalene, anthracene, fluorene, pyrene, and phenanthrene were detected. The total amount of PAHs in raw water was highest in Shamal Helwan (1,325 ± 631 ng/l) and lowest in Mostorod (468 ± 329 ng/l), and the removal ranged from 25 to 31%. Further research is needed to integrate other techniques to reduce PAHs using the conventional treatment, and more efforts should be made to reduce the presence and release of PAHs in raw water.

Aluminum sulfate regeneration from surface water treatment waste in Cairo, Egypt.

The world needs to adapt to recycling and reusing water due to limited resources. So, decision-makers and policy leaders should use sustainable practices to improve protection and pollution remediation. Aluminum sulfate is used for surface water treatment, which leads to waste sludge being disposed into water bodies, causing environmental pollution. Coagulants' regeneration from sludge improves water quality and reuse options. Organics accumulation is the primary concern regarding coagulant regeneration, using acidification. Our study investigated the raw water quality, aluminum sulfate, and sludge and evaluated its influence on coagulant recovery, using acidification, from eight water treatment plants (WTPs) in Cairo, Egypt. The significant elements in the tested sludge were aluminum with a concentration range of 86.65-688.85 mg/g sludge in El-Rawda and Embaba and iron with a concentration range of 9.45-7.45 mg/g in Shamal Helwan and El-Fostat. Recovery percentages of aluminum, iron, manganese, and strontium recorded the highest values 97%, 89%, 89%, and 92% for Embaba, Rod El-Farag, Embaba, El-Rawda, respectively. The correlation between metal concentration and recovery was insignificant in the studied matrix and conditions for the four metals. Total organic carbon (TOC) transfer into recovered solutions was maximum in El-Fostat (82.6%) and minimum in Embaba (36.7%). The TOC transfer percentage depends on the matrix of the sludge. The best location for coagulant recovery is at the Embaba WTP, where there were minimum organics transfer and maximum Al recovery.

Repeated Aluminum Sulfate Recovery from Waterworks Sludge: A Case Study in El-Sheikh Zaid WTP.

Although surface water treatment presents a good solution for pollutants in rivers and freshwater lakes, the purification process itself presents a great threat to the aquatic environment through aluminum waste disposal. Recent studies have introduced coagulants recovery from treatment sludge as a green solution for waste handling and cost reduction. This article aims to evaluate repeated aluminum coagulants recovery from sludge using sulfuric acid. The waste from El-Sheikh Zaid Water Treatment Plant (ESZ-WTP) was characterized, then sequential coagulants recovery using optimum conditions was conducted. In addition, treated water was analyzed to determine the efficiency of the obtained coagulants and their influence on treated water quality. Sequential coagulants recovery using acidification revealed that no metals accumulation took place in the produced coagulants until the third recovery from ESZ-WTP sludge. On the other hand, a noticeable increase in trihalomethanes was detected in the treated water, especially using the third recovered coagulant. In conclusion, sequential coagulants recovery and usage in water treatment is an attractive alternative for single-use original coagulant in ESZ-WTP but for no more than three sequential recoveries. It is advisable to apply a fresh coagulant every three sequential recoveries to enrich the aluminum content and regenerate the sludge before restarting the recovery process.

Evaluation of leached metals in recovered aluminum coagulants from water treatment slurry.

The water treatment industry consumes large quantities of coagulant and produces huge amounts of slurry. The cost of alum used in water treatment, stringent regulations and negative impacts of sludge disposal are the motive to do integrated research studies on the technical feasibility of aluminum coagulant recovery from sludge using acidification. This work studied the leaching of iron, manganese, and chromium as the most extracted metals with aluminum during sludge acidification; furthermore, these metals have a great impact on the recovered coagulants' efficiency and treated water quality. The sludge used was collected from El-Sheikh Zayd water treatment plant in Egypt, then dried and ground; afterward, the effect of acid concentration, sludge mass, temperature, mixing speed and mixing time was studied. In addition, it was noticeable that the efficiency of sulfuric acid in leaching iron, manganese and chromium is higher than that of hydrochloric acid. Also, higher leaching for the three metals was obtained in all the experiments using higher acid concentration, elevated temperature, and rotational speed. Finally, the leached metals in recovered aluminum coagulants will not limit its application to water and wastewater treatment, as their concentrations are still very low if compared with aluminum, even with the highest leaching efficiency.

Utilization of Drinking Water Treatment Slurry to Produce Aluminum Sulfate Coagulant.

In Egypt, water treatment consumes about 365 000 tons of aluminum sulfate and produces more than 100 million tons of sludge per year. The common disposal system of sludge in Egypt is to discharge it into natural waterways. Toxicity of aluminum, environmental regulations and costs of chemicals used in water treatment and sludge treatment processes led to an evaluation of coagulant recovery and subsequent reuse. The present work aimed at aluminum recovery from sludge of El-Shiekh Zayd water treatment plant (WTP) to produce aluminum sulfate coagulant. Sludge was characterized and the effect of five variables was tested and the process efficiency was evaluated at different operating conditions. Maximum recovery is 94.2% at acid concentration 1.5 N, sludge weight 5 g, mixing speed 60 rpm, temperature 60 °C and leaching time 40 min. Then optimum conditions were applied to get maximum recovery for aluminum sulfate and compared to commercial coagulant on raw water of El-Shiekh Zayd (WTP).

Flow injection spectrofluorimetric determination of iron in industrial effluents based on fluorescence quenching of 1-naphthol-2- sulfonate.

A sensitive and selective spectrofluorimetric method has been developed for flow injection analysis (FIA) of iron(III) based on its fluorescence quenching effect on the water soluble 1-naphthol-2-sulfonate. The fluorescence emission spectra were collected with excitation at 283 nm. The emission peaks of the neutral and anionic forms of 1-naphthol-2-sulfonate as well as the band area were found to decrease linearly with iron(III) concentrations over the range 0.1-18 µg ml(-1) and a detection limit of 3.4 ng ml(-1) (emission at 349 nm) with FIA. Possible interferences from different cations and anions, which could affect the analytical response, are evaluated and showed the high selectivity of the method. The effect of solution pH and 1-naphthol-2-sulfonate concentration were examined and the reaction conditions are optimized. The method is successfully applied to determine iron(III) in industrial effluents from different sources without any complications with recoveries of almost 100% with both manual and flow injection methods. Results were found to be very consistent with those obtained using atomic absorption spectrometry.

Classification of in-flight catering wastes in Egypt air flights and its potential as energy source (chemical approach).

Waste to energy conversion is based on the classification of waste. In-flight catering wastes resulting from Egypt Airlines economy class passengers were classified. The solid waste stream generated contains plastic, paper, left-over waste food and aluminum. The type of meal served varies according to the period of flight and so the quantity and content of the waste stream. It was found that the waste generation rate varied from 61.3 to 265 g according to the meal type. Breakfast snack meal generates the highest weight of waste which recorded an average of 265 g. Plastic waste generated varied from 39.6% to 64.6% by weight for the various types of meals served. A total amount of 725 tons were generated annually from organic waste (paper, plastic and food waste) among which a non combustible 39.4 tons of aluminum. The calorific value for each generated item is calculated and the total energy potential reached up to 14.3 TJ annually.