Cell response analysis in SARS-CoV-2 infected bronchial organoids.

The development of an in vitro cell model that can be used to study severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) research is expected. Here we conducted infection experiments in bronchial organoids (BO) and an BO-derived air-liquid interface model (BO-ALI) using 8 SARS-CoV-2 variants. The infection efficiency in BO-ALI was more than 1,000 times higher than that in BO. Among the bronchial epithelial cells, we found that ciliated cells were infected with the virus, but basal cells were not. Ciliated cells died 7 days after the viral infection, but basal cells survived after the viral infection and differentiated into ciliated cells. Fibroblast growth factor 10 signaling was essential for this differentiation. These results indicate that BO and BO-ALI may be used not only to evaluate the cell response to SARS-CoV-2 and coronavirus disease 2019 (COVID-19) therapeutic agents, but also for airway regeneration studies.

Dual inhibition of TMPRSS2 and Cathepsin Bprevents SARS-CoV-2 infection in iPS cells.

It has been reported that many receptors and proteases are required for severe acute respiratory syndrome coronavirus-2 (SARS-CoV-2) infection. Although angiotensin-converting enzyme 2 (ACE2) is the most important of these receptors, little is known about the contribution of other genes. In this study, we examined the roles of neuropilin-1, basigin, transmembrane serine proteases (TMPRSSs), and cathepsins (CTSs) in SARS-CoV-2 infection using the CRISPR interference system and ACE2-expressing human induced pluripotent stem (iPS) cells. Double knockdown of TMPRSS2 and cathepsin B (CTSB) reduced the viral load to 0.036% ± 0.021%. Consistently, the combination of the CTPB inhibitor CA-074 methyl ester and the TMPRSS2 inhibitor camostat reduced the viral load to 0.0078% ± 0.0057%. This result was confirmed using four SARS-CoV-2 variants (B.1.3, B.1.1.7, B.1.351, and B.1.1.248). The simultaneous use of these two drugs reduced viral load to less than 0.01% in both female and male iPS cells. These findings suggest that compounds targeting TMPRSS2 and CTSB exhibit highly efficient antiviral effects independent of gender and SARS-CoV-2 variant.

Generation of Tetrafluoroethylene-Propylene Elastomer-Based Microfluidic Devices for Drug Toxicity and Metabolism Studies.

Polydimethylsiloxane (PDMS) is widely used to fabricate microfluidic organs-on-chips. Using these devices (PDMS-based devices), the mechanical microenvironment of living tissues, such as pulmonary respiration and intestinal peristalsis, can be reproduced in vitro. However, the use of PDMS-based devices in drug discovery research is limited because of their extensive absorption of drugs. In this study, we investigated the feasibility of the tetrafluoroethylene-propylene (FEPM) elastomer to fabricate a hepatocyte-on-a-chip (FEPM-based hepatocyte chip) with lower drug absorption. The FEPM-based hepatocyte chip expressed drug-metabolizing enzymes, drug-conjugating enzymes, and drug transporters. Also, it could produce human albumin. Although the metabolites of midazolam and bufuralol were hardly detected in the PDMS-based hepatocyte chip, they were detected abundantly in the FEPM-based hepatocyte chip. Finally, coumarin-induced hepatocyte cytotoxicity was less severe in the PDMS-based hepatocyte chip than in the FEPM-based hepatocyte chip, reflecting the different drug absorptions of the two chips. In conclusion, the FEPM-based hepatocyte chip could be a useful tool in drug discovery research, including drug metabolism and toxicity studies.

Usability of Polydimethylsiloxane-Based Microfluidic Devices in Pharmaceutical Research Using Human Hepatocytes.

A liver-on-a-chip (liver-chip) is a microfluidic device carrying liver cells such as human hepatocytes. It is used to reproduce a part of liver function. Many microfluidic devices are composed of polydimethylsiloxane (PDMS), which is a type of silicone elastomer. PDMS is easy to process and suitable for cell observation, but its high hydrophobicity carries the risk of drug absorption. In this study, we evaluated drug absorption to the PDMS device and investigated the drug responsiveness of human hepatocytes cultured in the PDMS device (hepatocyte-chips). First, the absorption rates of 12 compounds to the PDMS device were measured. The absorption rates of midazolam, bufuralol, cyclosporine A, and verapamil were 92.9, 71.7, 71.4, and 99.6%, respectively, but the other compounds were poorly absorbed. Importantly, the absorption rate of the compounds was correlated with their octanol/water distribution coefficient (log D) values (R2 = 0.76). Next, hepatocyte-chips were used to examine the response to drugs, which are typically used to evaluate hepatic functions. Using the hepatocyte-chips, we could confirm the responsiveness of drugs including cytochrome P450 (CYP) inducers and farnesoid X receptor (FXR) ligands. We believe that our findings will contribute to drug discovery research using PDMS-based liver-chips.

Modeling SARS-CoV-2 infection and its individual differences with ACE2-expressing human iPS cells.

Genetic differences are a primary reason for differences in the susceptibility and severity of COVID-19. As induced pluripotent stem (iPS) cells maintain the genetic information of the donor, they can be used to model individual differences in SARS-CoV-2 infection in vitro. We found that human iPS cells expressing the SARS-CoV-2 receptor angiotensin-converting enzyme 2 (ACE2) (ACE2-iPS cells) can be infected w SARS-CoV-2. In infected ACE2-iPS cells, the expression of SARS-CoV-2 nucleocapsid protein, budding of viral particles, and production of progeny virus, double membrane spherules, and double-membrane vesicles were confirmed. We performed SARS-CoV-2 infection experiments on ACE2-iPS/ embryonic stem (ES) cells from eight individuals. Male iPS/ES cells were more capable of producing the virus compared with female iPS/ES cells. These findings suggest that ACE2-iPS cells can not only reproduce individual differences in SARS-CoV-2 infection in vitro but also are a useful resource to clarify the causes of individual differences in COVID-19 due to genetic differences.

Biomimetic aorta-gonad-Mesonephros-on-a-Chip to study human developmental hematopoiesis.

A fundamental limitation in the derivation of hematopoietic stem and progenitor cells is the imprecise understanding of human developmental hematopoiesis. Herein we established a multilayer microfluidic Aorta-Gonad-Mesonephros (AGM)-on-a-chip to emulate developmental hematopoiesis from pluripotent stem cells. The device consists of two layers of microchannels separated by a semipermeable membrane, which allows the co-culture of human hemogenic endothelial (HE) cells and stromal cells in a physiological relevant spatial arrangement to replicate the structure of the AGM. HE cells derived from human induced pluripotent stem cells (hiPSCs) were cultured on a layer of mesenchymal stromal cells in the top channel while vascular endothelial cells were co-cultured on the bottom side of the membrane within the microfluidic device. We show that this AGM-on-a-chip efficiently derives endothelial-to-hematopoietic transition (EHT) from hiPSCs compared with regular suspension culture. The presence of mesenchymal stroma and endothelial cells renders functional HPCs in vitro. We propose that the AGM-on-a-chip could serve as a platform to dissect the cellular and molecular mechanisms of human developmental hematopoiesis.

Tetrafluoroethylene-Propylene Elastomer for Fabrication of Microfluidic Organs-on-Chips Resistant to Drug Absorption.

Organs-on-chips are microfluidic devices typically fabricated from polydimethylsiloxane (PDMS). Since PDMS has many attractive properties including high optical clarity and compliance, PDMS is very useful for cell culture applications; however, PDMS possesses a significant drawback in that small hydrophobic molecules are strongly absorbed. This drawback hinders widespread use of PDMS-based devices for drug discovery and development. Here, we describe a microfluidic cell culture system made of a tetrafluoroethylene-propylene (FEPM) elastomer. We demonstrated that FEPM does not absorb small hydrophobic compounds including rhodamine B and three types of drugs, nifedipine, coumarin, and Bay K8644, whereas PDMS absorbs them strongly. The device consists of two FEPM layers of microchannels separated by a thin collagen vitrigel membrane. Since FEPM is flexible and biocompatible, this microfluidic device can be used to culture cells while applying mechanical strain. When human umbilical vein endothelial cells (HUVECs) were subjected to cyclic strain (~10%) for 4 h in this device, HUVECs reoriented and aligned perpendicularly in response to the cyclic stretch. Moreover, we demonstrated that this device can be used to replicate the epithelial-endothelial interface as well as to provide physiological mechanical strain and fluid flow. This method offers a robust platform to produce organs-on-chips for drug discovery and development.

Engineering of vascularized 3D cell constructs to model cellular interactions through a vascular network.

Current in vitro 3D culture models lack a vascular system to transport oxygen and nutrients, as well as cells, which is essential to maintain cellular viability and functions. Here, we describe a microfluidic method to generate a perfusable vascular network that can form inside 3D multicellular spheroids and functionally connect to microchannels. Multicellular spheroids containing endothelial cells and lung fibroblasts were embedded within a hydrogel inside a microchannel, and then, endothelial cells were seeded into both sides of the hydrogel so that angiogenic sprouts from the cell spheroids and the microchannels were anastomosed to form a 3D vascular network. Solution containing cells and reagents can be perfused inside the cell spheroids through the vascular network by injecting it into a microchannel. This method can be used to study cancer cell migration towards 3D co-culture spheroids through a vascular network. We recapitulated a bone-like microenvironment by culturing multicellular spheroids containing osteo-differentiated mesenchymal stem cells (MSCs), as well as endothelial cells, and fibroblasts in the device. After the formation of vascularized spheroids, breast cancer cells were injected into a microchannel connected to a vascular network and cultured for 7 days on-chip to monitor cellular migration. We demonstrated that migration rates of the breast cancer cells towards multicellular spheroids via blood vessels were significantly higher in the bone-like microenvironment compared with the microenvironment formed by undifferentiated MSCs. These findings demonstrate the potential value of the 3D vascularized spheroids-on-a-chip for modeling in vivo-like cellular microenvironments, drug delivery through blood vessels, and cellular interactions through a vascular network.

Strand breakage of a (6-4) photoproduct-containing DNA at neutral pH and its repair by the ERCC1-XPF protein complex.

The (6-4) photoproduct is one of the major UV-induced lesions in DNA. We previously showed that hydrolytic ring opening of the 5' base and subsequent hydrolysis of the glycosidic bond of the 3' component occurred when this photoproduct was treated with aqueous NaOH. In this study, we found that another product was obtained when the (6-4) photoproduct was heated at 90 °C for 6 h, in a 0.1 M solution of N,N'-dimethyl-1,2-ethanediamine adjusted to pH 7.4 with acetic acid. An analysis of the chemical structure of this product revealed that the 5' base was intact, whereas the glycosidic bond at the 3' component was hydrolyzed in the same manner. The strand break was detected for a 30-mer oligonucleotide containing the (6-4) photoproduct upon treatment with the above solution or other pH 7.4 solutions containing biogenic amines, such as spermidine and spermine. In the case of spermidine, the rate constant was calculated to be 1.4 × 10(-8) s(-1) at 37 °C. The strand break occurred even when the oligonucleotide was heated at 90 °C in 0.1 M sodium phosphate (pH 7.0), although this treatment produced several types of 5' fragments. The Dewar valence isomer was inert to this reaction. The product obtained from the (6-4) photoproduct-containing 30-mer was used to investigate the enzymatic processing of the 3' end bearing the damaged base and a phosphate. The ERCC1-XPF complex removed several nucleotides containing the damaged base, in the presence of replication protein A.