Strength of small-bites abdominal wall closure using different suturing methods and materials in an experimental animal model.

PURPOSE: Using small instead of large bites for laparotomy closure results in lower incidence of incisional hernia, but no consensus exists on which suture material to use. This study aimed to compare five different closure strategies in a standardized experimental setting. METHODS: Fifty porcine abdominal walls were arranged into 5 groups: (A) running 2/0 polydioxanone; (B) interlocking 2/0 polydioxanone; (C) running size 0 barbed polydioxanone; (D) running size 0 barbed glycolic acid and trimethylene carbonate; (E) running size 0 suturable polypropylene mesh. The small-bites technique was used for linea alba closure in all. The abdominal walls were divided into a supra- and infra-umbilical half, resulting in 20 specimens per group that were pulled apart in a tensile testing machine. Maximum tensile force and types of suture failure were registered. RESULTS: The highest tensile force was measured when using barbed polydioxanone (334.8 N ± 157.0), but differences did not reach statistical significance. Infra-umbilical abdominal walls endured a significantly higher maximum tensile force compared to supra-umbilical (397 N vs 271 N, p < 0.001). Barbed glycolic acid and trimethylene carbonate failed significantly more often (25% vs 0%, p = 0.008). CONCLUSION: Based on tensile force, both interlocking and running suture techniques using polydioxanone, and running sutures using barbed polydioxanone or suturable mesh, seem to be suitable for abdominal wall closure. Tensile strength was significantly higher in infra-umbilical abdominal walls compared to supra-umbilical. Barbed glycolic acid and trimethylene carbonate should probably be discouraged for fascial closure, because of increased risk of suture failure.

Treatment of recurrent inguinal hernia after TransInguinal PrePeritoneal (TIPP) surgery: feasibility and outcomes in a case series.

BACKGROUND: TransInguinal PrePeritoneal (TIPP) inguinal hernia repair (IHR) combines an open anterior approach with a preperitoneal position of the mesh. Advantages include reduced chronic postoperative inguinal pain, low recurrence rates and quick recovery. Critics have expressed concerns that recurrent IHR after TIPP could be difficult and with an increased risk of complications due to the formation of scar tissue in both the anterior and posterior anatomical inguinal planes. This study reports feasibility and outcomes of recurrent IHR after TIPP repair. METHODS: Patients who underwent recurrent IHR after TIPP between January 2013 and January 2015 in a single hernia-dedicated teaching hospital were included. Exclusion criteria were femoral hernia, incarcerated hernia and reasons for unreliable follow-up. Electronic medical records were assessed retrospectively to register surgical outcomes and complications. RESULTS: Thirty-three patients underwent surgical repair of recurrent inguinal hernia after TIPP. Twenty patients were treated with a "re-TIPP when possible" strategy; resulting in 13 successful re-TIPPs and 7 conversions to Lichtenstein repair. Eleven patients underwent a primary Lichtenstein's repair, the remaining two patients underwent recurrent IHR using other techniques (TransREctus sheath PrePeritoneal and TransAbdominal PrePeritoneal repair). Mean time of surgery was 44.7 min (standard deviation 16.7). There was one patient (3.0%) with a re-recurrent inguinal hernia during follow-up. Other minor complications included urinary tract infection. CONCLUSION: These results indicate that after TIPP it is feasible and safe to perform re-surgery for recurrent inguinal hernia with an anterior approach again. For these recurrences, a Lichtenstein repair can be performed, or a "re-TIPP if possible" strategy can be applied by experienced TIPP surgeons, tailored to the intraoperative findings. Whether a re-TIPP has advantages over Lichtenstein should be evaluated in a prospective manner.

Treatment of dorsally dislocated distal radius fractures with individualized 3D printed bracing: an exploratory study.

BACKGROUND: The aim of this work was to develop a three-dimensionally (3D) printed brace for the acute treatment of dorsally dislocated and correctly reduced distal radius fractures (DRF). The hypothesis was that a brace shaped to the mirror image of the contralateral (non-fractured) wrist will have an optimal anatomical fit, resulting in improved comfort and lower rates of secondary fracture displacement. METHOD: Validation: the circumference of both wrists and comfort of the brace were studied in healthy volunteers and effectiveness of the brace was evaluated in an ex vivo fracture model. Clinical study: the brace was tested for comfort and effectiveness in patients with a well reduced unstable DRF. RESULTS: Validation: the circumference of both wrists may be different, the brace retained the reduction in the ex vivo fracture model and was well tolerated in the volunteers. Clinical study: in DRF patients comfort scores were lower and pain scores higher compared to the healthy volunteers. After 3 and 5 weeks all patients were independent in ADL according to the Katz-index. Posttraumatic swelling subsided in the first week. In two of the five patients secondary fracture dislocation occurred. CONCLUSIONS: Treatment of a dislocated DRF in the acute setting (day one) with a custom-made 3D printed brace, anatomically modelled from a 3D scan of the contralateral wrist, is possible. Difference between both wrists and posttraumatic swelling must be adapted for. The high rate of secondary fracture displacement led to early discontinuation of the study and a small sample size. TRIAL REGISTRATION: Name of the registry: ClinicalTrials.Gov Trial registration number: NCT03848702 Date of registration: 02/21/2019, retrospectively registered.

Use of the Humeral Head as a Reference Point to Prevent Axillary Nerve Damage during Proximal Fixation of Humeral Fractures: An Anatomical and Radiographic Study.

INTRODUCTION: Treatment of proximal humeral fractures with plate osteosynthesis or intramedullary nail fixation in humeral shaft fractures with a proximal locking bolt carries the risk of iatrogenic injury of the axillary nerve. The purpose of this anatomical study is to define a more reliable safe zone to prevent iatrogenic axillary nerve injury using the humeral head instead of the acromion as a (radiographic) reference point during operative treatment. MATERIALS AND METHODS: Anatomical dissection and labeling of the axillary nerve and branches was performed on 10 specially embalmed human specimens. Standard AP and straight lateral radiographs were made. The distances were measured indirectly from the cranial tip of the humerus to the axillary nerve on radiographs. RESULTS: The median distance from the cranial tip of the humerus to the axillary nerve was 52 mm. The mean number of axillary nerve branches was 3. The distances from the cranial tip of the humerus to the nerve (branch) varied from 23 to 78 mm. The median distance from the proximal (anterior) branch was 36 mm, to the second branch 47 mm, 54 mm to the third branch and 73 mm to the fourth branch. The axillary nerve moves along with the humerus in cranial and caudal direction when the subacromial space varies. CONCLUSION: This study shows that the position of the axillary nerve can be better determent using the cranial tip of the humerus as a reference point instead of the acromion. Furthermore, it is unsafe to place the proximal locking bolts in the zone between 24 mm and 78 mm from the cranial tip of the humerus. The greatest chance to cause a lesion of the main branch of the axillary nerve is in the zone between 48 mm and 58 mm caudal from the tip of the humeral head. HOW TO CITE THIS ARTICLE: Theeuwes HP, Potters JW, Bessems JHJM, et al. Use of the Humeral Head as a Reference Point to Prevent Axillary Nerve Damage during Proximal Fixation of Humeral Fractures: An Anatomical and Radiographic Study. Strategies Trauma Limb Reconstr 2020;15(2):63-68.

The course of the radial nerve in the distal humerus: A novel, anatomy based, radiographic assessment.

METHODS AND FINDINGS: Measurements were done on both arms of ten specially embalmed specimens. Arms were dissected and radiopaque wires attached to the radial nerve in the distal part of the upper arm. Digital radiographs were obtained to determine the course of the radial nerve in the distal 20 cm of the humerus in relation to bony landmarks; medial epicondyle and capitellum-trochlea projection (CCT). Analysis was done with ImageJ and Microsoft Excel software. We also compared humeral nail specifications from different companies with the course of the radial nerve to predict possible radial nerve damage. RESULTS: The distance from the medial epicondyle to point where the radial nerve bends from posterior to lateral was 142 mm on AP radiographs and 152 mm measured on the lateral radiographs. The average distance from the medial epicondyle to point where the radial nerve bends from lateral to anterior on AP radiographs was 66 mm. On the lateral radiographs where the nerve moves away from the anterior cortex 83 mm to the center of capitellum and trochlea (CCT). The distance from the bifurcation of the radial nerve into the posterior interosseous nerve (PIN) and superficial radial nerve was 21 mm on AP radiographs and 42 mm on the lateral radiographs (CCT). CONCLUSIONS: The course of the radial nerve in the distal part of the upper arm has great variety. Lateral fixation is relatively safe in a zone between the center of capitellum-trochlea and 48 mm proximal to this point. The danger zone in lateral fixation is in-between 48-122 mm proximal from CCT. In anteroposterior direction; distal fixation is dangerous between 21-101 mm measured from the medial epicondyle. The more distal, the more medial the nerve courses making it more valuable to iatrogenic damage. The IMN we compared with our data all show potential risk in case of (blind) distal locking, especially from lateral to medial direction.

Membrane properties and firing patterns of inferior colliculus neurons: an in vivo patch-clamp study in rodents.

The inferior colliculus (IC) is a large auditory nucleus in the midbrain, which is a nearly obligatory relay center for ascending auditory projections. We made in vivo whole cell patch-clamp recordings of IC cells in young-adult anesthetized C57/Bl6 mice and Wistar rats to characterize their membrane properties and spontaneous inputs. We observed spikelets in both rat (18%) and mouse (13%) IC neurons, suggesting that IC neurons may be connected by electrical synapses. In many cells, spontaneous postsynaptic potentials were sufficiently large to contribute to spike irregularity. Cells differed considerably in the number of simultaneous spontaneous postsynaptic potentials that would be needed to trigger an action potential. Depolarizing and hyperpolarizing current injections showed six different types of firing patterns: buildup, accelerating, burst-onset, burst-sustained, sustained, and accommodating. Their relative frequencies were similar in both species. In mice, about half of the cells showed a clear depolarizing sag, suggesting that they have the hyperpolarization-activated current I(h). This sag was observed more often in burst and in accommodating cells than in buildup, accelerating, or sustained neurons. Cells with I(h) had a significantly more depolarized resting membrane potential. They were more likely to fire rebound spikes and generally showed long-lasting afterhyperpolarizations following long depolarizations. We therefore suggest a separate functional role for I(h).