The effect of noise and dust exposure on oxidative stress among livestock and poultry feed industry workers.

INTRODUCTION: Simultaneous exposure to noise and dust may have detrimental health effects. This study was conducted to determine the effect of exposure to noise and dust on oxidative stress. METHODS: In this cross-sectional study, 82 employees of two livestock and poultry feed factories in Golestan Province, Iran, were selected as the exposed group and 82 office workers were selected as the control group. Occupational noise and dust exposure were measured using a dosimeter, sampling pump, and vinyl chloride filter. Oxidative stress was determined by measuring the levels of malondialdehyde (MDA) and superoxide dismutase (SOD) in blood samples. T-tests, one-way analysis of variance, and multivariate linear regression were used to analyze the data. RESULTS: The levels of MDA and SOD in the exposed group were significantly higher and lower than the control group (p < 0.001), respectively. The results showed the subgroup with both over the threshold dust and noise exposure had the highest MDA levels. The SOD level among those exposed to noise more than the recommended level, in the subgroup with more dust exposure, was significantly less than the subgroup with low noise exposure (p = 0.017). CONCLUSION: Noise and dust exposure probably increase the level of oxidative stress by increasing the level of lipid peroxidation (MDA) and reducing the level of antioxidant enzymes (SOD).

A study on using fireclay as a biomass carrier in an activated sludge system.

By adding a biomass carrier to an activated sludge system, the biomass concentration will increase, and subsequently the organic removal efficiency will be enhanced. In this study, the possibility of using excess sludge from ceramic and tile manufacturing plants as a biomass carrier was investigated. The aim of this study was to determine the effect of using fireclay as a biomass carrier on biomass concentration, organic removal and nitrification efficiency in an activated sludge system. Experiments were conducted by using a bench scale activated sludge system operating in batch and continuous modes. Artificial simulated wastewater was made by using recirculated water in a ceramic manufacturing plant. In the continuous mode, hydraulic detention time in the aeration reactor was 8 and 22 h. In the batch mode, aeration time was 8 and 16 h. Fireclay doses were 500, 1,400 and 2,250 mg l(-1), and were added to the reactors in each experiment separately. The reactor with added fireclay was called a Hybrid Biological Reactor (HBR). A reactor without added fireclay was used as a control. Efficiency parameters such as COD, MLVSS and nitrate were measured in the control and HBR reactors according to standard methods. The average concentration of biomass in the HBR reactor was greater than in the control reactor. The total biomass concentration in the HBR reactor (2.25 g l(-1) fireclay) in the continuous mode was 3,000 mg l(-1) and in the batch mode was 2,400 mg l(-1). The attached biomass concentration in the HBR reactor (2.25 g l(-1) fireclay) in the continuous mode was 1,500 mg l(-1) and in the batch mode was 980 mg l(-1). Efficiency for COD removal in the HBR and control reactor was 95 and 55%, respectively. In the HBR reactor, nitrification was enhanced, and the concentration of nitrate was increased by 80%. By increasing the fireclay dose, total and attached biomass was increased. By adding fireclay as a biomass carrier, the efficiency of an activated sludge system to treat wastewater from ceramic manufacturing plants was increased.