RESUMO
The solubility of oxygen in aqueous solutions of sodium perfluoroheptanoate (NaPFHept) at different concentrations was measured at 310.15 K with an apparatus based on the saturation method. The effect of adding beta-cyclodextrin (betaCD) on the solubility of oxygen was also studied. Conductimetry measurements showed that the presence of betaCD in aqueous solutions of NaPFHept increases its critical micellar concentration (CMC). In the presence of betaCD (15 mM), the characteristic minimum of oxygen solubility observed at the CMC is shifted from 83 to 114 mM, and the curvature at the minimum is reduced to 64% of the value in the absence of betaCD. Chemical shift changes for the H5 protons of betaCD, recorded as functions of the initial concentration of NaPFHept, point to the formation of a relatively strong 1:1 inclusion in betaCD of the perfluoroheptanoate anion. Hence, it is suggest that the effect of adding betaCD on the solubility of oxygen cannot be accounted for only by the perfluoroheptanoate anion inclusion in betaCD, but has to be ascribed to the direct influence of this inclusion complex on disrupting the aggregation process reducing the increase of oxygen solubility after the CMC value.
RESUMO
Samples of drug/hydroxypropylmethylcellulose (HPMC) mixtures and matrices (drug/HPMC mixtures plus excipients) were allowed to equilibrate in closed chambers with defined relative humidities (RHs). Their water uptake and drug release were evaluated by differential scanning calorimetry/thermogravimetric analysis and dissolution studies, respectively. Analysis of the thermal behaviors of the drug/HPMC mixtures and of the polymer alone, as functions of RH, leads to the conclusion that most of the hydration water is retained by the polymer, and points to the occurrence of different types of hydration water, from the strongly polymer-bound water molecules at RH values up to 81%, to the almost "free water" for RH values close to 100%. In addition, application of the Korsmeyer model to the dissolution results leads to the conclusion that the rate determining dissolution processes are predominantly of the fickian type.