Construction of Two-Component Chemically Reactive Supramolecular Assemblies-Acyl Migration Reactions in Cocrystals of Napthalene-2,3-Diol and Its Diesters.

Reactions in solids are of contemporary interest due to applications in pharmaceutical industries to environmental sustainability. Although several reactive crystals that support chemical reactions have been identified and characterized, the same cannot be said about reactive cocrystals. Earlier we correlated the facile acyl group transfer reactions in crystals with supramolecular parameters obtained from the crystal structures. The structure-reactivity correlation revealed the requirement of proper juxtaposition of electrophile (C=O) and the nucleophile (OH) with distance (∼3.2 Å) and angle (∼90°) along the chain structure. The current article describes the preparation of cocrystals that are capable of supporting intermolecular acyl group transfer reactions in a group of structurally similar molecules. The cocrystals of naphthalene 2,3-diol and its corresponding diesters showed a facile solid state acyl transfer reaction, which has been well correlated with their crystal structures.

Lithium hydride as an efficient reagent for the preparation of 1,2-anhydro inositols: Does the reaction proceed through 'axial rich' conformation?

scyllo-Inositol derived 1,2-trans-diequatorial halohydrins can be efficiently converted to the corresponding epoxides in the presence of lithium hydride. The structure of one of the epoxides was determined by single crystal X-ray diffraction analysis. This provides a potential route for the preparation of ring modified inositol derivatives. DFT calculations suggest that this epoxide formation could be proceeding through the intermediacy of the cyclohexane ring-inverted axial-rich conformer (1,2-trans-diaxial halohydrin). This is supported by the results of DFT calculations on the formation of inositol orthoformate, where the product is locked in the axial-rich conformation, while the starting inositol has the equatorial-rich conformation.

Effect of Crystal Packing on the Thermosalient Effect of the Pincer-Type Diester Naphthalene-2,3-diyl-bis(4-fluorobenzoate): A New Class†II Thermosalient Solid.

The pincer-like double ester naphthalene-2,3-diyl-bis(4-fluorobenzoate) (2) is pentamorphic. Upon heating crystals of form I to below their melting point (441-443 K), they undergo a phase transition accompanied by a thermosalient effect, that is, rare and visually striking motility whereby the crystals jump or disintegrate. The phase transition and the thermosalient effect are reversible. Analysis of the crystal structure revealed that form I is a class II thermosalient solid. Crystals of form III also underwent a reversible phase transition in the temperature range of 160 to 170 K; however, they were not thermosalient. Comparison of the structures and the mechanical responses of the two polymorphs revealed that the thermosalient effect of form I was due to reversible closing and opening of the arms of the diester molecules in a tweezer-like action.

Engineering crystals that facilitate the acyl-transfer reaction: insight from a comparison of the crystal structures of myo-inositol-1,3,5-orthoformate-derived benzoates and carbonates.

Minor variations in the molecular structure of constituent molecules of reactive crystals often yield crystals with significantly different properties due to altered modes of molecular association in the solid state. Hence, these studies could provide a better understanding of the complex chemical processes occurring in the crystalline state. However, reactions that proceed efficiently in molecular crystals are only a small fraction of the reactions that are known to proceed (with comparable efficiency) in the solution state. Hence, for consistent progress in this area of research, investigation of newer reactive molecular crystals which support different kinds of reactions and their related systems is essential. The crystal structures and acyl-transfer reactivity of a myo-inositol-1,3,5-orthoformate-derived dibenzoate and its carbonate (4-O-benzoyl-2-O-phenoxycarbonyl-myo-inositol 1,3,5-orthoformate, C21H18O9) and thiocarbonate (4-O-benzoyl-2-O-phenoxythiocarbonyl-myo-inositol 1,3,5-orthoformate, C21H18O8S) analogs are compared with the aim of understanding the relationship between crystal structure and acyl-transfer reactivity. Insertion of an O atom in the acyl (or thioacyl) group of an ester gives the corresponding carbonate (or thiocarbonate). This seemingly minor change in molecular structure results in a considerable change in the packing of the molecules in the crystals of myo-inositol-1,3,5-orthoformate-derived benzoates and the corresponding carbonates. These differences result in a lack of intermolecular acyl-transfer reactivity in crystals of myo-inositol-1,3,5-orthoformate-derived carbonates. Hence, this study illustrates the sensitivity of the relative orientation of molecules, their packing and ensuing changes in the reactivity of resulting crystals to minor changes in molecular structure.

Intramolecular Cyclization of Carbonate and Thiocarbonate Derivatives of myo-Inositol in the Solid State: Implications for Acyl Group Transfer Reactions in Molecular Crystals.

Racemic 4-O-phenoxycarbonyl and 4-O-phenoxythiocarbonyl derivatives of myo-inositol orthoformate undergo thermal intramolecular cyclization in the solid state to yield the corresponding 4,6-bridged carbonates and thiocarbonates, respectively. The thermal cyclization also occurs in the solution and molten states, but less efficiently, suggesting that these cyclization reactions are aided by molecular pre-organization, although not strictly topochemically controlled. Crystal structures of two carbonates and a thiocarbonate clearly revealed that the relative orientation of the electrophile and the nucleophile in the crystal lattice facilitates the intramolecular cyclization reaction and forbids the intermolecular reaction. The correlation observed between the chemical reactivity and the non-covalent interactions in the crystal of the reactants provides a way to estimate the chemical stability of analogous molecules in the solid state.

Correlation of the solid-state reactivities of racemic 2,4(6)-di-O-benzoyl-myo-inositol 1,3,5-orthoformate and its 4,4'-bipyridine cocrystal with their crystal structures.

Racemic 2,4(6)-di-O-benzoyl-myo-inositol 1,3,5-orthoformate, C21H18O8, (1), shows a very efficient intermolecular benzoyl-group migration reaction in its crystals. However, the presence of 4,4'-bipyridine molecules in its cocrystal, C21H18O8·C10H8N2, (1)·BP, inhibits the intermolecular benzoyl-group transfer reaction. In (1), molecules are assembled around the crystallographic twofold screw axis (b axis) to form a helical self-assembly through conventional O-H···O hydrogen-bonding interactions. This helical association places the reactive C6-O-benzoyl group (electrophile, El) and the C4-hydroxy group (nucleophile, Nu) in proximity, with a preorganized El···Nu geometry favourable for the acyl transfer reaction. In the cocrystal (1)·BP, the dibenzoate and bipyridine molecules are arranged alternately through O-H···N interactions. The presence of the bipyridine molecules perturbs the regular helical assembly of the dibenzoate molecules and thus restricts the solid-state reactivity. Hence, unlike the parent dibenzoate crystals, the cocrystals do not exhibit benzoyl-transfer reactions. This approach is useful for increasing the stability of small molecules in the crystalline state and could find application in the design of functional solids.

Identification of molecular crystals capable of undergoing an acyl-transfer reaction based on intermolecular interactions in the crystal lattice.

Investigation of the intermolecular acyl-transfer reactivity in molecular crystals of myo-inositol orthoester derivatives and its correlation with crystal structures enabled us to identify the essential parameters to support efficient acyl-transfer reactions in crystals: 1) the favorable geometry of the nucleophile (-OH) and the electrophile (C-O) and 2) the molecular assembly, reinforced by C-H⋅⋅⋅π interactions, which supports a domino-type reaction in crystals. These parameters were used to identify another reactive crystal through a data-mining study of the Cambridge Structural Database. A 2:1 co-crystal of 2,3-naphthalene diol and its di-p-methylbenzoate was selected as a potentially reactive crystal and its reactivity was tested by heating the co-crystals in the presence of solid sodium carbonate. A facile intermolecular p-toluoyl group transfer was observed as predicted. The successful identification of reactive crystals opens up a new method for the detection of molecular crystals capable of exhibiting acyl-transfer reactivity.