In vitro mapping of 1H ultrashort T2* and T2 of porcine menisci.

In this study, mapping of ultrashort T2 and T2* of acutely isolated porcine menisci at B0 = 9.4 T was investigated. Maps of T2 were measured from a slice through the pars intermedia with a spin echo-prepared two-dimensional ultrashort-TE T2 mapping technique published previously. T2* mapping was performed by two-dimensional ultrashort-TE MRI with variable acquisition delay. The measured signal decays were fitted by monoexponential, biexponential and Gaussian-exponential fitting functions. The occurrence of Gaussian-like signal decays is outlined theoretically. The quality of the curve fits was visualized by mapping the value δ = abs(1 - χ(2) red). For T2 mapping, the Gaussian-exponential fit showed the best performance, whereas the monoexponential and biexponential fits showed regionally high values of δ (δ > 20). Interpretation of the Gaussian-exponential parameter maps was found to be difficult, because a Gaussian signal component can be related to mesoscopic (collagen texture) or macroscopic (slice profile, shim, sample geometry) magnetic field inhomogeneities and/or residual (1) H dipole-dipole couplings. It seems likely that an interplay of these effects yielded the observed signal decays. Modulation of the T2* signal decay caused by chemical shift was observed and addressed to fat protons by means of histology. In the T2 measurements, no modulation of the signal decay was observed and the biexponential and Gaussian-exponential fits showed the best performance with comparable values of δ. Our results suggest that T2 mapping provides the more robust method for the characterization of meniscal tissue by means of MRI relaxometry. However, mapping of ultrashort T2, as performed in this study, is time consuming and provides less signal-to-noise ratio per time than the mapping of T2*. If T2* mapping is used, pixel-wise monitoring of the fitting quality based on reduced χ(2) should be employed and great care should be taken when interpreting the parameter maps of the fits.

[Tribological assessment of articular cartilage. A system for the analysis of the friction coefficient of cartilage, regenerates and tissue engineering constructs; initial results]. / Tribologische Messungen am Gelenkknorpel. Ein Prüfstand zur Messung der Reibungszahlen von Knorpel gegen Knorpel, Regeneraten und TE-Konstrukten und erste Ergebnisse.

Values for the friction coefficient of articular cartilage are given in ranges of percentage and lower and are calculated as a quotient of the friction force and the perpendicular loading force acting on it. Thus, a sophisticated system has to be provided for analysing the friction coefficient under different conditions in particular when cartilage should be coupled as friction partner. It is possible to deep-freeze articular cartilage before measuring the friction coefficient as the procedure has no influence on the results. The presented tribological system was able to distinguish between altered and native cartilage. Furthermore, tissue engineered constructs for cartilage repair were differentiated from native cartilage probes by their friction coefficient. In conclusion a tribological equipment is presented to analyze the friction coefficient of articular cartilage, in vivo generated cartilage regenerates and in vitro tissue engineered constructs regarding their biomechanical properties for quality assessment.