Interchangeable Biomass Fuels for Paper-Based Microfluidic Fuel Cells: Finding Their Power Density Limits.

Paper batteries are self-pumping emerging tools for powering portable analytical systems. These disposable energy converters must be low-cost and must achieve enough energy to power electronic devices. The challenge is reaching high energy while keeping the low cost. Here, for the first time, we report a paper-based microfluidic fuel cell (PµFC) equipped with Pt/C on a carbon paper (CP) anode and a metal-free CP cathode fed by biomass-derived fuels to deliver high power. The cells were engineered in a mixed-media configuration, where methanol, ethanol, ethylene glycol, or glycerol is electro-oxidized in an alkaline medium, while Na2S2O8 is reduced in an acidic medium. This strategy allows for optimizing each half-cell reaction independently. The colaminar channel of the cellulose paper was chemically investigated by mapping the composition, which reveals a majority of elements from the catholyte and anolyte on each respective side and a mixture of both at the interface, assuring the existing colaminar system. Moreover, the colaminar flow was studied by investigating the flow rate by considering recorded videos for the first time. All PµFCs show 150-200 s to build a stable colaminar flow, which matches the time to reach a stable open circuit voltage. The flow rate is similar for different concentrations of methanol and ethanol, but it decreases with the increase in ethylene glycol and glycerol concentrations, suggesting a longer residence time for the reactants. The cells perform differently for the different concentrations, and their limiting power densities are composed of a balance among anode poisoning, residence time, and viscosity of the liquids. The sustainable PµFCs can be interchangeably fed by the four biomass-derived fuels to deliver ∼2.2-3.9 mW cm-2. This allows choosing the proper fuel due to their availability. The unprecedented PµFC fed by ethylene glycol delivered 6.76 mW cm-2, which is the benchmark output power for a paper battery fed by alcohol.

New Approach to Dehydration of Xylose to 2-Furfuraldehyde Using a Mesoporous Niobium-Based Catalyst.

Furfural chemistry is one of the most promising platforms directly derived from lignocellulose biomass. In this study, a niobium-based catalyst (mNb-bc) was synthesized by a new fast and simple method. This new method uses microemulsion to obtain a catalyst with a high specific surface area (340 m2 g-1), defined mesoporosity, and high acidity (65 µmol g-1). Scanning electron microscopy revealed that mNb-bc has a rough surface. The mNb-bc was used to catalyze the conversion reaction of xylose into 2-furfuraldehyde in a monophasic system using water as a green solvent. This reaction was investigated using a 23 experimental design by varying the temperature, time, and catalyst-to-xylose ratio (CXR). The responses evaluated were xylose conversion (X c), reaction yield (Y), and selectivity to 2-furfuraldehyde (S). The optimized reaction conditions were used to evaluate the reaction kinetics. At milder reaction conditions of 140 °C, 2 h, and a CXR of 10%, mNb-bc led to an X c value of 41.2%, an S value of 77.1%, and a Y value of 31.8%.

Bismuth Vanadate Photoelectrodes with High Photovoltage as Photoanode and Photocathode in Photoelectrochemical Cells for Water Splitting.

Using dual-photoelectrode photoelectrochemical (PEC) devices based on earth-abundant metal oxides for unbiased water splitting is an attractive means of producing green H2 fuel, but is challenging, owing to low photovoltages generated by PEC cells. This problem can be solved by coupling n-type BiVO4 with n-type Bi4 V2 O11 to create a virtual p/n junction due to the formation of a hole-inversion layer at the semiconductor interface. Thus, photoelectrodes with high photovoltage outputs were synthesized. The photoelectrodes exhibited features of p- and n-type semiconductors when illuminated under an applied bias, suggesting their use as photoanode and photocathode in a dual-photoelectrode PEC cell. This concept was proved by connecting a 1 mol % W-doped BiVO4 /Bi4 V2 O11 photoanode with an undoped BiVO4 /Bi4 V2 O11 photocathode, which produced a high photovoltage of 1.54 V, sufficient to drive stand-alone water splitting with 0.95 % efficiency.

Soybean peroxidase immobilized on δ-FeOOH as new magnetically recyclable biocatalyst for removal of ferulic acid.

A significant enhancement in the catalytic performance due to enzymes immobilization is a great way to enhance the economics of biocatalytic processes. The soybean peroxidase (SP) immobilization under ferroxyte and the ferulic acid removal by the enzyme free and immobilized were investigated. The immobilization via silica-coated ferroxyte nanoparticles was effective, and immobilization yield of 39%. The scanning electron microscopy (SEM) images showed significant changes in the materials morphology. Substantial differences were observed in the particles' Fourier Transform Infrared (FTIR) spectra. The magnetic catalyst revealed a better performance than the free enzyme in the ferulic acid conversion, presenting a good V max/K m ratio when compared with the free enzyme. The reuse evaluated by ten cycles exhibited excellent recycling, remaining constant between the sixth and seventh cycles. The use of magnetic nanocatalyst becomes possible to eliminate the high operational costs, and complicated steps of the conventional enzymatic processes. Thus, a viable industrial route for the use of the enzyme as catalyst is possible.

A hole inversion layer at the BiVO4/Bi4V2O11 interface produces a high tunable photovoltage for water splitting.

The conversion of solar energy into hydrogen fuel by splitting water into photoelectrochemical cells (PEC) is an appealing strategy to store energy and minimize the extensive use of fossil fuels. The key requirement for efficient water splitting is producing a large band bending (photovoltage) at the semiconductor to improve the separation of the photogenerated charge carriers. Therefore, an attractive method consists in creating internal electrical fields inside the PEC to render more favorable band bending for water splitting. Coupling ferroelectric materials exhibiting spontaneous polarization with visible light photoactive semiconductors can be a likely approach to getting higher photovoltage outputs. The spontaneous electric polarization tends to promote the desirable separation of photogenerated electron- hole pairs and can produce photovoltages higher than that obtained from a conventional p-n heterojunction. Herein, we demonstrate that a hole inversion layer induced by a ferroelectric Bi4V2O11 perovskite at the n-type BiVO4 interface creates a virtual p-n junction with high photovoltage, which is suitable for water splitting. The photovoltage output can be boosted by changing the polarization by doping the ferroelectric material with tungsten in order to produce the relatively large photovoltage of 1.39 V, decreasing the surface recombination and enhancing the photocurrent as much as 180%.

Isolation of endophytic actinomycetes from roots and leaves of maize (Zea mays L.)

Actinomycetes were isolated from surface sterilized leaves and roots of maize. A total of 53 isolates were obtained, 31 of them from leaves and 22 from roots. The genus Microbispora was the most frequently found followed by the genera Streptomyces and Streptosporangium. From the isolated actinomycetes, 43.4 percent showed antimicrobial activity against one or more tested bacteria and yeast.

Microrganismos endofíticos são frequentemente encontrados no interior de plantas cultivadas. Embora vários tipos de microrganismos endofíticos tenham sido isolados de milho (Zea mays) não existiam dados sobre certos grupos de actinomicetos obtidos a partir desta espécie de planta cultivada. No presente trabalho, actinomicetos endofíticos foram isolados de folhas e raízes de milho. Um total de 53 isolados foram obtidos sendo 31 deles a partir de folhas e 22 a partir de raízes. O gênero Microbispora foi o mais frequente (62 por cento), seguido dos gêneros Streptomyces e Streptosporangium. Dos actinomicetos isolados, 43,4 por cento apresentaram atividade antimicrobiana contra um ou mais microrganismos ensaiado.