Nor-LAAM loaded PLGA Microparticles for Treating Opioid Use Disorder.

The treatment landscape for opioid use disorder (OUD) faces challenges stemming from the limited efficacy of existing medications, poor adherence to prescribed regimens, and a heightened risk of fatal overdose post-treatment cessation. Therefore, there is a pressing need for innovative therapeutic strategies that enhance the effectiveness of interventions and the overall well-being of individuals with OUD. This study explored the therapeutic potential of nor-Levo-α-acetylmethadol (nor-LAAM) to treat OUD. We developed sustained release nor-LAAM-loaded poly (lactic-co-glycolic acid) (PLGA) microparticles (MP) using a hydrophobic ion pairing (HIP) approach. The nor-LAAM-MP prepared using HIP with pamoic acid had high drug loading and exhibited minimal initial burst release and sustained release. The nor-LAAM-MP was further optimized for desirable particle size, drug loading, and release kinetics. The lead nor-LAAM-MP (F4) had a relatively high drug loading (11 wt.%) and an average diameter (19 µm) and maintained a sustained drug release for 4 weeks. A single subcutaneous injection of nor-LAAM-MP (F4) provided detectable nor-LAAM levels in rabbit plasma for at least 15 days. We further evaluated the therapeutic efficacy of nor-LAAM-MP (F4) in a well-established fentanyl-addiction rat model, and revealed a marked reduction in fentanyl choice and withdrawal symptoms in fentanyl-dependent rats. These findings provide insights into further developing long-acting nor-LAAM-MP for treating OUD. It has the potential to offer a new effective medication to the existing sparse armamentarium of products available to treat OUD.

Development of uniform fenofibrate-loaded biodegradable microparticle by membrane emulsification.

Fenofibrate has shown therapeutic effects on diabetic retinopathy. However, fenofibrate can be rapidly cleared from the eye after a single intravitreal injection. Here, we aim to develop fenofibrate loaded PLGA microparticles (Feno-MP) with high drug loading and sustained in vitro release up to 6 months suitable for intravitreal injection. First, orthogonal array experimental design was applied for formulation optimization. The selected formulation parameters were used to formulate Feno-MP using homogenization method and direct membrane emulsification method. Both methods generated Feno-MP with high drug loading and sustained in vitro drug release more than 140 days. Unlike the polydisperse Feno-MP prepared using homogenization method, membrane emulsification method generated Feno-MP with uniform size distribution. By controlling the membrane pore size, 1.5 µm, 8 µm and 16 µm Feno-MP were formulated and we found that larger Feno-MP demonstrated higher drug loading, more sustained drug release in vitro with less burst drug release than the smaller Feno-MP. In conclusion, we developed Feno-MP with high drug loading and sustained release profile, and elucidated that changing the particle size could have notable impacts on drug loading and release kinetics. Formulating Feno-MP with uniform size distribution by membrane emulsification method would benefit the batch-to-batch repeatability.

New Air-Jet Dry Powder Insufflator for High-Efficiency Aerosol Delivery to Rats.

Pulmonary deposition of lung-targeted therapeutic aerosols can achieve direct drug delivery to the site of action, thereby enhancing the efficacy and reducing systemic exposure. In this study, we investigated the in vitro and in vivo aerosol performance of the novel small animal air-jet dry powder insufflator (Rat AJ DPI) using spray-dried albuterol excipient-enhanced-growth (EEG) powder as a model formulation. The in vitro aerosolization performance of the optimized albuterol EEG powder was first assessed using the Rat AJ DPI. The performance of Rat AJ DPI to deliver albuterol EEG aerosol to rat lungs was then compared to that of the Penn-Century Insufflator. Albuterol EEG powders dispersed using the Rat AJ DPI demonstrated narrow unimodal aerosol size distribution profiles, which were independent of the loaded powder dose (1, 2, and 5 mg). In addition, the span value for Rat AJ DPI (5 mg powder mass) was 1.32, which was 4.2-fold lower than that for Penn-Century insufflator (5 mg powder mass). At a higher loaded mass of 5 mg, the Rat AJ DPI delivered significantly larger doses to rat lungs compared with the Penn-Century DPI. The Rat AJ DPI with hand actuation delivered approximately 85% of the total emitted dose (2 and 5 mg loadings), which was comparatively higher than that for Penn-Century DPI (approximately 75%). In addition, percentage deposition in each of the lung lobes for the Rat AJ DPI was observed to be independent of the administration dose (2 and 5 mg loadings) with coefficients of variation below 12%, except in the right middle lobe. Automatic actuation of a 5 mg powder mass using the Rat AJ DPI demonstrated a similar delivered dose compared to manual actuation of the same dose, with 82% of the total emitted dose reaching the lung lobes. High-efficiency delivery of the aerosol to the lobar lung region and low sensitivity of the interlobar delivery efficiency to the loaded dose highlight the suitability of the new air-jet DPI for administering therapeutic pharmaceutical aerosols to small test animals.

Six-month effective treatment of corneal graft rejection.

Topical corticosteroid eye drop is the mainstay for preventing and treating corneal graft rejection. While the frequent topical corticosteroid use is associated with risk of intraocular pressure (IOP) elevation and poor patient compliance that leads to graft failure and the requirement for a repeated, high-risk corneal transplantation. Here, we developed dexamethasone sodium phosphate (DSP)-loaded dicarboxyl-terminated poly(lactic acid) nanoparticle (PLA DSP-NP) formulations with relatively high drug loading (8 to 10 weight %) and 6 months of sustained intraocular DSP delivery in rats with a single dosing. PLA DSP-NP successfully reversed early signs of corneal rejection, leading to rat corneal graft survival for at least 6 months. Efficacious PLA DSP-NP doses did not affect IOP and showed no signs of ocular toxicity in rats for up to 6 months. Subconjunctival injection of DSP-NP is a promising approach for safely preventing and treating corneal graft rejection with the potential for improved patient adherence.