Large buccal bifurcation cyst in a child: a case report and literature review.

BACKGROUND: WHO defines the mandibular buccal bifurcation cyst as a cyst occurring near the cervical margin of the lateral aspect of a root as a consequence of inflammatory process in a periodontal pocket. The pathogenesis of these cysts is still debated, but they are most likely originated from reduced enamel epithelium or from inflammatory proliferation of epithelial cell rests of Malassez that come from the superficial mucosa of a tooth in eruption. The aim of this article was to describe a case of large buccal bifurcation cyst of a permanent mandibular first molar. CASE REPORT: A 6-year-old boy was referred to Department of Oral Riabilitation of the Istituto Stomatologico Italiano, University of Milan, Italy, with the complaint of hard swelling over the buccal gingiva and a deep probing depth located on the buccal aspect. Radiograph revealed a well-defined semilunar-shaped radiolucency, marked by a fine radiopaque line on the buccal aspect of the partially-erupted lower right first molar and it was large enough to include a small part of the crown of the second right molar. As reported in the literature the treatment of choice is enucleation and curettage of the lesion without extraction of the vital involved tooth. This procedure has shown excellent results in both the short- and long-term. The definitive diagnosis of paradental cysts can be assessed by histopathologic analysis.

Digital device in postextraction implantology: a clinical case presentation.

Aim. The aim of this work is to describe a case of immediate implant placement after extraction of the upper right first premolar, with the use of CAD/CAM technology, which allows an early digital impression of the implant site with an intraoral scanner (MHT 3D Progress, Verona, Italy). Case Report. A 46-year-old female was referred with a disorder caused by continuous debonding of the prosthetic crown on the upper right first premolar. Clinically, there were no signs, and the evaluation of the periapical radiograph showed a fracture of the root, with a mesial well-defined lesion of the hard tissue of the upper right first premolar, as the radiolucent area affected the root surface of the tooth. It was decided, in accordance with the patient, that the tooth would be extracted and the implant (Primer, Edierre implant system, Genoa, Italy) with diameter of 4.2 mm and length of 13 mm would be inserted. After the insertion of the implant, it was screwed to the scan abutment, and a scan was taken using an intraoral scanner (MHT 3D Progress, Verona, Italy). The scanned images were processed with CAD/CAM software (Exocad DentalCAD, Darmstadt, Germany) and the temporary crown was digitally drawn (Dental Knowledge, Milan, Italy) and then sent to the milling machine for production with a composite monoblock. After 4 months, when the implant was osteointegrated, it was not necessary to take another dental impression, and the definitive crown could be screwed in. Conclusion. The CAD/CAM technology is especially helpful in postextraction implant for aesthetic rehabilitation, as it is possible to immediately fix a provisional crown with an anatomic shape that allows an optimal healing process of the tissues. Moreover, the removal of healing abutments, and the use of impression copings, impression materials, and dental stone became unnecessary, enabling the reduction of the chair time, component cost, and patient's discomfort. However, it is still necessary for scientific research to continue to carry out studies on this procedure, in order to improve the accuracy, the reliability, and the reproducibility of the results.