Cu(II)-Mediated direct 18F-dehydrofluorination of phosphine oxides in high molar activity.

BACKGROUND: The 18F/19F-isotope exchange method employing P(V)-centered prosthetic groups demonstrates advantages in addressing mild one-step aqueous 18F-labeling of peptides and proteins. However, the molar activity (Am) achieved through isotope exchange remains relatively low, unless employing a high initial activity of [18F]F-. To overcome this drawback, our work introduces a novel approach through a Cu-mediated direct 18F-dehydrofluorination of phosphine oxides. This method leverages the straightforward separation of the 18F-labeled product from the phosphine oxide precursors, aiming to primarily increase Am. RESULTS: Through a 19F-dehydrofluorination efficiency test, Cu(OAc)2 was identified as the optimal oxidative metal salt, exhibiting a remarkable 100% conversion within one hour. Leveraging the straightforward separation of phosphine oxide precursors and phosphinic fluoride products, the Am of an activated ester, [18F]4, sees an impressive nearly 15-fold increase compared to the 18F/19F-isotope exchange, with the same initial activity of [18F]F-. Furthermore, this Cu(II)-mediated 18F-dehydrofluorination approach demonstrates tolerance up to 20% solvent water content, which enables the practical radiosynthesis of 18F-labeled water-soluble molecules under non-drying conditions. CONCLUSIONS: The direct 18F-dehydrofluorination of phosphine oxide prosthetic groups has been successfully accomplished, achieving a high Am via Cu(II)-mediated oxidative addition and reductive elimination.

Surfactants Accelerate Isotope Exchange-Based 18F-Fluorination in Water.

Radiochemical yields (RCYs) of isotope exchange-based 18F-fluorination of non-carbon-centered substrates in water are rationally enhanced by adding surfactants, which increases both the rate constant k and local reactant concentrations. Among 12 surfactants, the cationic surfactant cetrimonium bromide (CTAB) and two nonionic surfactants (Tween 20 and Tween 80) were selected for their superior catalytic effects, namely, electrostatic effects or solubilization effects. For a model substrate, bis(4-methoxyphenyl)phosphinic fluoride, the 18F-fluorination rate constant (k) increased up to 7-fold, while its saturation concentration rose up to 15-fold due to micelle formation, encapsulating 70-94% of the substrate. With 30.0 mmol/L CTAB, the required 18F-labeling temperature of a typical organofluorosilicon prosthesis ([18F]SiFA) decreased from 95 °C to room temperature, achieving an RCY of 22%. For an E[c(RGDyK)]2-derived peptide tracer with an organofluorophosphine prosthesis, the RCY in water at 90 °C achieved 25%, correspondingly increasing the molar activity (Am). After high-performance liquid chromatography (HPLC) or solid-phase purification, the residual selected surfactant concentrations in the tracer injections were well below the FDA DII (Inactive Ingredient Database) limits or the LD50 in mice.

18 F-Labeling Chemistry in Aqueous Media.

18 F-Labeled molecular tracers and subsequent positron emission tomography are indispensable molecular imaging tools in medical diagnosis and research. The preparation of 18 F-labeled molecular tracers involves critical steps such as the 18 F-labeling reaction, work-up, and 18 F-product purification, which are governed by 18 F-labeling chemistry. Since direct incorporation of 18 F in aqueous media exhibits many advantages in practice, this Review summarizes the existing 18 F-labeling methods in aqueous media, which are sorted by atoms forming chemical covalent bonds with F. The Review is focused on the respective reaction mechanism, the water effect and the applications of these methods for the development of 18 F-radiopharmaceuticals. The research progress on aqueous nucleophilic labeling methods using [18 F]F- as the 18 F source has been mainly discussed.