RESUMO
Two-photon polymerization has been employed to fabricate three-dimensional structures using the biodegradable triblock copolymer poly(epsilon-caprolactone-co-trimethylenecarbonate)-b-poly(ethylene glycol)-b-poly(epsilon-caprolactone-co-trimethylenecarbonate) with 4,4'-bis(diethylamino)benzophenone as the photoinitiator. The fabricated structures were of good quality and had four micron resolution. Initial cytotoxicity tests show that the material does not affect cell proliferation. These studies demonstrate the potential of two-photon polymerization as a technology for the fabrication of biodegradable scaffolds for tissue engineering.
Assuntos
Materiais Biocompatíveis/química , Polímeros/química , Animais , Biodegradação Ambiental , Proliferação de Células , Desenho de Equipamento , Luz , Camundongos , Camundongos Endogâmicos BALB C , Modelos Químicos , Células NIH 3T3 , Fotoquímica/métodos , Fótons , Propriedades de Superfície , Engenharia Tecidual/métodosRESUMO
An investigation of the shrinking behaviour of a zirconium-based sol-gel composite micro-structured by two-photon polymerization is presented and a simple, straightforward methodology allowing the evaluation of shrinkage is suggested. It is shown that volume reduction is directly related to the average laser power (irradiation dose) used for the microfabrication and becomes a critical issue near the polymerization threshold. It is demonstrated that this shrinkage can be employed beneficially to improve the structural resolution. This is demonstrated by the presence of stopbands in the photonic crystal nanostructures fabricated with controlled volume reduction. Well above the polymerization threshold, the studied material exhibits remarkably low shrinkage. Therefore, no additional effort for the pre-compensation of distortion and for the improvement of structural stability is required.