Simulation study of the Gilbert damping in Ni80Fe20/Nd bilayers: comparison with experiments.

We present an experimental and computational investigation the Neodymium thickness dependence of the effective damping constant (αeff) inNi80Fe20/Neodymium (Py/Nd) bilayers. The computational results show that the magnetic damping is strongly dependent on the thickness of Nd, which is in agreement with experimental data. Self consistent solutions of the spin accumulation model and the local magnetisation were used in the simulations. It was not possible to obtain agreement with experiment under the assumption of an enhanced damping in a single Py monolayer. Instead, it was found that the enhanced damping due to spin pumping needed to be spread across two monolayers of Py. This is suggested to arise from interface mixing. Subsequently, the temperature dependence of the effective damping was investigated. It is found that, with increasing temperature, the influence of thermally-induced spin fluctuations on magnetic damping becomes stronger with increasing Nd thickness.

Simulations of magnetization reversal in FM/AFM bilayers with THz frequency pulses.

It is widely known that antiferromagnets (AFMs) display a high frequency response in the terahertz (THz) range, which opens up the possibility for ultrafast control of their magnetization for next generation data storage and processing applications. However, because the magnetization of the different sublattices cancel, their state is notoriously difficult to read. One way to overcome this is to couple AFMs to ferromagnets-whose state is trivially read via magneto-resistance sensors. Here we present conditions, using theoretical modelling, that it is possible to switch the magnetization of an AFM/FM bilayer using THz frequency pulses with moderate field amplitude and short durations, achievable in experiments. Consistent switching is observed in the phase diagrams for an order of magnitude increase in the interface coupling and a tripling in the thickness of the FM layer. We demonstrate a range of reversal paths that arise due to the combination of precession in the materials and the THz-induced fields. Our analysis demonstrates that the AFM drives the switching and results in a much higher frequency dynamics in the FM due to the exchange coupling at the interface. The switching is shown to be robust over a broad range of temperatures relevant for device applications.

Non-equilibrium heating path for the laser-induced nucleation of metastable skyrmion lattices.

Understanding formation of metastable phases by rapid energy pumping and quenching has been intriguing scientists for a long time. This issue is crucial for technologically relevant systems such as magnetic skyrmions which are frequently metastable at zero field. Using Atomistic Spin Dynamics simulations, we show the possibility of creating metastable skyrmion lattices in cobalt-based trilayers by femtosecond laser heating. Similar to the formation of supercooled ice droplets in the gas phase, high temperature ultrafast excitation creates magnon drops and their fast relaxation leads to acquisition and quenching of the skyrmion topological protection. The interplay between different processes corresponds to a specific excitation window which can be additionally controlled by external fields. The results are contrasted with longer-scale heating leading to a phase transition to the stable states. Our results provide insight into the dynamics of the highly non-equilibrium pathway for spin excitations and pave additional routes for skyrmion-based information technologies.

Exploiting Unique Alignment of Cobalt Ferrite Nanoparticles, Mild Hyperthermia, and Controlled Intrinsic Cobalt Toxicity for Cancer Therapy.

Nanoparticle-based magnetic hyperthermia is a well-known thermal therapy platform studied to treat solid tumors, but its use for monotherapy is limited due to incomplete tumor eradication at hyperthermia temperature (45 °C). It is often combined with chemotherapy for obtaining a more effective therapeutic outcome. Cubic-shaped cobalt ferrite nanoparticles (Co-Fe NCs) serve as magnetic hyperthermia agents and as a cytotoxic agent due to the known cobalt ion toxicity, allowing the achievement of both heat and cytotoxic effects from a single platform. In addition to this advantage, Co-Fe NCs have the unique ability to form growing chains under an alternating magnetic field (AMF). This unique chain formation, along with the mild hyperthermia and intrinsic cobalt toxicity, leads to complete tumor regression and improved overall survival in an in vivo murine xenograft model, all under clinically approved AMF conditions. Numerical calculations identify magnetic anisotropy as the main Co-Fe NCs' feature to generate such chain formations. This novel combination therapy can improve the effects of magnetic hyperthermia, inaugurating investigation of mechanical behaviors of nanoparticles under AMF, as a new avenue for cancer therapy.

The Intracellular Number of Magnetic Nanoparticles Modulates the Apoptotic Death Pathway after Magnetic Hyperthermia Treatment.

Magnetic hyperthermia is a cancer treatment based on the exposure of magnetic nanoparticles to an alternating magnetic field in order to generate local heat. In this work, 3D cell culture models were prepared to observe the effect that a different number of internalized particles had on the mechanisms of cell death triggered upon the magnetic hyperthermia treatment. Macrophages were selected by their high capacity to uptake nanoparticles. Intracellular nanoparticle concentrations up to 7.5 pg Fe/cell were measured both by elemental analysis and magnetic characterization techniques. Cell viability after the magnetic hyperthermia treatment was decreased to <25% for intracellular iron contents above 1 pg per cell. Theoretical calculations of the intracellular thermal effects that occurred during the alternating magnetic field application indicated a very low increase in the global cell temperature. Different apoptotic routes were triggered depending on the number of internalized particles. At low intracellular magnetic nanoparticle amounts (below 1 pg Fe/cell), the intrinsic route was the main mechanism to induce apoptosis, as observed by the high Bax/Bcl-2 mRNA ratio and low caspase-8 activity. In contrast, at higher concentrations of internalized magnetic nanoparticles (1-7.5 pg Fe/cell), the extrinsic route was observed through the increased activity of caspase-8. Nevertheless, both mechanisms may coexist at intermediate iron concentrations. Knowledge on the different mechanisms of cell death triggered after the magnetic hyperthermia treatment is fundamental to understand the biological events activated by this procedure and their role in its effectiveness.

Unveiling the Dynamical Assembly of Magnetic Nanocrystal Zig-Zag Chains via In Situ TEM Imaging in Liquid.

The controlled assembly of colloidal magnetic nanocrystals is key to many applications such as nanoelectronics, storage memory devices, and nanomedicine. Here, the motion and ordering of ferrimagnetic nanocubes in water via liquid-cell transmission electron microscopy is directly imaged in situ. Through the experimental analysis, combined with molecular dynamics simulations and theoretical considerations, it is shown that the presence of highly competitive interactions leads to the formation of stable monomers and dimers, acting as nuclei, followed by a dynamic growth of zig-zag chain-like assemblies. It is demonstrated that such arrays can be explained by first, a maximization of short-range electrostatic interactions, which at a later stage become surpassed by magnetic forces acting through the easy magnetic axes of the nanocubes, causing their tilted orientation within the arrays. Moreover, in the confined volume of liquid in the experiments, interactions of the nanocube surfaces with the cell membranes, when irradiated at relatively low electron dose, slow down the kinetics of their self-assembly, facilitating the identification of different stages in the process. The study provides crucial insights for the formation of unconventional linear arrays made of ferrimagnetic nanocubes that are essential for their further exploitation in, for example, magnetic hyperthermia, magneto-transport devices, and nanotheranostic tools.

Magnetic Interaction of Multifunctional Core-Shell Nanoparticles for Highly Effective Theranostics.

The controlled size and surface treatment of magnetic nanoparticles (NPs) make one-stage combination feasible for enhanced magnetic resonance imaging (MRI) contrast and effective hyperthermia. However, superparamagnetic behavior, essential for avoiding the aggregation of magnetic NPs, substantially limits their performance. Here, a superparamagnetic core-shell structure is developed, which promotes the formation of vortex-like intraparticle magnetization structures in the remanent state, leading to reduced dipolar interactions between two neighboring NPs, while during an MRI scan, the presence of a DC magnetic field induces the formation of NP chains, introducing increased local inhomogeneous dipole fields that enhance relaxivity. The core-shell NPs also reveal an augmented anisotropy, due to exchange coupling to the high anisotropy core, which enhances the specific absorption rate. This in vivo tumor study reveals that the tumor cells can be clearly diagnosed during an MRI scan and the tumor size is substantially reduced through hyperthermia therapy by using the same FePt@iron oxide nanoparticles, realizing the concept of theranostics.

First order reversal curves and intrinsic parameter determination for magnetic materials; limitations of hysteron-based approaches in correlated systems.

The generic problem of extracting information on intrinsic particle properties from the whole class of interacting magnetic fine particle systems is a long standing and difficult inverse problem. As an example, the Switching Field Distribution (SFD) is an important quantity in the characterization of magnetic systems, and its determination in many technological applications, such as recording media, is especially challenging. Techniques such as the first order reversal curve (FORC) methods, were developed to extract the SFD from macroscopic measurements. However, all methods rely on separating the contributions to the measurements of the intrinsic SFD and the extrinsic effects of magnetostatic and exchange interactions. We investigate the underlying physics of the FORC method by applying it to the output predictions of a kinetic Monte-Carlo model with known input parameters. We show that the FORC method is valid only in cases of weak spatial correlation of the magnetisation and suggest a more general approach.